Universal Hardware UH4062 Heavy-Duty All-in-One Bronze Commercial Door Closer Instructions

Add to My manuals
2 Pages

advertisement

Universal Hardware UH4062 Heavy-Duty All-in-One Bronze Commercial Door Closer Instructions | Manualzz

999-30014

UNIVERSAL MOUNTING PLATE

UH4061/UH4062 INSTALLATION INSTRUCTIONS

1

Remove door closer to be replaced. Determine door handing and installation type. Align holes in the mounting plate with the existing mounting holes in the door or the jamb (for Top Jamb installations).

Notes:

• When installing mounting plate, make sure you can see the FRONT of the plate with properly marked handing and that the HINGE side of plate matches illustrations shown. Plate is marked with a sticker that designates the front and hinge side.

• The mounting plate will have to be flipped when used in a parallel arm installation so the hinge sticker is facing opposite side of illustration. Flip plate from left to right or right to left. DO NOT FLIP PLATE FROM TOP TO BOTTOM.

Regular Arm Installation

Left Hand Door - LH

Right Hand Reverse - RHR

Top Jamb Installation

Right Hand Door - RH

Left Hand Reverse - LHR

Left Hand Door - LH

Right Hand Reverse - RHR

Parallel Arm Installation

Right Hand Door - RH

Left Hand Reverse - LHR

Left Hand Door - LH

Right Hand Reverse - RHR

Right Hand Door - RH

Left Hand Reverse - LHR

999-30014

UNIVERSAL MOUNTING PLATE

UH4061/UH4062 INSTALLATION INSTRUCTIONS

2

Attach mounting plate to the door or jamb by either using the fasteners from the closer being replaced or the fasteners supplied with the

UH4061/UH4062 door closer. For the supplied fasteners, use the

“Preparation for Fasteners” chart on Page 2 of the closer instructions to identify the fasteners to be used.

3

Install UH4061/UH4062 door closer on the mounting plate with four

1/4"-20 x 7/16" oval head machine screws and install arm onto closer.

Refer to "Main Arm Installation" (Pages 3-5; dependent on installation type) for correct arm preload.

Notes:

• When installing forearm shoe or parallel arm bracket reuse existing holes if possible.

• If existing forearm shoe holes or existing parallel arm holes cannot be used, redrill new holes in door or frame; following "Door Closer

Installation Instructions"(Pages 3-5; dependent on installation type).

4

To adjust closer refer to "Door Closer Installation Instructions" provided

(Page 6).

Regular Arm Installation shown

FOR CUSTOMER CARE CALL TOLL FREE

800-562-5625 OR [email protected]

50 Icon, Foothill Ranch, CA 92610-3000 USA www.hamptonproducts.com • 1-800-562-5625

©2019 Hampton Products International Corp.

999-30014 REVA_Eng 08/19

advertisement

Related manuals

Download PDF

advertisement