Comfort Zone CZ550 Series Quick Start Manual

Add to My manuals
4 Pages

The Comfort Zone CZ550 Series Electric Radiant Heater is a versatile and safe heating solution for indoor residential and office use. It features adjustable thermostat control allowing you to set the desired temperature, dual heat settings (750W and 1,500W) to quickly warm up the room or maintain comfort, and safety features like overheat protection and tip-over cutoff switch. The heater is built with an all-metal body and includes a convenient carry handle for easy maneuverability.

advertisement

Comfort Zone CZ550 Series Electric Radiant Heater Quick Start Manual | Manualzz
CZ550 Series
Electric Radiant Heater
Features:
• Adjustable Thermostat
• Dual Heat Settings:
Low: 750W
High: 1,500W (5,120 BTU)
• Front Mounted Control Panel
• Power Indicator Light
• Safety Overheat Protection
• Safety Tip-Over Cutoff Switch
• Convenient Carry Handle
• All Metal Body
• 120V AC / 60Hz / 12.5A
www.comfortzoneproducts.com
Save These Instructions
INTENDED USE:
This product is intended for indoor residential and office use only,
not for industrial or other commercial application. Use only with
electrical wiring that is in good working order and that meets
applicable codes and ordinances. This heater must be plugged
in to a 120V AC, 15 Amp (or larger) circuit. Do not plug anything
additional into the same circuit. If you have any questions
whether your wiring is adequate, consult a qualified electrician.
Risk of fire, overheating, malfunction, property damage, injury or
even death may result if not adhered to.
Use your heater only with a working smoke detector located in
the vicinity of your heater.
EAD & SAVE THESE
R
INSTRUCTIONS
WARNING: SHOCK HAZARD
Use your heater only in dry environments. This heater is
not intended for use in a bathroom, laundry area, or similar
locations, or near sinks, washing machines, swimming pools
or other sources of water. Never locate heater where it may fall
into a bathtub or other water receptacle. Do not use in damp
environments such as flooded basements.
While using your heater, you should follow the IMPORTANT
INSTRUCTIONS listed below. As part of those instructions, we
have used the word “WARNING” to indicate the level of hazard:
WARNING indicates a hazard which, if not avoided, could result
in injury or death.
WARNING: HOT SURFACES
IMPORTANT INSTRUCTIONS
Heater has hot and arcing or sparking parts inside. Do not use
near combustible materials or flammable gases or sources of
heat. DO NOT USE in areas where gasoline, paint or flammable
materials are used or stored. Keep combustible materials such
as furniture, pillows, bedding, papers, clothes and curtains at
least 3 feet (0.9 m) from the front of the heater and keep them
away from the sides and rear. To prevent a possible fire, do not
block air intakes or exhaust in any manner. Do not use on soft
surfaces, like a bed, where openings may become blocked. Do
not place the heater near a bed because objects such as pillows
or blankets can fall off the bed and be ignited by the heater.
Do not insert or allow foreign objects to enter any ventilation or
exhaust opening as this may cause an electric shock, fire, or
damage the heater.
When using electrical appliances, basic safety precautions should always
be followed to reduce the risk of fire, electric shock and injury to persons,
including the following:
• Read all the instructions before using this heater.
• This heater is hot when in use. To avoid burns, do not let bare skin
touch hot surfaces. Use provided handle when moving this heater.
Keep combustible materials, such as furniture, pillows, bedding, papers,
clothes and curtains at least 3 feet (0.9 meters) from the front of the
heater and keep them away from the sides and rear.
• Do not use heater unattended. Use of extreme caution is necessary
when any heater is used by or near children, invalids, disabled persons
or pets.
• Do not operate the heater with a damaged power cord or after the
heater malfunctions, has been dropped or damaged in any manner.
Return heater to authorized service facility for examination, electrical
or mechanical adjustment or repair.
• Do not use heater outdoors.
• Use your heater only in dry environments. This heater is not intended
for use in a bathroom, laundry area, or similar locations, or near sinks,
washing machines, swimming pools or other sources of water. Never
locate heater where it may fall into a bathtub or other water container.
Do not use in damp environments such as flooded basements.
• Do not place the heater on a small, unlevel, uneven or any surface which
might allow heater to tip or fall.
• For proper operation, heater should be placed on a smooth,
non‑combustible, level surface. Do not place on rugs, carpet, vinyl
flooring or other plastic surfaces. Not for use outdoors or in wet areas.
• This heater is not designed as a primary heat source.
• Always plug heaters directly into a wall outlet/receptacle. Never use with
an extension cord or relocatable power tap (outlet/power strip). Always
unplug heater when not in use.
• Do not run power cord under carpeting. Do not cover cord with throw
rugs, runners or similar coverings. Arrange cord away from traffic area
where it will not be tripped over.
• To disconnect heater, turn controls off then remove plug from outlet.
• Do not insert or allow foreign objects to enter any ventilation or exhaust
opening as this may cause an electric shock or fire or damage the heater.
• To prevent a possible fire, do not block air intakes or exhaust in any
manner. Do not use on soft surfaces like a bed, where openings may
become blocked.
• A heater has hot and arcing or sparking parts inside. Do not use it in
areas where gasoline, paint or flammable liquids are used or stored.
• Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock
or injury to persons or property.
22
Do not touch body of heater when in use. This heater is hot when
in use, to avoid burns, do not let bare skin touch hot surfaces. If
provided, use handles when moving this heater.
WARNING: FIRE HAZARD
WARNING: ELECTRICAL SHOCK HAZARD
Do not use with damaged cord or plug. Use with adequate
electrical system that is up to code.
CAUTION: TO PREVENT ELECTRIC SHOCK
This product has a polarized two prong plug (one blade is
wider than the other) that must be fully inserted into a matching
properly grounded outlet. This plug is designed to fit a polarized
outlet only one way. If the plug does not fit fully into the outlet,
reverse the plug. If the plug still does not fit, contact a qualified
electrician. Do not attempt to defeat this safety feature.
Do not operate any heater with a damaged cord or plug or after
heater malfunctions, has been dropped or damaged in any
manner. Do not operate heater with a broken heating element
or ceramic cone or any visual imperfections. Disconnect power
before servicing. For repairs covered under warranty, see
warranty statement. For all other repairs contact Comfort Zone®
Customer Service by telephone or mail for information and
assistance.
PET OWNERS NOTE:
The health of birds and some small pets are extremely
sensitive to the fumes given off during the initial use of many
appliances. Although these fumes are not harmful to humans, it
is recommended that this heater not be used around birds and
small pets during its initial use until the manufacturing corrosion
coatings burn off.
USAGE:
HEATER OPERATION: Always operate the heater in the upright
position following all instructions and recommendations listed
in this manual.
HEATER LOCATION: Place the heater in the area of the room
that is coldest.
HEATER CONNECTION: Plug heater directly into 120 Volt AC,
60Hz wall outlet. Be sure plug fits tightly in outlet. A loose
connection may cause overheating and damage to the plug
or heater.
NOTE: To prevent overloading a circuit, do not plug the heater
into a circuit that is servicing other electrical needs.
POWER INDICATOR LIGHT: The Power Indicator Light will
illuminate when the heater is turned on.
ASSEMBLY INSTRUCTIONS: This heater is p
ackaged with the
legs unassembled. The legs must be attached before operating
the heater. Please notice the arrow on each base leg. It shows
the installation direction to the front of the heater. Insert the
protrusions on the leg into the notches on the bottom of the
heater. Once inserted, push base leg towards heater front until
it stops. Use supplied screw to secure leg. Repeat steps for
second leg.
Heater Leg
Protrusions
TURNING HEATER ON: To start the heater, turn the ON/OFF
Switch from the OFF position to the ON (I / II) position.
Then rotate the Thermostat Control clockwise to the HIGH
THERMOSTAT position as described below. (During the heaters
initial use, you may experience a slight odor or smoking.
This is the result of the heating element lubrication “burning off”.
This is normal and will go away after a few minutes of use.)
Heater Front
Heater Leg
Notches
ON/OFF
Switch
Two Heat
Settings:
750W/1,500W
Push Base Leg
owards Heater
T
Front Until It Stops
Use Supplied
Screws to
Secure Legs
IMPORTANT SAFETY FEATURES:
Adjustable
Thermostat
Power
Indicator
Light
The Power Indicator Light, located below the t hermostat switch,
lights whenever the heater is turned on. The heater is equipped
with an automatic overheat protection device located inside
the body of the heater. If the heater grille is obstructed, or if
the heater gets too hot for any reason, the automatic overheat
protection device will turn the heater off. To reset the heater,
simply turn power off and unplug the heater for 10 minutes until
it cools down and restart. Be sure that the heater is on a smooth
level surface with no obstructions.
POWER LEVEL SWITCH: This heater has two heat settings:
750W and 1,500W. Use the higher setting (1,500W) to raise
the room temperature quickly. When the desired temperature
is reached use the lower 750W setting. It is usually sufficient
to m
aintain a comfortable temperature.
SETTING THERMOSTAT: After heater has been turned on and
the room has reached the desired temperature, slowly rotate
the thermostat knob counter-clockwise until the heater shuts
off (you should hear a faint “click”). By leaving the thermostat
at this setting it will automatically maintain this temperature.
To lower temperature, rotate the knob further counter-clockwise
(towards the LOW position). To raise the temperature, rotate the
thermostat knob clockwise (towards the HIGH position).
TURNING OFF: Turn the ON/OFF Switch to the OFF position
before unplugging or plugging in the heater. Heater should be
unplugged when not in use.
33
CARE AND MAINTENANCE:
LIMITED WARRANTY
WARNING: ALWAYS UNPLUG THE CORD BEFORE
MOVING OR SERVICING. Do not use harsh chemical
or abrasive cleaners. DO NOT IMMERSE THE HEATER
IN WATER. Allow heater to dry completely before use.
This unit is guaranteed to the original retail purchaser
against defects in quality or workmanship for a period
of one year from the date of original purchase. If this unit
fails because of a manufacturing defect within 30 days
of purchase, return the unit, with your receipt, to the
retailer. After 30 days, but within the warranty period, if the
unit was purchased within the continental United States,
return it, freight prepaid, to World and Main for repair
or replacement. If the unit was purchased outside the
continental United States, return the unit to the place of
purchase. This warranty does not cover damage caused
by misuse, abuse, overheating or alteration. Repairs made
by anyone other than World and Main are not covered in
this warranty. World and Main will not be held liable for any
losses due to neglectful operation. All implied warranties,
including the warranties of merchantability and of fitness
of purpose, if applicable, are hereby limited in duration
to the period of one year from the date of original retail
purchase. Some states do not allow limitations on how
long an implied warranty lasts, so the above limitations
may not apply to you. Incidental or consequential
damages arising from a breach of either express or implied
warranties are hereby disclaimed and excluded. Some
states do not allow the exclusion of limitation of incidental
or consequential damages, so this limitation or exclusion
may not apply to you. Upon the expiration of this warranty
all such liability will terminate. No other warranties are
expressed or implied.
CLEANING: IMPORTANT! DO NOT IMMERSE HEATER
IN WATER! Clean the heater grille with the vacuum brush
attachment on your vacuum cleaner. This will remove
lint and dirt from inside the heater. DO NOT ATTEMPT
TO TAKE APART THE HEATER. DO NOT REMOVE THE
HEATER GRILLE. Clean the body of the heater with a
soft cloth.
CAUTION: Do not use gasoline, benzene, paint thinner,
harsh cleaners, etc. as they will damage the heater.
NEVER USE ALCOHOL OR SOLVENTS.
REPAIR: DO NOT OPERATE THE HEATER WITHOUT THE
GRILLE IN PLACE. DO NOT USE THE HEATER IF IT HAS
MALFUNCTIONED OR BECOME DAMAGED IN ANY WAY.
STORAGE: Keep original carton for storage of the heater.
Coil and tie the power cord to avoid damage during storage.
This warranty gives you specific legal rights, and you
may also have other rights which vary from state to state.
No informal dispute settlement mechanisms are available.
This limited warranty is given in lieu of all other warranties.
Manufactured for:
World and Main (Cranbury), LLC
324A Half Acre Rd.
Cranbury, NJ 08512 USA
800-221-6895
www.comfortzoneproducts.com
Rev. 06/07/2022
44

advertisement

Key Features

  • Adjustable Thermostat
  • Dual Heat Settings
  • Safety Overheat Protection
  • Tip-Over Cutoff Switch
  • All Metal Body
  • Carry Handle
  • Power Indicator Light

Related manuals

Frequently Answers and Questions

Can I use the CZ550 Series heater in a bathroom?
No, this heater is not intended for use in bathrooms or other wet locations.
How do I clean the heater?
Use the vacuum brush attachment to clean the grille. Clean the body with a soft cloth. Do not immerse the heater in water.
What should I do if the heater overheats?
The heater has an overheat protection device. If it overheats, the heater will turn off automatically. Unplug the heater and allow it to cool down for 10 minutes before restarting. Ensure the heater is on a smooth, level surface with no obstructions.
Download PDF

advertisement