VR Training Quick
Access Guide
How to use the Oculus Quest 2
SETUP
NAVIGATE
•
•
•
•
Press and hold the power button on the right side of the headset until a light appears
Power on the WiFi router (or check that the headset is connected to a local network)
Put the headset on and adjust straps so the headset sits comfortably on your head
Adjust eye gap width if necessary to make image clear, by gently pushing the lenses closer together or further apart
• Point the controller straight in front of you and press and hold the home button for 3 seconds (this will centre the view and
controller; repeat if needed to adjust orientation during training)
• From the Universal menu at the bottom of your view select App Library (indicated by a 9-dot grid icon) – press home button
once if the menu is not visible
• Select the TACTICS VR - Telehealth application icon user the trigger button to launch the module
START
•
•
•
•
Interact with the menus by pointing your controller and selecting options by clicking the trigger button
To initiate training select START
Follow on-screen prompts to progress through the training workflow
Pause the scenario at anytime, using the B button (press B button again to restart)
FINISH
• You will be given feedback on your performance at the end of the module
• For additional information go to www.tacticsvr.com.au
• Upon completion of training, power off the headset by holding down the power button and selecting Power Off in the
headset
VR Training Quick
Access Guide
Oculus Quest 2
Adjustment Straps
(top / back)
Adjust straps until fit is
firm but comfortable
Headset
A Button
Toggle tablet to view
patient details
B Button
Press to pause /
restart scenario
Home Button
Press and hold for 3seconds to re-centre
view and controller
(single click to toggle
Oculus menus)
Power Button
Turn on headset by
holding down until light
appears
Volume Buttons
(+/-)
Adjust as necessary to
local noise conditions
Controller
Trigger Button
Press to select menu
/ answer options
(Only right hand
required)
">
