9 9 switch button 7

Specifications

。 Speaker :50mm

1.

M ode

2.

: volume down / last song

3.

+ : volume up / next song

4.

>

5. USB: Insert USB card disk.

6. TF (Micro SD): Insert TF (Micro SD) card.

7. On/Off button

8. Micro USB: Charge the Speaker note: Playback and charge times mentioned are approximate and based on earbuds and case being fully charged, and playback at 50% volume. Playback and charge times may vary and performance may be affected by multiple factors including but not limited to battery conditions, ambient temperature, listening volume. and/or distance from the source audio device.

Turn on the speaker and press M to select Bluetooth mode. Enable Bluetooth function on your device and search the Blutooth device named SPBT9. Click to connect (pair). After successful connection, you can play music or use the

Bluetooth phone functions.

TWS: True wireless

To pair this speaker with other SPBT9 speakers. Turn off Bluetooth on your phone or music devices. Turn on two SPBT9 speakers together at the same time, press

M together for 3 seconds and a prompt says bluetooth connected. After two speakers connected, switch on the bluetooth on your phone and SPBT9.

1.

Press button 1 to choose mode.

2. Next song / volume up : Press button 3

3. Previous song / volume reduction: Press button 2.

Hands Free

1. Press button 4 to answer when the call incoming, press it again to hang up.

TF Card and USB Card

Insert the TF card to port 6.

Insert USB to port 5.

Select the mode by pressing button 1.

(see mode selection)

Only MP3 files can be played. Memory cards cannot exceed 32GB to the chargling slot 8. It is charging if the LED indicator light up red, and the LED indicator goes off upon charging finished.

Do not charge near water

Near Water ; Keep Charging port 7 covered. Do not submerge into water.

Supplier's Declaration of Conformity

(47 CFR Part 15.21, 15.105(b) Compliance Information )

2A CP4-SPBT9

Sentry Bluetooth speaker

9

Responsible Party –

Sentry Industries inc

One Bridge street, Hillburn, NY 10931

Tel +1 845 753 2910

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

"NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment."

and may use of such marks by Sentry

Industires Inc is under license. Other trademarks and trade names are those of their respective owners

SPBT 9