American Bicycle Security Company LA Hoop Rack Specifications and Assembly Instructions
Advertisement
Advertisement
LA Hoop Rack
Los Angeles approved bike rack (S-671-1)
American Bicycle Security Company
P.O. Box 7359
Ventura, CA 93006
Ph: (800) 245-3723 or (805) 933-3688
Fax: (805) 933-1865 www.ameribike.com
Email: [email protected]
LA Hoop
Internal
Chain
Capacity
Materials
Internal
Chain
Finishes
RAL 9005
RAL 6016
RAL 7011
RAL 3003
Installation
Methods
Space Use
& Setbacks
2 Bikes
2” schedule 40 pipe (2.375” OD)
Chain .38 X 86 Plain G30
ASTM A413 Proof Coil
Standard options: Galvanized
Or
Powder Coated
Flat Black RAL 9003 RAL 2004
RAL 6018
RAL 7042
RAL 3005
RAL 6005
RAL 9007
RAL 5005
RAL 1001
RAL 1023
RAL 5015
RAL 8014
Foot Mount – anchors on top of concrete
Wall Setbacks:
For racks set parallel to a wall:
Minimum: 24”
Recommended: 36”
For racks set perpendicular to a wall:
Minimum: 28”
Recommended: 42”
Distance Between Racks:
Minimum: 24”
Recommended: 36”
Street Setbacks:
Minimum: 24”
Recommended: 36”
Bright Yellow
Purple
Bronze
Also available without chain and lean bar (by request only)
Page 1 of 2
American Bicycle Security Company
P.O. Box 7359
Ventura, CA 93006
Ph: (800) 245-3723 or (805) 933-3688
Fax: (805) 933-1865 www.ameribike.com
Email: [email protected]
LA Hoop
Surface Mounted Installation
*Tools Needed for Installation
• Tape Measure
• Marker or Pencil
•
•
Masonry Drill Bit
Drill (Hammer drill recommended)
• Hammer
• Wrench 9/16”
• Level
1.
Mark holes
2.
Drill hole
3” Deep
Recommended Base materials:
Solid concrete is the best base material for installation. To ensure the proper anchors are shipped with your rack, ask your American Bicycle representative which anchor is appropriate for your application. Be sure nothing is underneath the base material that could be damaged by drilling.
Installation:
3/8” anchors are shipped with the rack. Place the rack in the desired location. Use a marker or pencil to outline the holes of the flange onto the base material. Drill the holes in accordance with the specifications shipped with the anchors. Make sure the holes are at least 3” away from any cracks in
3.
Use washers to level rack
4. the base material. Use washers to level rack if necessary. Tap in anchors and follow your specific anchor instructions provided with the rack. (Anchors will vary according to install surface)
Tamper Resistant Hardware
When using the special tamper resistant nuts, always set and first tighten the anchors. Once the rack is installed, replace two nuts from the bracket (opposite sides from each other) with the tamper resistant fastener.
DO NOT OVERTIGHTEN the tamper resistant nut.
Page 2 of 2
American Bicycle Security Company
P.O. Box 7359
Ventura, CA 93006
Ph: (800) 245-3723 or (805) 933-3688
Fax: (805) 933-1865 www.ameribike.com
Email: [email protected]

Public link updated
The public link to your chat has been updated.
Advertisement