user`s manual
user’s
manual
Portable
Battery Pack
model #: PB3001
Portable Battery Pack For Mobile Devices
What’s Included
Unpack the battery pack and make sure all accessories are put
aside so they will not be lost.
hello.
USB to Micro USB Cable
Thank you for purchasing the
AT&T Portable Battery Pack [PB3001].
Portable Battery Pack
Features
· Rechargeable 3000 mAh Li-ion Polymer Battery
· Micro USB port to charge the Portable Battery Pack
· Integrated Micro USB charging cable
· USB Port to charge most mobile devices
· Power Indicator – 4 LEDs power display
· Compact Design
Page 2
Portable Battery Pack
Page 3
Contents
Safety Information
Introduction
2
What’s Included
3
Safety Information
5
Getting Started
Location of Main Unit Controls
6
Operational Instructions
Charging Your PB3001 Portable Battery Pack
LED Power Indicator Lights
Charging Your Mobile Device
7
7
8
Troubleshooting
8
Compliance with FCC Regulations
9
Warranty Information
10
Specifications
11
Page 4
Important Safety Instructions
Please read all safety and operating instructions carefully before
installation and use, and keep these instructions handy for future
reference. Take special note of all warnings listed in this user’s
manual and on the PB3001.
1. ATTACHMENTS - Do not use attachments not recommended
by the manufacturer.
2. WATER AND MOISTURE - The unit should not be used near
water. For example: near a bathtub, washbowl, kitchen sink,
laundry tub, swimming pool or in a wet basement.
3. VENTILATION - The unit should be situated so that its location
or position does not interfere with its proper ventilation. For
example, it should not be situated on a bed, sofa, rug or similar
surface that may block ventilation openings. Also, it should
not be placed in a built-in installation, such as a bookcase
or cabinet, which may impede the flow of air through the
ventilation openings.
4. OBJECTS AND LIQUID ENTRY - Care should be taken so that
external objects do not fall into and liquids are not spilled onto
any openings or vents located on the product.
5. POWER SOURCE - The unit should be connected to a power
supply only of the type described in the operating instructions
or as marked on the unit. If you are not sure please consult the
dealer or local power company.
6. HEAT - The unit should be situated away from heat sources
such as radiators, heat registers, stoves or other appliances
(including amplifiers) that produce heat.
7. SERVICING - The user should not attempt to service the
unit beyond those methods described in the user’s manual.
Opening or removing covers will expose you to dangerous
voltage and other hazards. Service methods not covered in the
user’s manual should be referred to qualified service personnel.
Page 5
Getting Started
Operational Instructions
Location of Main Unit Controls
Charging Your PB3001 Portable Battery Pack
-- Using the included USB to micro-USB cable, plug the microUSB connector into the micro-USB input jack on your PB3001,
and the USB connector into any USB charging port.
-- Upon initial use, or after a prolonged storage period, the
PB3001 should be fully charged in approximately 4 hours.
-- The LED Power Indicator lights will light up to show you the
charging progress.
3
1
2
USB Wall Charger
Plug not included
5
LED Power Indicator Lights
When your PB3001 is not in use, you can check the battery level
by pressing the Power On/Off button. This button will activate the
LED Power Indicator lights and the lights will shut off automatically
after a few seconds.
4
1.
2.
3.
4.
5.
Power On/Off
LED indicators
Micro USB charging input
Integrated Micro USB output charging cable
USB output charging port
LED Power Indicator Chart
100%
80%
Light
Indicator
60%
40%
20%
Empty
Page 6
Page 7
Operational Instructions
Compliance with FCC Regulations
Charging Your Mobile Device
The equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate Radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to Radio
communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to Radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
-- The PB3001 has a charging output level of 5V – 0.5A for the
integrated Micro USB charging cable and 5V – 1A for the USB
output to charge your mobile devices.
Depending on your mobile device’s charging port:
-- Micro USB Charging Port – plug the integrated Micro USB
charging cable into the mobile device’s Micro USB charging
port.
-- Other Mobile Device Charging Port - plug the USB connector
of your charging cable into the USB output port on the PB3001,
and then the corresponding connector into your mobile
device.
-- Press the On/Off button on the PB3001 and your device will
automatically begin charging and the LED Power Indicators on
the PB3001 will light up.
Troubleshooting
Symptom
Possible cause
No power
Verify that there is power left in the
battery.
Recharge as needed.
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced Radio/television
technician for assistance.
THE SPECIFICATION AND EXTERNAL APPEARANCE OF THE
BATTERY PACK ARE SUBJECT TO CHANGE WITHOUT PRIOR
NOTICE.
If at any time in the future you should need
to dispose of this product, please note
that waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist. Check
with your local authority or retailer for
recycling advice.
Page 8
Page 9
Warranty Information
Warranty Information
Limited Warranty
Concept 101 LLC does not warrant that the unit will work properly in all environmental conditions,
and makes no warranty and representation, either implied or expressed, with respect to the quality,
performance, merchantability, or fitness for a particular purpose other than the purpose identified
within this user’s manual. Concept 101 LLC has made every effort to ensure that this user’s manual is
accurate, and disclaims liability for any inaccuracies or omissions that may have occurred. Information
in this user’s manual is subject to change without notice and does not represent a commitment on
the part of Concept 101 LLC. Concept 101 LLC reserves the right to make improvements to this user’s
manual and/or to the products described in this user’s manual, at any time without notice. If you find
information in this manual that is incorrect, misleading, or incomplete, please contact us through our
website.
The AT&T brands are used under license. Any repair, replacement, or warranty
service, and all questions about this product should be directed to Concept 101 LLC at
www.att.com/electronics or call 1 (888) 920-8680 from the USA or Canada. Concept
101 LLC warrants to the original purchaser that the product will be free from defects
in material, parts and workmanship for the period designated for this product. The
warranty commences the day the product is purchased and covers up to a period
of one (1) year (90 day Labor and 1 year Parts). Concept 101 LLC agrees that it will, at
its option, replace the defective product with either a new or remanufactured unit
equivalent to your original purchase during the warranty period. Should the Parts
warranty period exceed the Labor warranty period, Concept 101 LLC will supply
at no charge for the remainder of the Parts warranty, any new or remanufactured
replacement parts as required by the product. During this period all labor and service
charges will become the responsibility of the customer. Exclusions: This warranty does not apply to the appearance or exterior of the product
which may have been damaged or defaced, altered or modified in design
or construction. This warranty does not apply if the serial number is
altered or removed, or if there is any damage due to power line surge,
user damage to the AC power cord, connection to improper voltage
source, general misuse, accidents, or repair attempts by unauthorized
service agents. Other exclusions include ear pads, rechargeable and
non-rechargeable batteries.
REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE
EXCLUSIVE REMEDY OF THE CUSTOMER; CONCEPT 101 LLC SHALL NOT BE
LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH
OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT, EXCEPT TO
THE EXTENT PROHIBITED BY APPLICABLE LAW. ANY IMPLIED WARRANTY OF
MERCHANTABILITY OF FITNESS FOR A PARTICULAR PURPOSE ON THIS PRODUCT
IS LIMITED TO THE DURATION OF THE WARRANTY.
Some states do not allow the exclusion or limitations of incidental or consequential
damages, or limitations on how long the warranty lasts. In these cases the above
exclusions or limitations may not apply to you. This warranty gives you specific legal
rights and you may also have other rights which vary from state to state.
Specifications
------
Battery Type: Li-ion Polymer
Input: DC5.0V-1A
Dual Output: DC5.0V-1.5A(max)
Capacity: 3000 mAh
Size: 110 x 55 x 14mm
purchase date:
place of purchase:
Obtaining Service: To obtain service, product literature, supplies or accessories
please call 1 888-920-8680, or visit our website, www.att.com/
electronics, to create a ticket for exchange/repair. Please make
sure to provide the date of purchase, model number and a brief
description of the problem. Our customer service representative
will contact you or send detailed return instructions.
Page 10
Page 11
www.att.com/electronics
©2014 Concept 101 LLC. All Rights Reserved. AT&T and the AT&T logo
are trademarks of AT&T Intellectual Property licensed to Concept 101
LLC, New York, New York 10018. Issue 3.0 AT&T 12/2014.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement