ADJ Starball LED User manual

Add to my manuals
4 Pages

advertisement

ADJ Starball LED User manual | Manualzz

11/07

American DJ

User Instructions

®

American DJ

®

6122 S. Eastern Ave.

Los Angeles Ca. 90040 www.americandj.com

Starball LED™ Introduction

Unpacking:

Thank you for purchasing the Starball LED™ by American DJ

®

. Every

Starball LED™ has been thoroughly tested and has been shipped in perfect operating condition. Carefully check the shipping carton for damage that may have occurred during shipping. If the carton appears to be damaged, carefully inspect your unit for any damage and be sure all equipment necessary to operate the system has arrived intact. In the event damage has been found or parts are missing, please contact our toll free customer support number for further instructions. Please do not return the unit to your dealer without first contacting customer support.

Customer Support:

American DJ

®

provides a toll free customer support line, to provide set up help and to answer any question should you encounter problems during your set up or initial operation. You may also visit us on the web at www.americandj.com for any comments or suggestions. For service related issue please contact American DJ

®

. Service Hours are Monday through Friday 9:00 a.m. to 5:00 p.m. Pacific Standard Time.

Voice:

Fax:

E-mail:

(800) 322-6337

(323) 582-2941 [email protected]

To purchase parts online visit http://parts.americandj.com

Warning!

To prevent or reduce the risk of electrical shock or fire, do not expose this unit to rain or moisture.

Caution!

There are no user serviceable parts inside this unit. Do not attempt any repairs yourself, doing so will void your manufactures warranty. In the unlikely event your unit may require service please contact

American DJ.

PLEASE recycle the shipping carton whenever possible.

Safety Issues: This unit may blow a fuse if the maximum allotted load of 2 amps is reached. If the fuse needs replacement, always replace the fuse with same exact type that was remove, unless otherwise instructed by an authorized American DJ

®

service technician. Use of a different type fuse from that which is recommended may cause fire or electric shock and will void the manufactures warranty.

© American DJ Supply ® - www.americandj.com - Starball LED™ Instruction Manual Page 2

Starball LED™ General Instructions

To optimize the performance of this product, please read these operating instructions carefully to familiarize yourself with the basic operations of this unit. These instructions contain important safety information regarding the use and maintenance of this unit. Please keep this manual with the unit, for future reference.

Starball LED™ Safety Precautions

• Be sure that the local power outlet match that of the required volt-

age for your unit.

• Do not attempt to remove or break off the ground prong from the

electrical cord. This prong is used to reduce the risk of electrical

shock and fire in case of an internal short.

• Do not remove the unit cover under any conditions. There are no

user serviceable parts inside.

• Never plug this unit in to a dimmer pack

• Always be sure to mount this unit in an area that will allow proper

ventilation. Allow about 6” (15cm) between this device and a wall.

• To reduce the risk of electrical shock or fire, do not expose this unit

rain or moisture.

• This unit is intended for indoor use only, use of this product out-

doors voids all warranties.

• During long periods of non use, disconnect the unit’s main power.

• Always mount this unit in safe and stable matter.

• Power-Cord Protection - Power-supply cords should be routed so

that they are not likely to be walked on or pinched by items placed

upon or against them, paying particular attention to cords at plugs,

convenience receptacles, and the point where they exit from the fix-

ture.

• Cleaning -The fixture should be cleaned only as recommended by

the manufacturer.

• The fixture should be serviced by qualified service personnel when:

A. The power cord or the plug has been damaged.

B. Objects have fallen, or liquid has been spilled into the appliance.

C. The appliance has been exposed to rain or water.

D. The fixture does not appear to operate normally or exhibits a

marked change in performance.

Starball LED™ Warranty Registration

The Starball LED™ carries a one year (365 days) limited warranty.

Please fill out the enclosed warranty card to validate your purchase.

All returned service items whether under warranty or not, must be freight pre-paid and accompany a return authorization (R.A.) number.

The R.A. number must be clearly written on the outside of the return package. A brief description of the problem as well as the R.A. number must also be written down on a piece of paper and included in the shipping container. If the unit is under warranty, you must provide a copy of your proof of purchase invoice. You may obtain a R.A. number by contacting customer support at (800) 322-6337.

Starball LED™ Operation

Power Supply:

Before plugging your unit in, be sure the source voltage in your area matches the required voltage for your American

DJ

®

Starball LED.™ The American DJ

®

Starball LED ™ is available in a 120v and 230v version. Because line voltage may vary from venue to venue, be sure to plug your fixture into a wall outlet with a matching power supply before attempting to operate.

General Operation:

Simplicity! Just plug this fixture in, and watch it go. This fixture is designed to operate as a stand alone unit, there is no need of a controller. It has been tested at the factory there is no assembly necessary. The Starball LED™ is ready to be plugged in, out of the box.

There is no power switch, after plugging the unit the unit will light up and begin to slowly rotate in a single direction. If there is no rotation and light output check the fuse. If the fuse is good, please contact our toll free customer support number for further instructions. Please do not return the unit to your dealer without first contacting customer support.

©

American DJ Supply

®

- www.americandj.com - Starball LED™ Instruction Manual Page 3

©

American DJ Supply

®

- www.americandj.com - Starball LED™ Instruction Manual Page 4

Starball LED™

Fixture Cleaning:

Cleaning

Due to fog residue, smoke, and dust cleaning the fixture should be carried out periodically to optimize light output.

1. Use normal glass cleaner and a soft cloth to wipe down the outside

casing every 20 days.

2. Use a small brush and normal glass cleaner with a soft cloth to

wipe down the inside casing every 30-60 days.

3. Always be sure to dry all parts completely before plugging the

unit back in.

4. Frequent cleaning will extend lamp life and ensure fixture reliability.

Cleaning frequency depends on the environment in which the fixture operates (I.e. smoke, fog residue, dust, dew). In heavy use we recommend cleaning on a monthly basis. Periodic cleaning will ensure longevity, and crisp beam output.

Starball LED™

Trouble Shooting:

Trouble Shooting

Listed below are a few common problems and solutions you should try before contacting customer support.

Unit does not rotate and LED does not turn on;

1. Be sure you have connected your unit into a matching wall outlet.

2. Be sure the external fuse has not blown. The fuse is located on the

side panel of the unit.

3. Be sure the power cord is properly seated in the power outlet.

4. Be sure your main power outlet has power.

©

American DJ Supply

®

- www.americandj.com - Starball LED™ Instruction Manual Page 5

Starball LED™ Warranty

MANUFACTURER’S LIMITED WARRANTY

A. American DJ, Inc. hereby warrants, to the original purchaser, American DJ and American

Audio products to be free of manufacturing defects in material and workmanship for a prescribed period from the date of purchase (see specific warranty period on reverse). This warranty shall be valid only if the product is purchased within the United States of America, including possessions and territories. It is the owner’s responsibility to establish the date and place of purchase by acceptable evidence, at the time service is sought.

B. For warranty service you must obtain a Return Authorization number (RA#) before sending back the product. Contact American DJ, Inc. Service Department at 800-322-6337. Send the product only to the American DJ, Inc. factory. All shipping charges must be pre-paid. If the requested repairs or service (including parts replacement) are within the terms of this warranty,

American DJ, Inc. will pay return shipping charges only to a designated point within the United

States. If the entire instrument is sent, it must be shipped in it’s original package. No accessories should be shipped with the product. If any accessories are shipped with the product, American DJ,

Inc. shall have no liability whatsoever for loss of or damage to any such accessories, nor for the safe return thereof.

C. This warranty is void if the serial number has been altered or removed; if the product is modified in any manner which American DJ, Inc. concludes, after inspection, affects the reliability of the product; if the product has been repaired or serviced by anyone other than the American DJ,

Inc. factory unless prior written authorization was issued to purchaser by American DJ, Inc.; if the product is damaged because not properly maintained as set forth in the instruction manual.

D. This is not a service contract, and this warranty does not include maintenance, cleaning or periodic check-up. During the period specified above, American DJ, Inc. will replace defective parts at its expense with new or refurbished parts, and will absorb all expenses for warranty service and repair labor by reason of defects in material or workmanship. The sole responsibility of American DJ, Inc. under this warranty shall be limited to the repair of the product, or replacement thereof, including parts, at the sole discretion of American DJ. All products covered by this warranty were manufactured after January 1, 1990, and bear identifying marks to that effect.

E. American DJ, Inc. reserves the right to make changes in design and/or improvements upon its products without any obligation to include these changes in any products theretofore manufactured. No warranty, whether expressed or implied, is given or made with respect to any accessory supplied with products described above. Except to the extent prohibited by applicable law, all implied warranties made by American DJ, Inc. in connection with this product, including warranties of merchantability or fitness, are limited in duration to the warranty period set forth above. And no warranties, whether expressed or implied, including warranties of merchantability or fitness, shall apply to this product after said period has expired. The consumer’s and/or Dealer’s sole remedy shall be such repair or replacement as is expressly provided above; and under no circumstances shall American DJ, Inc. be liable for any loss or damage, direct or consequential, arising out of the use of, or inability to use, this product.

This warranty is the only written warranty applicable to American DJ and American Audio

Products and supersedes all prior warranties and written descriptions of warranty terms and conditions heretofore published.

MANUFACTURER’S LIMITED WARRANTY PERIODS:

• All American Audio Products = 1-year (365 day) Limited Warranty (except V-Plus Series Amplifiers)

• All American Audio V-Plus Series Amplifiers = 3-year (1095 day) Limited Warranty

• American DJ Lighting and American DJ Branded Products = 1-year (365 day) Limited Warranty

(Such as: Special Effect Lighting, Intelligent Lighting, UV lighting, Strobes, Fog Machines, Bubble

Machines, Mirror Balls, Par Cans, Trussing, Lighting Stands etc. excluding Laser Products, lamps, and Star Tec Series)

• American DJ Laser Products and Star Tec Products = 90-Day Limited Warranty

• American DJ L.E.D. Products = 3-year (1095 day) Limited Warranty (excluding motors which have a 1-year (365 day Limited Warranty)

©

American DJ Supply

®

- www.americandj.com - Starball LED™ Instruction Manual Page 6

Technical Specifications:

Model: Starball LED™

Voltage*:

Lamp:

Dimensions:

Colors:

Beams:

Weight:

Adapter/Output:

Power Consumption:

Ventilation:

Warranty:

* Voltage is preset at the factory and is not user selectable

120v~60Hz or 230v~50/60Hz

12V~1.67A/20VA

One 3 Watt

8.25” (L) x 8.25” (W) x 7” (H)

Clear

34 Multi Colored Beams

4 Lbs./1.8 Kgs.

17W

Air Cooled

One year (365 Days)

Please Note:

Specifications and improvements in the design of this unit and this manual are subject to change without any prior written notice.

© American DJ Supply ® - www.americandj.com - Starball LED™ Instruction Manual Page 7

©American DJ®

American DJ® Group of Companies World Headquarters:

6122 S. Eastern Ave. Los Angeles, CA 90040 USA

Tel: 323-582-2650 / Fax: 323-582-2610

Web: www.americandj.com / E-mail: [email protected]

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement