Aurora ASP-12H-4K User guide

Aurora ASP-12H-4K User guide
USERS GUIDE
ASP-12H-4K
HDMI 4K2K 1x2 Splitter with EDID Management
i
Manual Number: 141110
User Guide
SAFETY INSTRUCTIONS
Please review the following safety precautions. If this is the first time using this model, then read this manual
before installing or using the product. If the product is not functioning properly, please contact your local
dealer or Aurora for further instructions.
The lightning symbol in the triangle is used to alert you to the presence of dangerous voltage
inside the product that may be sufficient to constitute a risk of electric shock to anyone opening
the case. It is also used to indicate improper installation or handling of the product that could
damage the electrical system in the product or in other equipment attached to the product.
The exclamation point in the triangle is used to alert you to important operating and maintenance
instructions. Failure to follow these instructions could result in injury to you or damage to the
product.
Be careful with electricity:











Power outlet: To prevent electric shock, be sure the electrical plug used on the product power cord
matches the electrical outlet used to supply power to the Aurora product. Use only the power adapter
and power connection cables designed for this unit.
Power cord: Be sure the power cord is routed so that it will not be stepped on or pinched by heavy
items.
Lightning: For protection from lightning or when the product is left unattended for a long period,
disconnect it from the power source.
.
Also follow these precautions:
Ventilation: Do not block the ventilation slots if applicable on the product or place any heavy object on
top of it.
Blocking the air flow could cause damage. Arrange components so that air can flow freely. Ensure that
there is adequate ventilation if the product is placed in a stand or cabinet. Put the product in a properly
ventilated area, away from direct sunlight or any source of heat.
Overheating: Avoid stacking the Aurora product on top of a hot component such as a power amplifier.
Risk of Fire: Do not place unit on top of any easily combustible material, such as carpet or fabric.
Proper Connections: Be sure all cables and equipment are connected to the unit as described in this
manual.
Object Entry: To avoid electric shock, never stick anything in the slots on the case or remove the cover.
Water Exposure: To reduce the risk of fire or electric shock, do not expose to rain or moisture.
Cleaning: Do not use liquid or aerosol cleaners to clean this unit. Always unplug the power to the
device before cleaning.
ESD: Handle this unit with proper ESD care. Failure to do so can result in failure.
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interferences received, including interference that may cause undesired
operation.
Trademarks
All trademarks in this document are the properties of their respective owners.
i
User Guide
TABLE OF CONTENTS
PACKAGE CONTENTS .............................................................................................................1
INTRODUCTION ........................................................................................................................2
About ..................................................................................................................................................... 2
Features ................................................................................................................................................ 2
Front & Rear Panel ASP-12H-4K.......................................................................................................... 3
Connection Diagram ............................................................................................................................. 4
CONNECTOR PIN DEFINITION ................................................................................................5
HDMI ..................................................................................................................................................... 5
APPENDIX 1
Troubleshooting .............................................................................................6
APPENDIX 2
Technical Specifications................................................................................7
APPENDIX 4
Warranty .........................................................................................................8
ii
User Guide
PACKAGE CONTENTS
Please make sure the following items are included within your package. Contact your dealer if any items
are missing or damaged.

ASP-12H-4K x 1

5V 2A DC Power Wall Adapter x 1

User Manual x 1
Note: Go to www.auroramultimedia.com for latest manual and firmware
1
User Guide
INTRODUCTION
About
The ASP-12H-4K 1x2 HDMI 4K2K Splitter with EDID Management provides one of the most
advanced HDMI splitter solutions by which the Ultra High Definition video and high quality audio
can be transmitted to multiple locations without losing quality. The ASP-12H-4K supports all 3D
formats and true 4K2K video.
The ASP-12H-4K firmware upgrade capability via the USB port ensures compatibility now and in
the future. With 48 bit deep color video and high definition audio support the ASP-12H-4K is
suitable for high quality HDMI broadcasting, conference room, digital signage and education
applications.
Features
 Supports HDMI Deep Color & 3D / DVI 1.0 compliant
 HDCP 1.3 compliant
 Wide frequency range: 25MHz~340MHz
 Video bandwidth: 10.2Gbps
 Resolution up to 4K2K @ 30Hz
 Supports default EDID and has ability to learn the EDID of displays
 Supports xvYCC, x.v.Color & Deep Color
 Mini-USB port for firmware updating
 Supports Dolby Digital, DTS-HD and Dolby TrueHD audio
 Connectors on same side for easy installation
* Refer to Technical Specifications Section.
2
User Guide
Front & Rear Panel ASP-12H-4K
1. Signal LED: Signal LED indicator
2. Power LED: Lights on when device is ready
3. HDMI IN: Connect to a HDMI input source
4. HDMI OUT1-2: HDMI outputs to HDMI displays
[HDMI OUT1: EDID Learn Default]
5. Mini-USB: For technical support only [firmware update]
6. MODE:
0 - F/W update mode
1 - EDID Full-HD ([email protected]) - 24bit 2D video & 7.1ch audio
2 - EDID Full-HD ([email protected]) - 24bit 2D video & 2ch audio
3 - EDID Ultra-HD ([email protected]) - 24bit 2D video & 7.1ch audio
4 - EDID Ultra-HD ([email protected]) - 24bit 2D video & 2ch audio
5 - EDID HD ([email protected]) ([email protected])([email protected]) - 24bit 2D video & 2ch audio
6 - Auto EDID analysis learning mode
7 - EDID learning mode
7. +5V DC: Connect to the +5V DC 2A power supply unit
Note: Automatic EDID learning will detect all the connected HDMI equipped monitors and
analyze all the content of EDID. The EDID with lowest resolution support will be the
reference EDID for incoming HDMI source players.
If connecting a new monitor to the splitter under mode 6 (auto EDID) & mode 7 (EDID
3
User Guide
learning), experiencing a short period of time without display should be expected. The
splitter will do Automatic EDID learning which analyzes the newly connected monitor to see
if the EDID for the HDMI input is necessary to update.
Connection Diagram
4
User Guide
CONNECTOR PIN DEFINITION
HDMI
Pin 1 TMDS Data2+
Pin 8
TMDS Data0 Shield
Pin 15
SCL
Pin 2 TMDS Data2 Shield
Pin 9
TMDS Data0–
Pin 16
SDA
Pin 3 TMDS Data2–
Pin 10
TMDS Clock+
Pin 17
DDC/CEC Ground
Pin 4 TMDS Data1+
Pin 11
TMDS Clock Shield
Pin 18
+5 V Power
Pin 5 TMDS Data1 Shield
Pin 12
TMDS Clock–
Pin 19
Hot Plug Detect
Pin 6 TMDS Data1–
Pin 13
CEC
Pin 7 TMDS Data0+
Pin 14
Reserved (N.C. on device)
5
User Guide
APPENDIX 1
Troubleshooting
Problem
1. No Video Signal.
2. LED is not lit
3. EDID did not take
Solution
a. Check that the power plug is properly inserted into a functioning power
outlet.
b. Make certain source is on.
c. Make certain destination is on
d. Check EDID setup
a. Check 5v power supply is plugged in.
b. Check to see if Wall supply is plugged into wall outlet.
c. Make certain wall outlet has power.
a. Recycle power to source device or unplug and reinstall cable for
source device to retrieve latest EDID
6
User Guide
APPENDIX 2
Technical Specifications
Model Name
ASP-12H-4K
Technical
HDMI/DVI compliance
HDMI Deep Color, full 3D & 4K2K/ DVI 1.0
HDCP compliance
Video bandwidth
HDCP 1.3
Single-link 340MHz [10.2Gbps]
Video support
Up to 4K2K @30
HDMI Output Distance
720p 12bit up to 20m, 1080i 12bit up to 20m, 1080p 12bit up to 15m, 4K up to 7.5m
(Note: Cable quality may impact distance)
DTS-HD Master Audio, Dolby TrueHD Dolby Digital,
DTS, DVD-Audio, LPCM, SACD, MPCM
Audio support
[1] Human body model — ±19kV [air-gap discharge] & ±12kV [contact discharge]
[2] Core chipset — ±2kV
ESD protection
Firmware update
Mini-USB port
Input
1x HDMI [7.1ch audio & video]
Output
2x HDMI [7.1ch audio & video]
HDMI connector
Type A [19-pin female]
Rotary control switch
EDID Mode selection
Mechanical
Housing
Dimensions
[L x W x H]
Weight
Metal enclosure
Model
Package
113 x 62.5 x 25mm [4.45" x 2.46" x .984"]
198 x 137x 74mm [7.8" x 5.39" x 2.91"]
Model
463g [16.3 oz]
Package
946g [1.0 lbs]
Mounting
Integrated ears
Power supply
5V 2A DC
Power consumption
10 Watts [max]
Operation temperature
0~40°C [32~104°F]
Storage temperature
-20~60°C [-4~140°F]
Relative humidity
20~90% RH [no condensation]
Specifications subject to change without notice.
7
User Guide
APPENDIX 4
Warranty
Limited 3 Year Warranty
Aurora Multimedia Corp. (“Manufacturer”) warrants that this product is free of defects in both materials and
workmanship for a period of 3 years as defined herein for parts and labor from date of purchase. This Limited Warranty
covers products purchased in the year of 2009 and after. Motorized mechanical parts (Hard Drives, DVD, etc),
mechanical parts (buttons, doors, etc), remotes and cables are covered for a period of 1 year. Touch screen displays
are covered for 1 year; touch screen overlay components are covered for 90 days. Supplied batteries are not covered
by this warranty. During the warranty period, and upon proof of purchase, the product will be repaired or replaced (with
same or similar model) at our option without charge for parts or labor for the specified product lifetime warranty period.
This warranty shall not apply if any of the following:
A. The product has been damaged by negligence, accident, lightning, water, act-of-God or mishandling; or,
B. The product has not been operated in accordance with procedures specified in operating instructions: or,
C. The product has been repaired and or altered by other than manufacturer or authorized service center; or,
D. The product's original serial number has been modified or removed: or,
E. External equipment other than supplied by manufacturer, in determination of manufacturer, shall have
affected the performance, safety or reliability of the product.
F. Part(s) are no longer available for product.
In the event that the product needs repair or replacement during the specified warranty period, product should be
shipped back to Manufacturer at Purchaser's expense. Repaired or replaced product shall be returned to Purchaser
by standard shipping methods at Manufacturer's discretion. Express shipping will be at the expense of the Purchaser.
If Purchaser resides outside the contiguous US, return shipping shall be at Purchaser's expense.
No other warranty, express or implied other than Manufacturer's shall apply.
Manufacturer does not assume any responsibility for consequential damages, expenses or loss of revenue or property,
inconvenience or interruption in operation experienced by the customer due to a malfunction of the purchased
equipment. No warranty service performed on any product shall extend the applicable warranty period. This warranty
does not cover damage to the equipment during shipping and Manufacturer assumes no responsibility for such
damage.
8
www.auroramultimedia.com
User Guide
This product warranty extends to the original purchaser only and will be null and void upon any assignment or
Aurora Multimedia Corp.
205 Commercial Court
Morganville, NJ 07751
Phone: 732-591-5800
9
Fax: 732-591-6801
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement