Philips SBA3210/00 User manual

Philips SBA3210/00 User manual
Register your product and get support at
www.philips.com/welcome
SBA3210/00
User manual
1Important
Safety
Important Safety Instructions
• Heed all warnings.
• Follow all instructions.
• Do not use this apparatus near water.
• Do not block any ventilation openings. Install in accordance with the
manufacturer’s instructions.
• Do not install near any heat sources such as radiators, heat registers,
stoves, or other devices (including amplifiers) that produce heat.
• Only use attachments/accessories specified by the manufacturer.
• Refer all servicing to qualified service personnel. Servicing is required
when the device has been damaged in any way, such as power-supply
cord or plug is damaged, liquid has been spilled or objects have fallen
into the device, the device has been exposed to rain or moisture,
does not operate normally, or has been dropped.
• Devices shall not be exposed to dripping or splashing.
• Do not place any sources of danger on the device (e.g. liquid filled
objects, lighted candles).
Warning
•• Never remove the casing of this apparatus.
•• Never lubricate any part of this apparatus.
•• Never place this apparatus on other electrical equipment.
Notice
Any changes or modifications made to this device that are not expressly
approved by Philips Consumer Lifestyle may void the user’s authority to
operate the equipment.
This product complies with the radio interference requirements of the
European Community.
Disposal of your old product
Your product is designed and manufactured with high quality
materials and components, which can be recycled and reused.
When this crossed-out wheeled bin symbol is attached to a
product it means that the product is covered by the European
Directive 2002/96/EC.
Please inform yourself about the local separate collection
system for electrical and electronic products.
Please act according to your local rules and do not dispose of your old
products with your normal household waste. Correct disposal of your
old product helps to prevent potential negative consequences for the
environment and human health.
Your product contains batteries covered by the European
Directive 2006/66/EC, which cannot be disposed with normal
household waste.Please inform yourself about the local rules on
separate collection of batteries because correct disposal helps to prevent
negative consequences for the environmental and human health.
Always bring your product to a professional to remove the built-in battery.
Environmental information
All unnecessary packaging has been omitted. We have tried to make
the packaging easy to separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.)
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging materials, exhausted
batteries and old equipment.
Note
•• The type plate is located on the bottom of the apparatus.
2
Get started
Always follow the instructions in this chapter in sequence.
If you contact Philips, you will be asked for the model and serial number
of this apparatus. The model number and serial number are on the
bottom of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
What’s in the box
Power supply
The speaker can operate on built-in rechargeable battery.
To recharge the built-in battery:
Connect your speaker with PC through supplied cable.
»» The power indicator turns on.(white)
• The power indicator turns off when it’s fully charged.
Play
1 Connect your two speakers with supplied cable.
2 Connect your device to the speaker.
3 Slide the switch to turn the speaker on.
»»The power indicator turns on.
4 Adjust the volume and navigate your audio content on your device.
5 After use,disconnect your device from the speaker and slide the
switch to turn the speaker off.
3
Product information
Note
•• Product information is subject to change without prior notice.
Specifications
Amplifier
Rated Output Power
2 x 2W RMS
Signal to Noise Ratio
>70dB
Aux-in Link
600 mV RMS, 10 kohm
General information
DC power input
USB: 5V, 500mA
Built-in Li-Polymer battery
3.7V 500mAH, each unit
Battery working time
>8 hours
Dimensions-Main Unit
(diameter x height)
D56 mm* H80mm
Weight- Main Unit
0.17 kg *2
4Troubleshooting
Warning
•• Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair the system yourself.
If you encounter problems when using this apparatus, check the
following points before requesting service. If the problem remains
unsolved, go to the Philips web site (www.philips.com/welcome). When
you contact Philips, ensure that the apparatus is nearby and the model
number and serial number are available.
No power: Recharge your speaker.
No sound : Adjust volume on your device.
No response from the speaker : Restart the speaker.
All registered and unregistered trademarks are property of their
respective owners.
© 2012 Koninklijke Philips Electronics N.V.
All rights reserved.
SBA3210_00_UM_V1.0
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement