9382 Wooden Doll High Chair
Assembly Instructions
This doll chair is not
intended for child seating.
Use only for toy dolls.
! WARNING:
Adult assembly required.
We care about your comments. Please call us!
1-800-284-3948
www.MelissaAndDoug.com
c 2013 Melissa & Doug, LLC, P.O. Box 590, Westport, CT 06881
Item # 9382
! WARNING:
CHOKING HAZARD- Small parts.
Not for children under 3 years.
9382 Wooden Doll High Chair
PARTS
(B) 1 piece
(A) 1 piece
(D) 1 piece
(C) 1 piece
(E) 2 pieces
(H) 1 piece
(F) 1 piece
(G) 1 piece
HARDWARE
(Shown Actual Size)
Hex Head Screw
12 pieces
Barrel Nut
6 pieces
Hex Key
1 piece
9382 Wooden Doll High Chair
How to correctly install
Barrel Nuts
(Images on this page are
for example only.)
Press a Barrel Nut into the hole in the
part making sure that the "+" pattern
is facing out.
"+" pattern
Using a standard screwdriver, turn
the Barrel Nut until the threaded hole is facing
outward to accept the screw shown below.
Threaded hole
of the Barrel Nut
STEP 1
9382 Wooden Doll High Chair
A
Attach seat(A) to front legs(B)
with 2 Hex Head Screws.
Hex Head
Screws
Make sure the legs are facing
the correct direction, noted
below.
B
NOTE: The longer side
of the foot support should
be facing out.
Assembled Step
STEP 2
Attach the armrests(C & D) as
shown using 2 Barrel Nuts and then
2 Hex Head Screws as shown.
C
D
Refer to the instructions about
how to properly install Barrel Nuts.
Barrel Nuts
Hex Head
Screws
Assembled Step
Hex Head
Screws
9382 Wooden Doll High Chair
STEP 3
E
Hex Head Screws
Attach 2 spindles(E) as shown
using 2 Hex Head Screws.
Assembled Step
STEP 4
F
Hex Head
Screws
Attach the Back(F) to the Seat
and Armrests as shown using 2
Barrel Nuts first, then 2 Hex Head
Screws as shown.
NOTE: The direction of the
slanted edge on the Back(F)
Barrel Nuts
Assembled Step
9382 Wooden Doll High Chair
STEP 5
G
Hex Head Screws
4 pieces needed
Attach the Rear Legs(G) as
shown using 2 Barrel Nuts first
then 4 Hex Head Screws.
Note: The Spindles already have
threaded inserts.
NOTE: The slanted edge on the
Rear Legs(G) should match the
slanted edge of the Back(F).
Barrel Nuts
2 pieces needed
Assembled Step
STEP 6
H
NOTE: Slide on
with curve side out
Finally, slide on the Tray(H) as
shown. The Tray has a bump on
the bottom to keep it in place.
Removing or inserting the Tray
may require a slight lifting to
fit over the bump.
Enjoy your completed
Wood Doll High Chair.
Assembled Step
">
