CRYSTEBRAMA
LIGHTING THE WAY FOR SIXTY YEARS
ASSEMBLY INSTRUCTION MODEL #HAY-1407-PN
There is a safety cable supplied with this fixture, as it weighs
over 50lbs. The fixture should be mounted to the ceiling
independent of the outlet box.
/ N
/ ii К
AMI :
ANA
\ pl y
B
\ 4
28"
DETAILED ILLUSTRATION
400
223
B C
SY i N SY iA N
N
y
a 1]
h N mM
= x
1 A
N
Y и A
N Short end above frame
20.5"
4 WARNING: à
©
\ Electrical Danger Turn Power Off /
All electrical components must be
installed by a licensed electrician
in accordance with the National
Electric Code and the appropriate
local electrical codes.
C
You will need 16-Candelabra Base Bulb
40 Watts Recommended 60 Watts Max
USE LED BULBS FOR EXTENDED USE
This fixture is Dry rated
How to Install
1.
2.
Do a complete inventory of all parts and components
before you start installing.
Screw the threaded pipe into the coupler and slide the
metal tube over the threaded pipe. Slide check ring over
the top of metal tube and secure with fixture loop.
. After safety attaching fixture into outlet box, install
bulbs (not included) and proceed to connecting the power.
. When you begin to dress the fixture, start with crystal
labeled (A).
. IMPORTANT: Apply crystal sets in alphabetical order.
Installation of Safety Cable
1.
Pass the long threaded pipe on the hickey through the
center of outlet box.Attach it to the ceiling joist and secure
it with nuts.
. Feed wires and safety cable up through chain and the hole
of screw collar loop. Have the wires and safety cable exit
through the side of hickey.
. Feed safety cable through the cable lock and coil it around
the hickey twice. Then Feed the cable through the lock
again and tighten it with lock screw.
. Continue to run safety cable through the top of outlet box
and secure it to the ceiling joist.
0
Crystal Sets
24Sets. (1)30x400mm
. 40Sets. (1)30x300mm
. 56Sets. (1)30x200mm
IN WARNING: This product can expose you to Lead,
which is known to the State of California to cause cancer
and/or birth defects or reproductive harm. For more
information go to www.P65Warnings.ca.gov
CRYSTEBRAMA
LIGHTING THE WAY FOR SIXTY YEARS
PART NUMBER MODEL #HAY-1407-PN
Outlet box Part Number
Part Numbers
A(2xP4)
A. (2)-Wire Connector
B. (1)-Mounting Hardware
С. (1)-Canopy; w5"xh1.25" (XFB1405PNCANSIN)
D. (1)-Collar Ring
E. (1)-Collar Loop
Е. (1)-Chain; 72", 5mm (XFB1407PNCHA5MM)
G. (1)-Steel Wire
B H. (1)-Ground Wire
|. (1)-Fixture Loop
J. (1)-Metal Tube; 9.5", 19MM thickness
K. (1)-Threaded Pipe; 9.5", 16MM thickness
L. (1)-Check Ring
M. (1)-Metal Frame
PART BAG Г: Includes Parts A
PART BAG II: Includes Parts B,D,E
IN
\ı
N
y
y
A Y” STEELCHANNEL Y
M
y |
]
A
; >
FIXED
\ STUD )
8 5/8 "IP NIPPLE(A) N
= FLAT WASHER EX М SAFETY CABLE
! FLAT WASHER CHANNEL
Ll N Г — ——JOIST
в : IA SA)
D — tn O Ex} Ha
:
= à 2"x4"x12" caline
SUPPORT WIRING BOX(NOT INCLUDED)
LAG NS NO INCLUDED) ICKEY
i 5/8 "IP NIPPLE(B)
Car HEX NUT FIXTURE CANOPY
FIXTURE TOP LOOP AND COLLAR
Ne
">
