6400 SYCAMORE CANYON BLVD.
RIVERSIDE, CALIFORNIA 92507
855-680-9595
WWW.DV8OFFROAD.COM
PRODUCT
INSTALLATION MANUAL
Interior Speaker/Light Mount
2021+ Bronco
BRSB-01
TOOLS REQUIRED
SKILL LEVEL
TIME REQUIRED
- #5 Allen Head
- Novice/Intermediate
- 1 persons
- .5 Hour
Little skill level required, you can
easily install it by yourself.
Time to install this should
approximately take .5 hour.
WARNINGS/CAUTIONS BEFORE STARTING INSTALLATION
Before you install this kit — Read and understand all
instructions, warnings, cautions, and notes contained in
this installation instruction guide. Consult your vehicle
owner’s manual for proper disconnection of electrical and
lifting of vehicle if required for installation of this product.
This install may require some technical skills and
knowledge of basic mechanical work. If you do not feel that
you are capable of performing this install please take this
product to a trained professional.
After reading this guide please contact us with any
questions or concerns before installing product.
Customer Service: 855-680-9595
DV8 Offroad is not responsible for any bodily injury or harm to you
or your vehicle as a result of an improper install.
Proper installation of this kit required knowledge of the factory
recommended procedures for removal and installation of original
equipment components. We recommend that the factory shop manual
and any special tools needed to service your vehicle be on hand during
the installation. Installation of this kit without proper knowledge of the
factory recommended procedures may affect the performance of these
components and the safety of the vehicle
• Always wear eye protection when operating power tools
Inspect all contents of this package to make sure product is not damaged
and all installation hardware has been included. If parts are missing from
kit, please be prepared to provide the following information
1. Name of purchase location
2. Bar Code on side of box
3. Date above bar code
4. Date inside box cover
NEED HELP?
855-680-9595
INSTALLATION MANUAL
STEP 1
Begin by unpacking all items and
inspecting for missing pieces or
damage. If you have any concerns,
please contact the company the
product was purchased from. This
can be installed with and without a
top, however removal of the top will
allow install to be much faster.
Hardware Included:
-(4) M8x25mm Bolts
-(4) M8 split Washers
-(4) M8 Flat Washers
STEP 2
Locate the four M8 factory mounting
holes on top of the rear roll cage.
NEED HELP?
855-680-9595
INSTALLATION MANUAL
STEP 3
Hold up your speaker bar, and using
your #5 allen head and provided
hardware, loosely install speaker bar.
NEED HELP?
855-680-9595
INSTALLATION MANUAL
STEP 4
Ensure speaker bar is straight and
centered, and secure hardware.
NEED HELP?
855-680-9595
INSTALLATION MANUAL
STEP 5
When mounting items, use the
provided rubber grommets on the bar
to run wiring as needed.
STEP 6
Double check all hardware and wiring
is secure.
NEED HELP?
855-680-9595
">
