Windows 7 PDF Guide

Windows 7 PDF Guide
Setup guide for
Windows 7
UniWide is the UNSW Campus Wireless Network for UNSW students and staff. It offers fast,
secure wireless network connectivity from a wide range of locations across UNSW’s campuses. Wireless access is available to all current staff and students. UniWide can be accessed via
any WiFi-enabled laptop or mobile device that supports WPA2 Enterprise wireless security.
System requirements & prerequisites
To access UniWide, you will need a properly configured 802.11a/b/g/n (WiFi) compatible notebook
computer or mobile device that supports WPA2 Enterprise wireless security. Most new notebooks and
many new mobile devices meet these requirements.
1. Activate your laptop’s wireless connectivity [page 1]
2. Configure your wireless connection for UniWide [page 1]
3. Connect to UniWide [page 5]
UniWide requires zPass to access - UniPass will no longer work on this service
For more information about zPass, please visit
UniWide setup instructions
Step 1 - Activate your laptop’s wireless connectivity
Methods of turning wireless networking on and off differ from computer to computer.
Some laptops have a key displaying the wireless symbol (left), while others require a
manual connection method. If in doubt, consult your laptop’s user manual.
Step 2 - Configure your wireless connection for UniWide
You need to be on campus near a UniWide
hotspot such as a library, computer lab or
common area to configure your computer.
If unsure look for the UniWide logo (above)
or view for
hotspot locations on campus
Last updated: 05/05/11 12:42pm
Staff Version
1. Click Start > Control Panel
View by Category
2. Under Network and Internet click
View Network status and tasks
3. Click Set up a new connection or
4. Click Manually connect to a wireless
Continued over...
5. Type uniwide (in lowercase)
in the Network name field
• Select WPA2-Enterprise from the
Security Type drop-down menu.
• Select AES from the Encryption
type drop down menu
6. Click Next
7. Click Change connection
8. Ensure the following are checked:
• Connect automatically when this
network is in range
• Connect to a more preferred
network if available
9. Click on the Security tab
• Check the Remember my credentials...
(below Protected EAP drop-down menu)
10. Click on the Settings
Continued over...
11. Ensure the following are checked:
• Validate server certificate
• QuoVadis Root CA2
• Enable Fast Reconnect
12. Click the Configure button
13. Ensure this is NOT checked
14. Click OK to close this window
15. Click OK to close the previous two
When you see the Manually Connect to a wireless
network window, click Close
You have configured your laptop to connect to UniWide
Continued over...
Step 3 - Connect to UniWide network
1. Click on the Additional information is
needed bubble if it appears (then go to step 4)
or if the bubble is not visible...
2. Click Connect to a network
inside the Network and
Sharing Center window
3. Then select uniwide in the Connections are available window and click
the Connect button.
4. Enter your z number and your
zPass in their respective fields then
click OK
A Connecting to uniwide window will appear
You should see uniwide in the Network and Sharing Center window,
You are now connected to the UniWide wireless network
Once you have completed the above instructions your laptop should automatically connect to
UniWide whenever you are on campus AND within range of a UniWide access point.
Refer to the website for UniWide coverage maps.
Note: ensure your laptop has wireless connectivity turned on before attempting to access UniWide.
If you change your zPass in the future - you will be prompted to re-enter it the
next time you attempt to connect to UniWide
If you have any issues or questions, please contact the IT Service Centre at [email protected]
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF