—

QUICK START GUIDE

Pedestal for Terra AC wallbox

Rectangular back-to-back 6AGC082326

B x2

C x2

Component

A pedestal sleeve grommet

D=35mm H=15mm sleeve grommet

D=30mm H=15mm

E x2

F x2

G x2

Component

D x2

Adapter

Gasket 80x44 mm

Gasket D= 40 mm

Gasket D= 40 mm

I x1

J x4

K x4

Component

H x2

Device cover

Screw bit

M5x3 screw

M6x80 screw with socket head

• 1. Remove the cover by taking out the 14 screws (use screw bit I). Next remove the e-base cover from the e-base (1) (mounted with 4x PH2 screws).

• 2. Mount the pedestal on a concrete foundation. Use 4x anchors M10x40 for anchoring (not included in the packaging), mark 4 holes on the foundation, drill 4 holes with diameter 12mm and minimum depth 43mm, hammer the anchors so that they are flush with the floor and anchor the pedestal to the foundation using 4 bolts M10 and washer.

• 3. Position the connection cables from the bottom and cut on length.

• 4. Secure the connection cables on DIN rail 1 (2). This is compatible with Phoenix Contact cable clamps: WCC

14 – (3240252)/ 18 – (3240253)/ 22 – (3240254)/ 26 – (3240255)/ 30 – (3240256)/ 34 – (3240257) or equivalents.

• 5. Install the terminal blocks on DIN rail 2 and DIN rail components on DIN rails 3,4 and 5 each DIN rail has room for 8 slots.

• 6. Install the wiring between the terminal blocks and the DIN rail components.

• 7. Add sealings (E), (F) and (G) to adapter (D).

• 8. Remove from Terra AC the 26 and 32mm grommets and in place click in the adapter (D).

• 9. Place the 2x M5x3 screws (J) in the pedestal (A) top area and sleeve grommets (B) and (C).

• 10. Mount the Terra AC Wallbox on the pedestal (A). Take the front cover off.

• 11. Screw in the 2x M6x80 (K).

• 12. Continue install of the Terra AC Wallbox as per the device installation manual.

• 13. Mount the e-base cover on the e-base.

• 14. Cut the device covers (H) as required per the installation conducted.

• 15. Close cover pedestal (A).

Note (1): e-base can be wired separate/outside from the pedestal(A). It can be take out and in again including DIN rail components and wiring.

Note (2): The DIN rail component can be changed to support different terminal block models.

5

2

1

4

3

Click

!

Push to secure adapter

F G D

In case to take out adapter use flat head screwdriver

E B A

C