i6800 SINGLE QUICK REFERENCE GUIDE
SEASTAR ELECTRONIC SHIFT & THROTTLE QUICK REFERENCE GUIDE
Neutral Throttle Warmup
(NTW):
NTW allows throttle control without gear engagement.
A slow flashing green N (Neutral) lamp indicates that
NTW is engaged for this engine.
To engage NTW:
• Move the lever to the Neutral position. Green lamp
goes steady.
• Press the N button. The N lamp flashes green to
indicate that NTW is engaged.
To disengage NTW:
• Return the lever to the Neutral position.
• Press the N button. The lamp will light steady
green. NTW is disengaged and the engine and
transmission will respond normally
to lever commands. trolling mode (TM):
Provides greater throttle sensitivity: moving the control
lever to full forward will only produce a percentage of
wide open throttle. The default TM throttle limit is 50%
in Forward, and 100% in Reverse.
A very slow flashing green N lamp (one second on,
two seconds off) indicates that trolling mode is
engaged.
To engage TM:
• Move the control lever to the forward idle or
reverse idle position.
• Press the N button. The lamp will flash green
slowly – TM is engaged.
To disengage TM:
• Move the control lever to forward idle or reverse
idle position.
• Press the N button. The flashing green lamp will
go out – TM is disengaged.
There are two types of faults – DANGER & WARNING
danger fault
Fast flashing of both lights indicates a critical fault which
will result in limited or no system performance. Call for
assistance, use an alternate controlling device, or use
manual override in an emergency.
warning fault
NOTE: The flashing green N (Neutral) lamp
indicates the status of NTW or TM. Please
exercise caution when engaging/disengaging
these modes! A steady-on Neutral lamp ALWAYS
indicates engine is in neutral.
A fast flashing amber light indicates a non-critical fault
which may cause the boat speed to be reduced. The
system will continue to operate. Manual Override: In case of emergency,
a manual override is available on the shift
and throttle actuators. A label on the actuator
describes the override procedure.
over
For more detailed alarm information see User's Manual.
3831 No. 6 Road, Richmond,
B.C. Canada V6V 1P6
tech support: 604.248.3858
web: www.seastarsolutions.com
SEASTAR ELECTRONIC SHIFT & THROTTLE QUICK REFERENCE GUIDE
ENGINE TRIM CONTROL:
in the handle (optional)
LEVER POSITION INDICATOR
ADJUSTABLE LEVER FEEL
SELECT/CHANGE STATION:
Note: Station Select Protection may be on.
See the Operator's Manual.
A lit amber SELECT lamp indicates a station is active.
• On single station boats, station selection is
automatic.
• For multi-station boats, choose a station and then
press SEL button with the lever in neutral.
To change stations:
• Move to new station and press SEL button.
(Amber lamp flashes)
• Match control lever position with that of active
station. (Amber lamp goes steady when levers
match and this station is now in control.)
Shift
Detent
Throttle
Friction
INDICATOR DIMMING FEATURE:
PLEASE KEEP ON BOAT
When the control head is active, pressing SEL repeatedly
will cycle through five available indicator brightness levels.
over
©2014 Marine Canada Acquisition Inc. PID# 710092A 09/14
3831 No. 6 Road, Richmond,
B.C. Canada V6V 1P6
tech support: 604.248.3858
web: www.seastarsolutions.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement