Sareer Richmond Assembly Instructions

1
1465mm
Approximate
Assembly Time
1025mm
20
mins
600mm
Two persons are
recommended to
assemble this product
2360mm
Richmond 4'6" Bed
BEFORE STARTING...
Read the assembly instructions carefully before
beginning assembly.
Check and ensure that you have all parts and fittings
for complete assembly.
Choose a clean, level, spacious assembly area.
Hard surfaces may damage the product.
The packaging and contents can be a choking
hazard, therefore keep out of reach of small chidren
at all times.
Do not over tighten the bolts as this may damage
the thread.
HARDWARE
A
2
B
C
D
M8 x 25mm
x 12pcs
Washer
x 18pcs
M8 x 40mm
x 4pcs
M8 x 50mm
x 3pcs
E
F
G
Hex Nut
x 7pcs
Allen Key
x 1pc
Spanner
x 1pc
PART
1
3
6
9
10
3
4
8
7
5
9
2
10
10
1
3
Screw in the wooden legs to headend and footend.
1
2
1
2
1
10
10
10
10
2
Attach the siderails and centre rail to the bedend.
3
1
A
F
3
4
3
22
B
A
4
F
3
Attach across rail and support legs to the base.
4
D
B
G
F
5
B
E
9
C
B
F
5
4
B
E
G
9
4
Align the pins on the Holders to the holes along the Centre Rail
and the Siderails. Gently tap them into the holes using hand palm.
6
8
7
5
Retightening of all fixing periodically is recommended.
When moving your fully assembled bed you must first remove the mattress and
lift the frame into position, take care when lifting and always have two people
handling the bed. PLEASE DO NOT DRAG THE BED as this will cause damage to
the rail.
It is advisable to use approved cleaning products when cleaning the furniture and
bed frame as certain chemical based cleaners could have an adverse effect on the
bed finish.
If any queries, please contact your seller.
">