RR500 Manual - Liberty Games
RR500 JUKEBOX
WITH AM/FM RADIO, CD PLAYER AND MP4 DOCKING STATION
USER MANUAL
WWW.RICATECH.COM
The Lighting flash with an arrowhead symbol, within
the equilateral triangle, is intended to alert the user to
the presence of uninsulated “dangerous voltage”
within the product’s enclosure that may be of sufficient
magnitude to cause an electric shock.
The exclamation point within the equilateral triangle
is intended to alert the user to the presence of
important operating and maintenance (servicing)
instructions in this owner manual.
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION: TO PREVENT ELECTRIC SHOCK,
MATCH WIDE BLADE OF PLUG TO WIDE SLOT,
FULLY INSERT. (USA AND CANADA ONLY)
On Placement
Do not use the unit in places which are extremely hot, cold, dusty, or humid.
Place the unit on a flat and even surface.
Do not restrict the air flow of the unit by placing it in a place with poor air flow, by covering it with a
cloth.
FCC Information (USA VERSION ONLY)
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions:
(1) Device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesirable
operation.
On Safety
When connecting or disconnecting the AC cord, grip the plug and not the cord itself. Pulling the cord may
damage it and create a hazard.
When you are not going to use the unit for a long period of time, disconnect the AC power cord.
On Condensation
When left in a heated room where it is warm and damp, water droplets or condensation may form inside the
unit. When there is condensation inside the unit, the unit may not function normally. Let the unit stand for 1
to 2 hours before turning the power on, or gradually heat the room up and dry the unit before use.
ATTENTION SHOULD BE DRAWN TO THE ENVIRONMENTAL ASPECTS OF BATTERY DISPOSAL
WARNING:
Should any trouble occur, disconnect the AC power cord and refer servicing to a qualified technician.
Do not place anything directly on the top of the unit. Damage to the unit can result.
LASER SAFETY
THIS UNIT EMPLOYS A LASER.
ONLY A QUALIFIED SERVICE PERSONNEL SHOULD OPEN COVER IN ATTEMPT TO
SERVICE THIS DEVICE DUE TO POSSIBLE EYE INJURY.
CAUTION: USE OF ANY CONTROLS, ADJUSTMENTS, OR
PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN
MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
CD PLAYING
ENGLISH - 1
This section describes the compact disc controls in the order in which you
would normally use them.
Follow the instruction in a step-by-step sequence and in a very short time
you will master complete operation of the unit.
CD OPERATION
1. Rotate the VOLUME knob from OFF position towards the Max position to
turn on the unit.
2. Push the CD DOOR once to open the CD DOOR to insert a disc into the
DISC TRAY then push the CD DOOR again to close the CD DOOR.
**Make sure the CD DOOR is closed properly**
3. Press PLAY button.
4. Adjust the listening level by rotating the VOLUME knob.
NOTES
If the disc is seriously scratched, or too dirty, disc play may not start.
If an improperly centered disc is played, noise can be heard in the
mechanism. The use of such disc should be avoided.
Do not tilt the unit with discs loaded. Doing so may cause malfunction.
TO STOP DISC PLAY
Press the STOP button. Disc play will stop; the TRACK display will show the
total number of tracks.
TO LISTEN TO THE DESIRED TRACK
1. Press the F.F button, the CD player will skip ahead to the next track each
time when the F.F button.
2. Press the F.W button, the CD player will skip back to the previous track.
3. Press the PLAY button, play will start.
ENGLISH - 3
REPEAT DISC PLAY (IF EQUIPPED)
1. Press REP button once to repeat disc play of one track.
2. Press REP button twice to repeat disc play all the track.
3. Pressing once more turns off repeat mode.
PROGRAMMED DISC PLAY (IF EQUIPPED)
1. Press the STOP button.
2. Press the PGM button.
3. Select a track number then press PGM button again.
4. Repeat step 3 until all the desired tracks are programmed (Up to total 20
tracks).
RADIO
1. Rotate the VOLUME knob from OFF position towards MAX position to turn
on the unit.
2. Select AM or FM by sliding the FUNCTION selector.
3. Select radio station by rotating the TUNING knob.
4. To turn off the unit, rotate VOLUME knob to OFF position.
FM ANTENNA JACK (IF EQUIPPED)
For better FM reception, connect FM antenna wire (included) to the FM
ANTENNA jacks (located at the back cover)
LIGHT OPERATION
ENGLISH - 4
1. Rotate the LIGHT button to turn on all the light.
2. To turn off the light, rotate the LIGHT button again.
REMARK: (FOR NEON LIGHTS VERSION ONLY)
When MODE selector is switched to AM, the neon lights will be automatically
turned off.
LIGHT MODE (IF EQUIPPED BULB LIGHTS VERSION ONLY)
Switch the MODE selector at back cover to change the light mode.
LIGHT MODE (IF EQUIPPED LED LIGHTS VERSION ONLY)
The colours of the lights change over time, switch to HOLD at back cover to remain
static to your favourite colour. Switch to PLAY position to resume
*IMPORTANT NOTE: (LED LIGHTS VERSION ONLY)
The changing colors sequences of lights are controlled by IC, the lights maybe
turned off when the light mode in HOLD position is normal.
AUXILIARY CONNECTION “AUX IN” (IF EQUIPPED)
1. Connect your own device (i.e. MP3 player or IPOD) to the “AUX IN
2.
3.
4.
5.
connection” (located at the back of cabinet) with stereo plug and detachable
rack (packed separately). OR IF YOUR UNIT EQUIPPED WITH “AUX IN
socket” (located at the right side of cabinet) with RCA cord (packed
separately), the two ends of the cord should be connected to the holes of the
jack in accordance with the colors.
Adjust the ON / OFF switch next to the jack to the ‘ON’ position.
Rotate the mode selector to “CD-AUX”.
Adjust the sound with the VOLUME knob or the volume control of the device.
When change to another mode, the device will continue to play with no sound
until the ON / OFF switch is adjusted to ‘OFF’ position and switch off the device.
IMPORTANT NOTE:
1. Adjust the ON / OFF switch to the ‘OFF’ position when not in use.
2. The CD function will resume to normal only after the ON / OFF switch is adjusted
to ‘OFF’ position.
TROUBLESHOOTING GUIDE
The following checks will assist in the correction of most problems which you may encounter will
your set. Before going through the check list below first check the following points.
**The power cord must be connected firmly.
Should any problem persist after you have made these check consult your nearest friendly dealer.
Symptom
No radio
Disc play does not start.
Sound skips
Unit not working
No sound output
Severe hum or noise
Possible Causes (and Remedies)
Radio Reception
The function switch is not in the correct
position.
Adjust the VOLUME knob.
Rotate the TUNING knob to find a radio
station.
Switch the AUX IN jack to “OFF”
CD Player Operation
Reload the disc with the label side up.
Clean the disc.
Change the installation location.
Press reset button.
General
The AC power cord is not connected to an
outlet.
Check that the power cord is connecting
firmly.
Turn the power button from the “OFF”
position to “ON” position.
Turn VOLUME clockwise.
Press reset button.
Switch the AUX IN jack to “OFF” & remote
RCA cord.
The TV or VTR is too close to the stereo
system.
Separate from the TV or VTR.
SPECIFICATION
POWER CONSUMPTION
POWER SOURCE
:
:
LOUD SPEAKER
:
ENGLISH - 6
15W
PLEASE REFER
TO THE CAUTION
LABEL ON THE
BACK SIDE OF
UNIT.
2 X 3” 8 Ohms.
Warranty:
Ricatech BV covers all products (Excl. accessories) with a 2 year warranty applying to all faults
caused by a factory-error. External physical damage will not be covered by our warranty
Warranty:
All hardware errors occurring within 2
years after purchase unless caused
by points mentioned below.
Faults caused by:
*Dismountal by any other service
center then ours.
*Water and moisture damage
*Drop and bump damage
*Usage with non approved Ricatech
accessories.
*Short-circuit or over-voltage
*Physical damage, loss or damage to
accessories
No Warranty :
Out of warrranty
repairs
Please be so kind to contact us for
out-of-warranty repairs. We will
provide you with a quotation with the
expected costs.
Goods out of warranty cannot be
returned to your reseller.
Ricatech BV
Tinstraat 103, 2984AN Ridderkerk
The Netherlands
Tel : +31 (0)180 446020
Fax : +31 (0)180 446029
Email : [email protected]
Support : [email protected]
Website : www.ricatech.com
IM-NYSRC-09X
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement