ALL Security Equipment FAS-RM893 3-Button Remote User Guide
Advertisement
Advertisement
3-Button Remote with Visor Clip
FAS-RM893
5
3
5 CR2032
Programming
Remote controls
This remote Can be used as a replacement remote control for 80 Series,970 Series,890
Series Liftmaster Remote controls.
Compatible with 315MHZ or 390MHZ garage door openers manufactured after January 1,
1993.Make sure the garage door opener has a working light bulb because it is a programming indicator.
For use with gate operators ,commercial door operators,or other products that are 315MHZ or 390MHZ and have a Learn button.
Programming
Remote controls
(The default of 3 buttons is to
Programming garage door opener with YELLOW Learn button)
1.Press and hold 1+2 button at the same time until remote LED flash quickly then off,within 3
Second
2.Press and release the remote control button you wish to use the number of times that corresponds with the garage door opener type:
# of Presses Garage door opener Type
1 Security+2.0 (Yellow Button)
2 315MHZ Security+(Purple button)
3 390MHZ Security+(Red/Orange button)
4 390MHZ Billion Code(Green button)
For example,if you press any button 4 times,remote
LED will flash 4 times then off,then you can use this button that pressed 4 times to programming with
Green Learn button opener.
3.Press and release the Learn button on the garage door opener.The Learn LED will light.within 30 seconds
4.Press the remote control button programmed in step 2 until the garage door opener lights flash or two clicks are heard.
5.To test,press the programmed button on the remote control...the garage door opener will activate.Last install the visor clip.
Programmed pair up again
9

Public link updated
The public link to your chat has been updated.
Advertisement