english @ safe 10/30 ei- operating instructions

english @ safe 10/30 ei- operating instructions
ENGLISH
@ SAFE 10/30 EI- OPERATING INSTRUCTIONS
º Functions
º INTERFACE
Concealed Keyhole
Screw
Batteries
If the green light blinks for about 8 seconds
and the lock gives a continuous “beep”;
batteries should be immediately replaced .
Keypad
Receiver
Battery cover
º OPERATING INSTRUCTIONS
Opening
Lean the electronic key (iB key) on the
receptor or enter the code followed by #,
the green light is on, open the safe.
Setting of the new code on the
electronic key (iB key)
Unscrew the lock cover and remove the
cover; push the button on the bottom of
the board, after three “beep” lean the
electronic key on the receiver; after one
“beep” the new code is issued.
Note: only one master electronic
card (iB key) is associated to a safe.
Setting of the digital
code and
closure
After every opening, you have to set a
new code.
Leaving the door closed, insert a new
code (1-9 numbers) followed by #; when
the green light is on, the safe is closed.
Note: when you insert the new code,
if you enter a wrong number, press *
to cancel it and insert anew number.
Safety code
The user can enter any number before the
correct code and then press # to open the
safe.
Warning function
When one wrong code is entered three times,
the safe will give warning signals for 60
seconds and it will not operate. After 60
seconds, the safe will revert to its normal
locked state.
Key override
Unscrew the screw and remove the battery
cover, insert and turn the mechanical key to
open the safe.
Batteries replacement
Remove the cover, replace the batteries with
new ones (alkaline batteries 1,5 V).
º SPECIFICATIONS
DESCRIPTION
MODEL
DIMENSIONS
PACKAGE
DIGITAL SAFE
DIGITAL SAFE
@SAFE 10E
@SAFE 30E
300 X 250 X 166
430 X 370 X 220
1 pc/carton
1 pc/carton
WEIGH
T
7 kg
16 kg
ENGLISH
Opening the safe and first setting of the iB key
Before installing the safe and the first time you have to set the iB key, follow these steps:
9 remove the plastic film from the receiver;
9 lean the iB key against the receiver; after one “beeps” the setting is finished. If in the
future you would like to modify the code, please follow instructions on the user manual.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement