Nags Head Hammocks Double deluxe swing Instructions
PDF
Download
Document
Advertisement
Advertisement
DOUBLE DELUXE SWING HARDWARE PACK I N ST R U C T I O N S (4) 4.5” Barrel Bolts (2) 4” Barrel Bolts (7) 5” Hex Bolts (8) 3.5” Hex Bolts (6) Barrel Nuts (1) Allen Wrench (15) Locknuts NOTE. Instructions not to scale. (30) Washers (2) Tree Hooks and chain sets SUGGESTED TOOLS CHAIN SET • CHAIN SETS: (2) Eye Bolts, nuts, and washers attached NOTE. Add chains after completeing assembly. • Rubber Mallet • Adjustable Wrench • Phillips Head Screwdriver ASSEMBLY LONG CHAIN FRONT SHORT CHAIN FRONT STEP 1. Align left arm with swing body. Insert 3.5” Hex Bolt through washer, arm and swing body. Secure using washer and lock nut, repeat this process for all 3 holes both left and right side. NOTE. do not tighten bolts until Step 4. 5.5” EYE BOLT 4” EYE BOLT Lock Nut 3.5” Hex Bolt ASSEMBLY STEP 2. Position an upright as shown and secure it with (2) 3.5” Hex bolts and a washer on each side of the material. Repeat for the other side. STEP 4. Place the center table in the frame as shown, use (3) 5” Hex bolts, a washer on each side of the material and a lock nut to secure the front and rear legs to the center frame. 4” Barrel Bolt Barrel Nut Lock Nut Lock Nut 5” Hex Bolt 3.5” Hex Bolt STEP 3. Attach front and rear table legs to the center table using (2) 5” Hex Bolts, a washer on each side of the material and a lock nut as shown. Note : Rear legs are longer than the front. STEP 5. Attach center upright with (2) 5” Hex Bolts with a washer on each side of the material and secure with a locknut. Lock Nut 5” Hex Bolt Lock Nut 5” Hex Bolt ASSEMBLY STEP 7. Attach long bolt of Chain Assembly in the hole on the top of the rollup, by first unscrewing the nut and removing 1 washer. Thread bolt with one washer through the frame and secure with washer and locknut. Repeat for the right side, then repeat for the front using holes in the frame as shown. Insert plastic drink holders. Make sure to tighten all bolts then hang the swing using the included tree hooks or two other properly installed hooks - spacing hooks approximately 50-54” apart. Enjoy your new Nag’s Head Deluxe Double Swing! STEP 6. Position rollup as shown and secure it with (4) 4.5” Barrel Bolts, starting with the center upright. 4.5” Barrel Bolt Barrel Nut 5.5” EYE BOLT 4” EYE BOLT Lock Nut Congratulations on purchasing this Original Nag’s Head Deluxe Double Swing. QUESTIONS REGARDING THIS PRODUCT? Call our customer service team, 252-295-0405. INSTALLATION - Get somebody to help you, some pieces are heavy and a second pair of hands is always helpful. Do not tighten bolts until the product is fully assembled. Some pieces are harder to fit in place and this will help. A hammer or rubber mallet is needed during assembly. Do not over-tighten the bolts or screws. Build your item close to where it will be used to eliminate difficulty in moving once completed. For a uniform look, face all nuts in the same direction. MAINTENANCE - Great care has been put into manufacturing this item. However, it is made of high density resin and some natural esthetic imperfections and dark spots are normal and should be expected. You can wash the wood and the rope using a hose and some bleach water. You can also brush the wood to help remove dirt. WARRANTY & RETURNS - Nags Head Hammocks products are guaranteed to be free of defects in both workmanship and material. Prolonged exposure to weather conditions including snow, rain, and humidity are not covered under the warranty, nor is damaged caused by normal wear, mildew, or improper care, including storage, maintenance, and assembly. If you are not satisfied with an item, return it unused in its original packaging for a complete refund or exchange. You can return it to any of our stores or to our warehouse, Nags Head hammocks, 305 Industrial Blvd., Greenville, NC 27834. Please include a copy of your receipt and your contact information. #5113NHR1 ">

Public link updated
The public link to your chat has been updated.
Advertisement