Buyers Products Company 8891400 3.4 in. Amber LED Mini Strobe Light Installation Guide

8891400 SERIES

LED Mini Strobe

Surface Mount

To +VDC (fuse @ 3A)

TO Chassis Ground

For Synchronization

1. Connect YELLOW wires of all heads together for synchronization

(all heads must be set at the same pattern)

For Simultaneous or Alternating Flash

1. Apply +VDC to RED and YELLOW wires simultaneously to enter Grouping Mode; lighthead will display short

(single or double) flashers:

• Single flash = Group 1

• Double flash = Group 2

2. Remove YELLOW wire from +VDC and momentarily apply to +VDC to change Groups:

• Heads in the same Group flash together.

• Group 1 Heads alternate with Group 2 Heads

For Flash Patterns

1. Momentarrily apply

+VDC to YELLOW wire:

• Once for next pattern

• Quickly three times for pattern Zero

Note: Flash Pattern is preset to #0 Quint Flash

0

1

3

5

# FLASH PATTERN

Quint

8 Flash

2 Single-Quad

Single H/L

4 Single-Triple-Quint

Random

#

6

7

8

9

10

11

FLASH PATTERN

Steady

Single

Mega

Double

Triple

Quad

8891400SERIESINST_B

8891400 SERIES

LED Mini Strobe

Adhesive Mount

1. Select mounting location and clean surface

2. Peel one side of adhesive and apply to lighthead base

3. Peel other side of adhesive and secure lighthead firmly to the mounting surface

Note: Optimum adhesive strength is achieved after 24 hours.

Screw Mount

1. Select mounting location.

2. Mark and drill mounting holes.

3. Secure lighthead to mounting surface with supplied screws.

Bracket Mount

1. Select mounting location.

2. Place rubber pad to bottom of lighthead base

3. Place lighthead to the mounting surface.

4. Align top holes of bracket onto the lighthead base alignment points.

5. Secure lighthead with supplied screws from the bottom ofthe bracket

8891400SERIESINST_B