Hill-Rom Liko 31390012 Assembly Instruction

Helping Hand
Assembly Instruction
Product No. 31390012
Contains: Fits:
3139012 Helping Hand
3136010 Carriage MR, S50
Helping hand is an accessory to Multirall™ overhead lift that facilitates the connection and disconnection of the lift strap
from the Quick-release Hook mounted in the rail system. For complete instructions for assembly and use of Multirall™
overhead lift, please refer to the instruction guide, which can be downloaded at www.liko.com.
Definitions
Upper part
Helping hand
Measurements:
Length: 134 cm / 52.7 inch.
Rail
Carriage
Q-link
Safety latch
Lift strap
Quick-release Hook
3EN690244 Rev. 1
ENGLISH
Mounting the lift motor:
1. Place the lift strap with the Q-link in the
Helping hand.
Move the Helping hand with the Q-link towards the Quick-release Hook according to the illustration
above.
3.
2. Press up the safety latch with the upper part of the Helping hand and connect the Q-link to
the Quick-release Hook.
After mounting, make sure that the lift strap with Q-link is securely attached to the Quick-
release Hook (see illustration) and that the safety latch functions properly.
Assembly Instruction Helping Hand • 3EN690244 Rev. 1
4. Multirall™ overhead lift is now properly mounted and ready for use.
2(4)
www.hill-rom.com
l
www.liko.com
Incorrect use!
Before lifting it is important to ensure that the
lift strap is securely fastened to the Quick-release
Hook. The Q-link must pass the safety latch on the
Quick-release Hook and the lift strap must hang
vertically before lifting begins.
Helping hand Multirall™ overhead lift must not be
left in the Quick-release Hook after mounting the lift
strap. Helping hand is just an accessory that is used to
facilitate the connection and disconnection of the lift
strap and it must never be under load.
Assembly Instruction Helping Hand • 3EN690244 Rev. 1
3(4)
www.hill-rom.com
l
www.liko.com
Dismounting the lift motor:
2. Place the Q-link in the Helping hand according to the illustration above.
3. Press on the back of the safety latch and unhook the Q-link from the Quick-release Hook.
4. Remove the lift strap and the Helping hand from the Quick-release Hook mounted in the rail.
© Copyright Liko R&D AB 2017
1. Lower the lift motor to a Multirall™ overhead lift
Trolley or other suitable location. Unload the lift strap
by applying tension to the strap, while feeding out
the desired length by pressing the button marked
in the desired direction.
NOTE
- Make sure the spare part is mounted according to the assembly instruction.
- Check all functions related to the changed spare part.
- Repairs and maintenance may only be performed by personnel authorized by Hill-Rom and using original Liko™ spare parts.
Assembly Instruction Helping Hand • 3EN690244 Rev. 1
4(4)
www.hill-rom.com
l
www.liko.com