Model PF600BP-PF1000BP
Backpack Vacuum
OPERATING INSTRUCTIONS
COMMERCIAL AND HOUSEHOLD
BACKPACK VACUUM CLEANERS
CONGRATULATIONS
YOU HAVE JUST ACQUIRED A HIGH QUALITY VACUUM
CLEANER. PLEASE READ THIS MANUAL CAREFULLY,
BEFORE OPERATING YOUR NEW VACUUM CLEANER.
KEEP MANUAL ON HAND FOR FURTHER REFERENCES.
Save These Instructions
PFBP-MAN 9/2008
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
*When using an electrical backpack vacuum cleaner, basic precautions should be followed.
*Read all instructions before using vacuum cleaner.
grounded. Do not modify the plug provided with the appliance - if it will not fit the outlet, have a proper outlet installed by a qualified electrician.
W AR NIIN G
To reduce risk of fire, electric shock, or injury:
●
Do not use outdoors or on wet surfaces.
●
Do not leave vacuum cleaner unattended when plugged in. Turn off the switch and unplug the electrical cord when not in use and before servicing.
●
Do not allow to be used as a toy. Close attention is necessary when used by or near children.
●
Use only as described in this manual. Use manufacturer’s recommended attachments.
●
Do not use with damaged cord or plug. If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service center before using.
●
Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull a cord around sharp edges or corners. Do not run vacuum cleaner over cord. Keep cord away from heated surfaces.
●
Do not use outlets with inadequate current carrying capacity. Only
16AWGx3 SJT extension cord should be used with machine.
●
Turn off all controls before unplugging.
●
Do not handle plug or vacuum cleaner with wet hands.
●
Do not put any objects into openings. Do not use with any opening blocked, keep free of dust, lint, hair, and anything that may reduce airflow.
●
This vacuum cleaner creates suction. Keep hair, loose clothing, fingers, and all parts of body away from openings.
●
Do not pick up anything that is burning or smoking, such as cigarettes, matches or hot ashes. Do not use without dust bag in place. Use extra care when cleaning on stairs. Do not use to pick up flammable or combustible liquids such as gasoline, or use in areas where they may be present.
●
Store your cleaner indoors in a cool, dry area.
●
Do not unplug by pulling on cord. To unplug, grasp the plug,
NOT THE CORD.
This appliance is for use on a normal 120 volt circuit, and has a grounded plug that looks like the plug illustrated in sketch A. A temporary adapter that looks like the adapter illustrated in fig B and C may be used to connect this plug to a 2-pole receptacle as shown in fig B if a properly grounded outlet is not available. The temporary adapter should be used only until a properly grounded outlet (fig A) can be installed by a qualified electrician, The green colored rigid ear, lug, or the like extending for the adapter must be connected to a permanent ground such as a properly grounded outlet box cover. Whenever the adapter is used, it must be held in place by a metal screw.
Note: In Canada, the use of a temporary adapter is not permitted by the
Canadian Electrical Code.
S AF TY RE CA TIIO S
●
Do not vacuum water or liquids.
●
Do not vacuum up hard or sharp objects, as they may damage the hose, vacuum bag or the vacuum motor.
●
Do not drop the vacuum on the floor.
● Do not operate the vacuum while it is standing on high-pile carpet.
The exhaust airflow is restricted and will cause the unit to overheat.
●
Do not wash or launder the cloth vacuum bag. It would destroy the filtration capacity of the fabric.
●
Do not kink or twist the power cord.
● Do not attempt to service the vacuum yourself. Repair by anyone other than an authorized repair service center may void the warranty.
THESE MODELS ARE GROUNDED, CONNECT
TO A PROPERLY GROUNDED OUTLET ONLY -
SEE GROUNDING INSTRUCTIONS.
GROUNDING INSTRUCTIONS
This appliance must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of shock. This appliance is equipped with a cord having an equipment-grounding conductor and grounding plug. The plug must be inserted into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
WARNING - Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service person if you are in doubt as to whether the outlet is properly
M AIIN NA NC
●
Clean the cloth vacuum bag regularly. After emptying the vacuum bag, turn it inside out and shake as much dust out of the fabric as possible. Optimum performance is achieved by using a paper vacuum bag with the cloth bag.
● Use only approved paper vacuum bags.
● Check the power cord for damage.
●
Always unwind the cord completely.
●
Ensure that the vacuum hose, the extension wand and the vacuuming accessories are not blocked.
●
Ensure that the electrical outlet and the plug are securely connected. Incorrect connections may cause sparking and damage to the cable socket.
●
Have your Backpack Vacuum serviced by an authorized repair service center if you suspect any potential problems.
●
Ensure that the flexible vacuum bag ring provides a proper seal before vacuuming.
OP ER TIIO N IIN ST UC TIIO S
Please read the following operating instructions carefully. They will help you to get the best performance from this professional quality vacuum cleaner and to maintain it in optimum condition.
Follow these simple steps for easy and effective operation of the Backpack vacuum.
Open the lid and ensure that the cloth bag is correctly located and the flexible ring provides a proper seal when the lid is closed. For optimum performance, filtration and maximum hygiene, it is advisable to use a paper vacuum bag in addition to the standard cloth bag.
If you use a paper vacuum bag, simply insert it into the cloth bag, making sure that the cardboard disk is centered on the flexible sealing ring.
When you replace the lid, the short nozzle in the center of the lid will be forced into the central hole of the cardboard disk of the paper vacuum bag thus providing a tight seal. Make sure the paper vacuum bag is tightly secured over the short nozzle before vacuuming.
Lock the lid down with the two latches. Always ensure that the vacuum bag is empty before vacuuming. Your Backpack vacuum has been fitted with a thermal overload switch to protect the motor against damage should the airflow be blocked for extended periods. This may occur if the vacuum bag is overfull, the cloth filter bag is clogged or if the vacuum hose or exhaust is blocked. The vacuum motor will stop before it can get too hot. If this happens, empty and thoroughly clean the vacuum bag or free any blockage and ensure that adequate airflow is restored. After the motor has cooled to a safe operating temperature, locate the thermal reset switch on the bottom of the unit and push it back in. There will be a slight audible click. Now the motor will restart.
1.
The vacuum hose is fitted into the cuff in the lid. It should not be necessary to remove the hose in normal operation.
2.
Place the Backpack vacuum on your back, adjust the shoulder straps until you feel comfortable and then tighten the waist belt. The
Backpack vacuum is designed to ride higher on your back for maximum comfort.
3.
Plug the cord into a 110 volt, grounded outlet. Always unwind the cord completely before vacuuming. It is important to maintain the power cord in good condition. This unit ships with a 50' 16AWG x 3 conductor SJT extension cord. Always use a 16x3 SJT extension cord when operation this unit. Use care when pulling the cord around sharp edges and through doorways
Never operate the Backpack vacuum if the power cord is damaged in any way.
4.
Attach the extension wand to the hose and fit the floor tool or any of the other vacuuming accessories on the wand.
5. Turn the vacuum on. The toggle switch is located on the switch box.
You may clip the switch box to the waist belt.
Turn off main power switch and unplug unit from wall outlet.
Remove vacuum hose from top of unit.
Release the two latches and lift off lid.
Separate lid from paper bag insert and dispose of paper bag.
Remove cloth filter bag, clean, dust and replace.
Insert new paper bag making sure to align lid nozzle with bag hole and replace latches.
Model PF600BP - PF1000BP Parts
18
32
19
28
6
17
32
3
7
37
29
30
31
32
33
34
35
36
23
24
25
26
27
28
17
18
19
20
21
22
9
10
11
12
13
14
15
16
6
7
8
3
4
5
1
2
Parts List for PF600BP ref # item # description
A328-1400
A352-3300
THERMAL PROTECTION SWITCH
LATCH
A352-8100
A352-8200
A430-0205
#10 .750 TYPE B PHILIPS PAN HEAD SCREW
#6 X .375 HI-LO PHILIPS PAN HEAD SCREW
#8-16 X 2.500 PHILIPS PAN HEAD SCREW
A732-8300 #8 X .625 HI-LO PHILIPS PAN HEAD SCREW
C352-9200 BACK SET
B352-2400 POST FILTER
B325-2500
B352-3200
B352-6100
B352-0200
B352-0300
PAPER BAG
POWER HARNESS
BAG COMPARTMENT SEAL
B352-600 HEYCO FITTING
B352-6800-NUT HEYCO FITTING NUT
B352-0100 MOTOR COMPARTMENT
BUMPER
FRONT PLATE
B352-0400 BACK PLATE
B352-0500 COVER
B352-0600 HOSE INLET
B352-0700 MOTOR COVER
B352-0800 SECONDARY FILTER PLATE
B352-0900 SECONDARY FILTER FRAME
B352-1000 SECONDARY FILTER CAP
B352-8000 POST FILTER FRAME
B352-1200 BODY SEAL
B352-1900 BOTTOM MOTOR MOUNT
B352-4800 INLET SEAL
C352-1400 SHAKE OUT BAG
C352-2800 SWITCH HARNESS
A113-2600 5.1" SINGLE STAGE TEK MOTOR
B113-0915 TEK MOTOR SHROUD PC
B352-1800
B352-5300
B352-5400
B352-5500
TOP MOTOR MOUNT
MOTOR SHROUD BOTTOM 5.1 - 1 STAGE
MOTOR SHROUD TOP 5.1 - 1 STAGE
MOTOR SEAL
1
29
11
5
25
20
33
10 12 13
27
6
9
2
16
23
22
21
31
6
34
4
26
35
36
30
14
15
6
8
24
25
26
27
28
29
30
31
32
19
20
21
22
23
24
33
34
35
36
37
13
14
15
16
17
18
8
9
10
11
12
5
6
7
2
3
4
Parts List for PF1000BP ref # item #
1 A328-1400 description
THERMAL PROTECTION SWITCH
A352-3300
A352-8100
A352-8200
LATCH
#10 .750 TYPE B PHILIPS PAN HEAD SCREW
#6 X .375 HI-LO PHILIPS PAN HEAD SCREW
A430-0205 #8-16 X 2.500 PHILIPS PAN HEAD SCREW
A732-8300 #8 X .625 HI-LO PHILIPS PAN HEAD SCREW
C352-9200 BACK SET
B352-2400
B325-7800
B352-3200
B352-6100
B352-600
POST FILTER
PAPER BAG
POWER HARNESS
BAG COMPARTMENT SEAL
HEYCO FITTING
B352-6800-NUT HEYCO FITTING NUT
B352-0100 MOTOR COMPARTMENT
B352-0200 BUMPER
B352-7639 FRONT PLATE
B352-7743 BACK PLATE
B352-0500 COVER
B352-0600 HOSE INLET
B352-0700 MOTOR COVER
B352-0800 SECONDARY FILTER PLATE
B352-0900 SECONDARY FILTER FRAME
B352-1000 SECONDRAY FILTER CAP
B352-8000 POST FILTER FRAME
B352-1200 BODY SEAL
B352-1900 BOTTOM MOTOR MOUNT
B352-4800 INLET SEAL
C352-1500 SHAKE OUT BAG
C352-2800 SWITCH HARNESS
A113-2600 5.1" SINGLE STAGE TEK MOTOR
B113-0915 TEK MOTOR SHROUD PC
B352-1800
B352-5300
B352-5400
B352-5500
B352-8100
TOP MOTOR MOUNT
MOTOR SHROUD BOTTOM 5.1 - 1 STAGE
MOTOR SHROUD TOP 5.1 - 1 STAGE
MOTOR SEAL
BACKREST MOUNT
8
9
10
11
5
6
7
2
3
4
Not Illustrated ref # item #
1 A134-0441 description
50' EXTENSION CORD 16-3 SJT YELLOW
A352-3400
B352-3500
B352-3600
HOSE
UPHOLSTERY TOOL
CREVICE TOOL
B352-3700 DUST BRUSH TOOL BODY
B352-3800 DUST BRUSH BRISTLES
B352-3900 DOUBLE BEND WAND
B352-4200 CARPET TOOL BODY
B352-4300 CARPET TOOL BUMPER
B352-4500 BARE FLOOR TOOL BODY
B352-4600 BARE FLOOR TOOL BRUSH
The Powr-Flite Limited Warranty
The manufacturer warrants to the original purchaser that products manufactured are free from defects, provided such goods are installed, operated and maintained in accordance with written manuals or other instructions for a period of 1 year from date of purchase on workmanship, motor, and parts. In case you, as our customer, meet any trouble with your machine, contact a Powr-Flite representative, who will be happy to be of service to you and will take care of any warranty issues. This warranty covers normal use and does not cover damage which occurs in shipment or failure resulting from altercation, accident, misuse, abuse, neglect or improper maintenance.
A Tacony Company
3101 Wichita Court • Ft. Worth, TX 76140-1710 • Call 1-800-880-2913 • www.Powr-Flite.com
