Desktop Time Clock Owner`s Manual
Desktop Time Clock Owner’s Manual
Rev 2.04
Thank you for purchasing the ControlSCAPE Desktop Time Clock, the only 100% reliable, 100% guaranteed landscape
lighting controller in the world. Please follow the simple instructions below to operate your landscape lighting. Enjoy!
Basic Operation
Once the ControlSCAPE Desktop Time
Clock has been set-up it will automatically
control the landscape lighting according
to the timers (actual time or sunrise/sunset)
enabled during initial installation. However,
the Desktop Time Clock still acts as a manual switching device for the landscape
lights that are on the system. Simply press
the buttons labeled 1 thru 4 to toggle the
first four landscape lighting loads on and
off. To gain control of loads 4 thru 8 press
the Next/Set button. To revert to loads 1
thru 4 press the Next/Set button again.
Lansdcape Lighting Loads
Load 1:____________________________________
Load 5:____________________________________
Load 2:____________________________________
Load 6:____________________________________
Load 3:____________________________________
Load 7:____________________________________
Load 4:____________________________________
Load 8:____________________________________
Timer Settings
Timer 1
Timer 2
Timer 3
Timer 4
Action is: ON OFF
Runs at: TIME ________
Effects Loads: 1 2 3
Action is: ON OFF
Runs at: TIME ________
Effects Loads: 1 2 3
Action is: ON OFF
Runs at: TIME ________
Effects Loads: 1 2 3
Action is: ON OFF
Runs at: TIME ________
Effects Loads: 1 2 3
DAWN ________ DUSK ________ NEVER ________
4 5 6 7 8
DAWN ________ DUSK ________ NEVER ________
4 5 6 7 8
DAWN ________ DUSK ________ NEVER ________
4 5 6 7 8
DAWN ________ DUSK ________ NEVER ________
4 5 6 7 8
Desktop Time Clock Owner’s Manual
Changing Timers
Enter Programming Mode
Press and hole the Next/Set button for up to 3 seconds until you see “Set
Time/Date?”
Select Next/Set to skip.
Select Next/Set to skip.
Select Next/Set to skip.
Select Next/Set to skip.
Select YES to set up the 4 internal clock timers. Select Next/Set to skip. Note
that current information about these timers is on Page 1 of this manual.
Select YES to setup Timer #1. Select NO to skip Timer #1 and move on
to the next Timer.
Select ON to have this Timer turn the devices selected in the next 3
steps ON when Timer activated. Select OFF to have this Timer turn
the devices selected in the next 3 steps OFF when Timer activates.
Select TIME to activate Timer at the same time each day. Select
DAWN to activate timer based on the Sunrise. Select DUSK to activate
this timer On based on the Sunset. Select NEVER for no activation.
TIME
Use the - and + buttons to select the Timer activation Hour (based
on 24 hour military time). Press SET when finished.
Use the - and + buttons to select the Timer activation Minute.
Press SET when finished.
DAWN
Use the - and + buttons to select the Timer activation Dawn Offset
(number of minutes before or after sunrise). The Offset can be up
to - or + 128 minutes. Press SET when finished.
DUSK
Use the - and + buttons to select the Timer activation Dusk Offset
(number of minutes before or after sunset). The Offset can be up
to - or + 128 minutes. Press SET when finished.
Use the arrows to select devices 1 - 8. Press ADD to add selected
device to Timer. Press DEL to remove selected device from timer.
NOTE: Highlighted devices will turn ON with an ON Timer and OFF with
an OFF timer. Press SET when finished.
Complete above step for all 4 Timers.
Select YES to view all settings made during previous steps. Use Next/Set to
scroll through settings. Select Next/Set to skip.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement