LP
670-4
Installation Manual
[Remote Controller System]
1. Red Cable ： Key on Switch
2. Brown Cable ： GND
3. Yello Cable ： TPS Voltage Signal 0~5V
4. Electronic Valve
1
2
3
4
第 1 頁
Step1. FIND FUSE BOX, CONNECT WITH RED POWER CORD IN ORDER, HANG THE
GND AND THROTTLE VALVE SIGNAL 0-5V
1 、 FIND FUSE BOX UNDER THE GLOVE COMPARTMENT AT PASSENGER'S SEAT AND
CONNECT RED POWER CORD ON THE NUBER "10" (THE SECOND-LAST)
↓ SEE THE IMAGE BELOW
第 2 頁
2 、 HANG GND ABOVE THE FUSE BOX
3 、 FIND YELLOW/BLACK CABLE LINES FROM ELECTRONIC POWER CONTROL ON THE
RIGHT HAND SIDE OF ACCELERATOR PEDAL, THEN CONNECT YELLOW/BLACK CABLES
第 3 頁
Step2. OPEN THE ENGINE BAY YOU WILL FIND THE SOLENOID VALVE ON YOUR
RIGHT HAND SIDE, PULL OUT THE "IN" AND "OUT " CABLE LINE
Before
6.儲壓桶
第 4 頁
After Installation
CONNECT THE STOCK "IN" AND "OUT
"SOLENOID VALVE TOGETHER WITH
CALBE LINES. SEE THE IMAGE ON YOUR
LEFT HAND SIDE.
第 5 頁
