Screamer User Manual
LEVEL - This is the overall level of the affected signal. Adjust this for the correct
sound level between off and on.
Tone - Controls overall tone of the pedal.
Drive - All the way counter clockwise is no
gain, all the way clockwise is about twice
the gain of a typical Overdrive pedal.
IN—Guitar Input to the pedal. This jack disconnects power, so unplug when not in use.
OUT - Output of the pedal. Plug this either
into your amp or into any other effects you want after this effect.
Bypass Switch - Kick the switch
to change from effect on to
effect off.
DC Power Jack - Used
to power your pedal
from a DC supply. This has
the same pin-out as the
standard pedal supplies,
tip is ground, sleeve is
9V. Use a filtered
supply, especially
on high gain overdrive and distortion
pedals, since they tend to
amplify power supply noise.
Status LED (Red/Green) - When the effect is on
the LED is Red. When battery voltage is below
~7.5V, the LED will blink a few times when the pedal
is engaged. By default the LED is Green when bypassed. To have the LED off in bypass HOLD the Bypass Switch for several seconds until the LED Blinks.
Hold again to turn the LED back on in Bypass.
Clip Mode Toggle - Select the type of Clipping
Diodes. To the Left is “Stock”, to the right is
“Crushed”, and in the middle is “LED” (Asymmetrical
LED clipping). Different diodes cause the overall
level to change, so you may have to adjust
the level after moving the Clip
Mode Toggle.
Clip LED This is the
LED above the Toggle
Switch. When in LED Clip
Mode, this LED will follow
your guitar playing. The
brightness will vary depending
on guitar pickups and Drive setting, and does not light up at low
gain settings. If you jam the front
end with another high gain pedal, you
can use the Clip-O-Meter to tune your
guitar. Hit your 5th fret and next open;
Tune until the Clip-O-Meter stops blinking. A
great trick to impress your friends with!
Power Consumption - ~8mA.
Updated 7/16/10
www.cusackeffects.com
494 Lincoln Ave, STE 10, Holland, MI 49423
(616)546-8888
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement