USER MANUAL

USER MANUAL
STERILIZER & AIR CLEANER
USER MANUAL
Model No.: AC-2127H
READ AND SAVE
THESE IMPORTANT INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed to
reduce the risk of fire, electric shock and injury to persons, including the following:
1. Read all instructions before using the appliance.
2. To avoid fire or shock hazard, plug the appliance into an exact electrical outlet.
3. Keep the cord out of heavy traffic areas. To avoid fire hazard, NEVER put the cord
under rugs, near heat registers, radiator, stoves, or heaters.
4. To protect against electrical hazards, DO NOT immerse in water or other liquids. Do
not use near water.
5. Close supervision is necessary when any appliance is used by or near children, or
by disabled people. Children should be supervised to ensure that they do not play
with the appliance.
6. Always unplug the air purifier before moving it, opening the grill, changing filters,
cleaning, or whenever the air purifier is not in use. Be sure to pull by the plug and
not the cord.
7. NEVER drop or insert any object into any openings.
8. DO NOT operate any appliance with a damaged cord or plug, if motor fan fails to
rotate, after the appliance malfunctions, or if it has been dropped or damaged in
any manner. Return appliance to manufacturer for examination, electrical or
mechanical adjustment, or repair.
9. Use appliance only for intended household use as described in this manual. Any
other use not recommended by the manufacturer may cause fire, electric shock,
or injury to persons.
10. DO NOT use outdoors.
11. NEVER block the air openings, grilles/outlets or place on a soft surface such as a
bed or sofa, as this could cause the unit to tip over, blocking the air Intake or
outtake opening.
12. Keep unit away from heated surfaces and open flames.
13. DO NOT attempt to repair or adjust any electrical or mechanical functions on
this unit. Doing so will void your warranty. The inside of the unit contains no user
serviceable parts. All servicing should be performed by qualified personnel only.
14. WARNING: To reduce the risk of fire or electric shock, DO NOT use this air purifier
with any solid-state speed control device.
15. DO NOT place anything on top of unit.
-1-
PRE-OPERATING INSTRUCTIONS
1. Carefully remove your air purifier from the gift box and the bag.
2. Select a firm level and flat location. For proper air flow, locate the unit at least 3
feet (1 M) from any wall or furniture. Ensure no grilles are blocked.
3. Plug the power cord into a 220-240V AC outlet.
4. Always lift your air purifier by the handle of the unit.
OPERATING INSTRUCTIONS
The air purifier may be operated by the manual controls located on the air purifier (as
shown in Figure 1) or by your remote control (shown in Figure 3).
-2-
Figure 1
1. When the air purifier is initially plugged in, the buzzer will come on a “beep” voice
indicating that there is power to the unit.
2. Turn the air purifier on by pressing On/Off Button (
) and the red indicator will
lit until pressing On/Off Button ( ) again. (Figure 1)
3. Upon turning the air purifier on, the unit will be in the High mode.
4. Pressing Mode Button (
) at this point will set the air purifier into Low mode.
5. Pressing Mode Button (
) once more will set the air purifier back to High mode.
6. To turn the air purifier off, press the On/Off Button (
).
TIMER FUNCTION: This function will work in any mode. The timer function allows
you to set the length of operation from 1 hour (1H) to 8 hours (8H). Press Timer
Button ( ) to set your desired operation time. Once the timer has been set, the
timer indicator will lit and the timer will count down the hours, until the air purifier will
turn itself off. Pressing Timer Button ( ) once more after the timer indicator
reflects 8 hours (8H) will reset the air purifier to continuously running.
HEPA RESET FUNCTION: Over a period of time, the HEPA filter performance will
begin to decrease. At this point the HEPA filter need to be checked or replaced, HEPA
Filter Reset Indicator will illuminate and flicker, also the buzzer will come on a
“beep, beep” voice. After replacing the HEPA filter, RESET the HEPA Filter
-3Reset Indicator by pressing HEPA Filter Reset Button, then the indicator will
stop flickering and the buzzer will stop sounding. Pressing HEPA Filter Reset
Button at normal working statement, the air purifier will be no any operation but
only the buzzer comes on a “beep”.
OZONE FUNCTION: This function will work in any mode. Press Ozonizer Button,
the ozone will output from Ozone Outlet. Stop ozone output by pressing this button
once more.
Ozone can be used to purify water, clean fruits / meat / fish / shrimp / shellfish /
rice, wash dishware / face / hands / baby products and for shower, purify air, etc.
Use the air pipe supplied as Figure 2 to purify. Please note the unit must be put on
a location higher than water level of water container.
CAUTION --- If the ozone function is turned on in a non-ventilated room to sterilize
the air (not need to use air pipe supplied), enter the room after the unit stops working
for at least 30 minutes. It is recommended that operate the OZONE FUNCTION with
TIMER FUNCTION at the same time.
Figure 2
REMOTE CONTROL FUNCTION: All the functions performed with the Remote
Control work identically to the manual controls. (Figure 3)
1. Install two “AAA” batteries as shown in Figure 3.
2. Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries.
-4-
Figure 3
Figure 4
REMOVING/CLEANING/INSTALLING PRE-FILTERS (See Figure 4)
● To remove air inlet covers
1. Turn off and unplug the unit;
2. Press the spring buttons and take off the air inlet covers from the unit.
The pre-filters are attached on the air inlet covers.
(See Figure 4 and consult the indication of arrow)
● To clean pre-filters
1. Clean pre-filters with the vacuum brush attachment of your vacuum cleaner.
This will remove lint and dirt from the filter;
2. Use a clean, damp, soft cloth to wipe the pre-filters again.
-5-
● To install air inlet covers
1. Direct the air inlet covers bottom toward the hooks on the bottom-side of the unit;
2. Install the air inlet covers to the unit by gripping and pressing the spring buttons;
3. Ensure the air inlet covers are flush with the surrounding surface and securely
latch in place.
REMOVING/INSTALLING HEPA FILTERS (See Figure 4)
● To remove HEPA filters
1. Turn off and unplug the unit;
2. Press the spring buttons and take off the air inlet covers from the unit.
3. With the air inlet covers removed, remove the used HEPA filter and dispose of it in
the garbage. Do NOT try to wash and re-use the HEPA filter. Replace with a new
HEPA filter then insert it into the air purifier.
● To install air inlet covers
1. Direct the air inlet covers bottom toward the hooks on the bottom-side of the unit;
2. Install the air inlet covers to the unit by gripping and pressing the spring buttons;
3. Ensure the air inlet covers are flush with the surrounding surface and securely
latch in place.
Figure 5
WALL MOUNTING USAGE (See Figure 5)
The air purifier can be used by mounted on the wall.
1. Drilling two holes on the wall comply with a wall-mounted tool applied in the
gift box; then fix two screws into the holes;
-62. Direct the wall-mounted hooks on the rear of the air purifier to the screws then
fix on;
3. Plug the air purifier and use remote controller applied to start and stop it.
NOTE:
1. As mounting the air purifier, always unplug the unit.
2. As mounting the air purifier, the bottom of the unit MUST be 6 feet (1.8
meters) high from the ground of your room. (Refer to Figure 5)
CLEANING AND MAINTENANCE THE UNIT
1. The air purifier should be checked at least once every week and the pre-filter
should be cleaned every week. More frequent cleaning may be required depending
upon environmental conditions.
2. Clean the pre-filter as REMOVING/CLEANING/INSTALLING PRE-FILTERS.
3. When HEPA Filter Reset Indicator illuminates and flickers, check the HEPA filter as
REMOVING/INSTALLING HEPA FILTERS. If the HEPA filter turns white to grey
even black, replace it with a new one. If the HEPA filter is still white, please install
it back to unit and reset the HEPA RESET BUTTON.
4. Use a clean, dry, soft cloth to wipe the external surface of unit.
NOTE: Do not stick any foreign objects or your fingers inside the unit.
CAUTION: Do not use gasoline, benzine, thinner, harsh cleaners, etc., as
they will damage the product. NEVER use ALCOHOL OR SOLVENTS.
TROUBLE SHOOTING TIPS
If the air purifier shuts off unexpectedly, safety features may have been activated to
prevent damage or injury. If this happens:
1. Be sure the air purifier is plugged into a working electrical outlet;
2. Check to be sure the HEPA filter is firmly seated in place;
3. Check to be sure the air inlet covers are latched firmly in place.
NOTE: IF YOU CONTINUE TO EXPERIENCE A PROBLEM, PLEASE RETURN THE AIR
PURIFIER TO THE PLACE OF ORIGINAL PURCHASE OR SEE YOUR WARRANTY. DO
NOT ATTEMPT TO TAKE APART THE UNIT BY YOURSELF. DOING SO MAY
VOID YOUR WARRANTY AND CAUSE DAMAGE TO THE PRODUCT OR PERSONAL
INJURY.
-7-
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement