.12

010 2 .a

rev 51 29 60 MK lip ne C

. d Pho ion mat oun nfor res nal i he itio ult t

add ons

for se c uide lea r g te: P

Use nO

P

ted (Quick Guide)

honE Cli

getting started (Quick Guide)

rESound PhonE CliP

Before you can use your resound Phone Clip it is necessary to: a. Charge your phone clip

B. Pair with your hearing instrument

C. Pair with your mobile phone d. Connect to your mobile phone

Consult your hearing healthcare professional to determine which, if any, of these procedures may have already been completed for you.

ound P

getting star

rES

A

ChargE Your rESound PhonE CliP

1. Plug one end of the charging cable into the phone clip.

2. Plug the other end of the charging cable into an electric wall outlet.

3. generally, charging is complete when the red Led indicator turns green. However, when charging for the first time allow it to charge for at least 3 hours, even if the

Led turns green before 3 hours have elapsed.

B

Pair with Your hEaring inStrumEnt

1. turn on your phone clip by squeezing the multifunction button for 1 second. a solid blue light will display for 4 seconds and then go dark once the phone clip is turned on.

2. Open the battery door on your hearing instruments .

b. Pair with Your hEaring inStrumEnt … continued

3. remove the cover from the phone clip.

4. Press the pairing button to put the phone clip in pairing mode for

30 seconds.

5. While in pairing mode, turn on the hearing instruments by closing the battery doors on both hearing instruments.

C. Pair with Your mobilE PhonE … continued

4. Locate the “Bluetooth” option in the mobile phone menu, and search for Bluetooth™ devices.

5. From a list of discovered

Bluetooth devices, select “Hearing aid

Phone.”

6. enter a passcode of

“0000” (four zeros) if prompted.

Tip: Ensure that the

Bluetooth feature is activated on your mobile phone.

NOTE: Select “Headset” if asked which Bluetooth service you wish to enable.

6. a melody of beeps will be heard in both hearing instruments once they successfully pair with the phone clip.

replace the cover on the phone clip once pairing is complete.

C

Pair with Your mobilE PhonE

1. turn off your phone clip by pressing and holding the multifunction button for about 3 seconds until the Led indicator flashes quickly 4 times and then goes dark.

2. turn on your mobile phone and place it next to the phone clip.

3. Press and hold the multifunction button on the phone clip for 7 seconds to activate pairing mode. a solid blue light will be displayed for approximately 6 seconds before blinking once. do not release the multifunction button until the light blinks. a solid blue light

will then remain lit for two minutes during which time the phone clip will be in pairing mode.

NOTE: if you should release the button before pairing mode has been activated, turn the phone clip off and start again.

D

ConnECt with Your mobilE PhonE

1. in most instances, the phone will ask you to confirm your intention to connect with the phone clip after successfully pairing.

2. if you have to manually connect:

3.

You are now ready to use your phone clip.

Locate a list of “Paired devices” in your phone’s Bluetooth” menu. From that list, highlight “Hearing aid

Phone” and select

“Connect.”

Tip: in most instances, a headset symbol on the main screen of your mobile phone will confirm that you have successfully connected.

HeLPFUL tiPs:

• Typically, pairing is a procedure that only needs to be conducted as part of the initial setup procedure and does not need to be repeated.

• You may need to repeat the connection procedure if the devices are turned off or moved out of range.

• On some phones you can configure “Automatic reconnection.” refer to the user guide of your mobile phone for instructions on how to do this.