Comfort Zone CZ448E Series Quick Start Manual

CZ448E Series
ENERGY SAVE TECHNOLOGY®
helps save energy and reduces
your heating costs.
ENERGY SAVE TECHNOLOGY
provides comfortable heating
using 30% less energy than a
standard heater!*
*Note: Compared to a 1,500 watt space
heater on high heat.
Patent Pending
Oscillating Compact
Ceramic Heater
Features:
• Three Heat Settings:
Energy Save Mode
High - 1,500W (5,120 BTU)
Low - 750W
• Adjustable Thermostat
• Fan Only Setting
• Top Mounted Control Panel
• Power Indicator Light
• Quiet High Efficiency Fan Assisted
• 80° Oscillation for Wide Coverage
• Safety Overheat Protection
• Safety Tip-Over Protection
• Stay Cool Carry Handle
• 120V AC, 60Hz, 12.5A
www.comfortzoneproducts.com
Save These Instructions
INTENDED USE:
This product is intended for indoor residential and office use only,
not for industrial or other commercial applications. Use only with
electrical wiring that is in good working order and that meets
applicable codes and ordinances. This heater must be plugged in to
a 120V AC, 15 Amp (or larger) circuit. Do not plug anything additional
into the same circuit. If you have any questions whether your wiring
is adequate, consult a qualified electrician. Risk of fire, overheating,
malfunction, property damage, injury or even death may result if not
adhered to.
Use you heater only with a working smoke detector located in the
vicinity of your heater.
While using your heater, you should follow the IMPORTANT
INSTRUCTIONS listed below. As part of those instructions, we
have used the word "WARNING" to indicate the level of hazard:
WARNING indicates a hazard which, if not avoided, could result in
injury or death.
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic safety precautions should
always be followed to reduce the risk of fire, electric shock and injury
to persons, including the following:
• Read all the instructions before using this heater.
• This heater is hot when in use. To avoid burns, do not let bare skin
touch hot surfaces. Use provided handle when moving this heater.
Keep combustible materials, such as furniture, pillows, bedding,
papers, clothes and curtains at least 3 feet (0.9 meters) from the
front of the heater and keep them away from the sides and rear.
• Do not use heater unattended. Use of extreme caution is necessary
when any heater is used by or near children, invalids, disabled
persons or pets.
• Do not operate the heater with a damaged power cord or after the
heater malfunctions, has been dropped or damaged in any manner.
Return heater to authorized service facility for examination,
electrical or mechanical adjustment or repair.
• Do not use heater outdoors.
• Use your heater only in dry environments. This heater is not
intended for use in a bathroom, laundry area, or similar locations,
or near sinks, washing machines, swimming pools or other sources
of water. Never locate heater where it may fall into a bathtub or
other water container. Do not use in damp environments such as
flooded basements.
• Do not place the heater on a small, unlevel, uneven or any surface
which might allow heater to tip or fall.
• For proper operation, heater should be placed on a smooth,
non‑combustible, level surface. Do not place on rugs, carpet, vinyl
flooring or other plastic surfaces. Not for use outdoors or in wet
areas.
• This heater is not designed as a primary heat source.
• Always plug heaters directly into a wall outlet/receptacle. Never
use with an extension cord or relocatable power tap (outlet/power
strip). Always unplug heater when not in use.
• Do not run power cord under carpeting. Do not cover cord with
throw rugs, runners or similar coverings. Arrange cord away from
traffic area where it will not be tripped over.
• To disconnect heater, turn controls off then remove plug from
outlet.
• Do not insert or allow foreign objects to enter any ventilation or
exhaust opening as this may cause an electric shock or fire or
damage the heater.
• To prevent a possible fire, do not block air intakes or exhaust in any
manner. Do not use on soft surfaces like a bed, where openings
may become blocked.
22
• A heater has hot and arcing or sparking parts inside. Do not use
it in areas where gasoline, paint or flammable liquids are used or
stored.
• Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock
or injury to persons or property.
READ & SAVE THESE
INSTRUCTIONS
WARNING: SHOCK HAZARD
Use your heater only in dry environments. This heater is not intended
for use in a bathroom, laundry area, or similar locations, or near
sinks, washing machines, swimming pools or other sources of
water. Never locate heater where it may fall into a bathtub or other
water receptacle. Do not use in damp environments such as flooded
basements.
WARNING: HOT SURFACES
Do not touch body of heater when in use. This heater is hot when
in use, to avoid burns, do not let bare skin touch hot surfaces. If
provided, use handles when moving this heater.
WARNING: FIRE HAZARD
Heater has hot and arcing or sparking parts inside. Do not use near
combustible materials or flammable gases or sources of heat. DO
NOT USE in areas where gasoline, paint or flammable materials
are used or stored. Keep combustible materials such as furniture,
pillows, bedding, papers, clothes and curtains at least 3 feet (0.9 m)
from the front of the heater and keep them away from the sides and
rear. To prevent a possible fire, do not block air intakes or exhaust in
any manner. Do not use on soft surfaces, like a bed, where openings
may become blocked. Do not place the heater near a bed because
objects such as pillows or blankets can fall off the bed and be ignited
by the heater. Do not insert or allow foreign objects to enter any
ventilation or exhaust opening as this may cause an electric shock,
fire, or damage the heater.
WARNING: ELECTRICAL SHOCK HAZARD
Do not use with damaged cord or plug. Use with adequate electrical
system that is up to code.
CAUTION: TO PREVENT ELECTRIC SHOCK
This product has a polarized two prong plug (one blade is wider
than the other) that must be fully inserted into a matching properly
grounded outlet. This plug is designed to fit a polarized outlet only
one way. If the plug does not fit fully into the outlet, reverse the plug.
If the plug still does not fit, contact a qualified electrician. Do not
attempt to defeat this safety feature.
Do not operate any heater with a damaged cord or plug or after
heater malfunctions, has been dropped or damaged in any manner.
Do not operate heater with a broken heating element or ceramic
cone or any visual imperfections. For repairs covered under warranty,
see warranty statement. For all other repairs contact Comfort
Zone® Customer Service by telephone or mail for information and
assistance.
PET OWNERS NOTE
The health of birds and some small pets are extremely sensitive to
the fumes given off during the initial use of many appliances.
Although these fumes are not harmful to humans, it is recommended
that this heater not be used around birds and small pets during its
initial use until the manufacturing corrosion coatings burn off.
USAGE
TO OPERATE FAN ONLY:
HEATER OPERATION: Always operate the heater in the upright
position following all instructions and recommendations listed in
this manual.
Turn the Power Level Control dial to the FAN
setting. Turn
thermostat fully clockwise so the fan will run continuously.
HEATER LOCATION: Place the heater in the area of the room
that is coldest. The heater should not be placed immediately
under a power outlet.
OSCILLATION:
HEATER CONNECTION: Plug heater directly into 120V AC,
60Hz wall outlet. Be sure plug fits tightly in outlet. A loose
connection may cause overheating and damage to the plug or
heater.
You can control the Oscillation feature on the Heater (FAN) by
pressing the Oscillation Control switch located at the base of the
heater.
NOTE: To prevent overloading a circuit, do not plug the heater
into a circuit that is servicing other electrical needs.
Oscillation switch
POWER INDICATOR LIGHT:
When the unit is turned on, the power indicator light will
illuminate to tell you the heater is functioning.
TURNING THE HEATER OFF:
TURNING THE HEATER ON:
To turn the heater OFF, rotate the Power Control dial to the OFF
« O » position and unplug the unit. Heater should be unplugged
when not in use.
To start the heater, turn the Power Control dial (right knob) from
OFF « O » position to FAN , LOW heat « », HIGH heat « », or
ENERGY SAVE
setting. Then rotate the Thermostat Control
(left knob) clockwise to the HIGH THERMOSTAT position
« MAX » as described below.
NOTE: During the heaters initial use, you may experience a
slight odor or smoking. This is the result of the heating element
lubrication protective coating “burning off”. This is normal and
will go away after a few minutes of use.
CONTROL PANEL
Power Level Control Dial:
Power On/Off – O
Power Indicator
Fan Only –
Low Heat –
Thermostat
High Heat –
(750W)
(1,500W)
Energy Save –
IMPORTANT SAFETY FEATURES:
The power indicator light, located near the control panel, lights
whenever the heater or fan is turned on.
The heater is equipped with an automatic overheat protection
device located inside the body of the heater. If the heater grille
is obstructed, or if the heater gets too hot for any reason, the
automatic overheat protection device will turn the heater off. To
reset the heater, simply turn power off and unplug the heater
for 10 minutes until it cools down and then you may plug the
heater in and restart. Be sure that the heater is on a smooth level
surface with no obstructions.
The heater is also equipped with a safety tip-over switch to turn
power off to the heater when the heater tips over. To resume
heater functions simply stand heater upright.
POWER LEVEL PANEL:
This heater has 3 heat settings: LOW, HIGH and ENERGY SAVE.
Select the heat setting that best meets your heating needs.
The ENERGY SAVE setting provides comfortable heating in most
rooms, while saving you money on energy costs.
SETTING THE THERMOSTAT:
After heater has been turned on and the room has reached
the desired temperature, slowly rotate the thermostat knob
counter-clockwise until the heater shuts off (you should
hear a faint “click”). By leaving the thermostat at this setting
it will automatically maintain this temperature. To lower the
temperature, rotate the knob further counter-clockwise
(towards the « MIN » position). To raise the temperature, rotate
the thermostat knob clockwise (towards the « MAX » position).
NOTE: It is normal for the heater unit to cycle Heating On and
Heating Off as it maintains the set temperature.
33
CARE AND MAINTENANCE:
LIMITED WARRANTY
WARNING: ALWAYS UNPLUG THE CORD BEFORE MOVING
OR SERVICING. Do not use harsh chemical or abrasive cleaners.
DO NOT IMMERSE THE HEATER IN WATER. Allow heater to dry
completely before use.
This unit is guaranteed to the original retail purchaser against
defects in quality or workmanship for a period of one year
from the date of original purchase. If this unit fails because of
a manufacturing defect within 30 days of purchase, return the
unit, with your receipt, to the retailer. After 30 days, but within
the warranty period, if the unit was purchased within the
continental United States, return it, freight prepaid, to World
and Main for repair or replacement. If the unit was purchased
outside the continental United States, return the unit to the
place of purchase. This warranty does not cover damage
caused by misuse, abuse, overheating or alteration. Repairs
made by anyone other than World and Main are not covered
in this warranty. World and Main will not be held liable for any
losses due to neglectful operation. All implied warranties,
including the warranties of merchantability and of fitness of
purpose, if applicable, are hereby limited in duration to the
period of one year from the date of original retail purchase.
Some states do not allow limitations on how long an implied
warranty lasts, so the above limitations may not apply to you.
Incidental or consequential damages arising from a breach
of either express or implied warranties are hereby disclaimed
and excluded. Some states do not allow the exclusion of
limitation of incidental or consequential damages, so this
limitation or exclusion may not apply to you. Upon the
expiration of this warranty all such liability will terminate.
No other warranties are expressed or implied.
CLEANING: IMPORTANT! DO NOT IMMERSE HEATER IN
WATER! Clean the heater grille with the vacuum brush
attachment on your vacuum cleaner. This will remove lint and
dirt from inside the heater. DO NOT ATTEMPT TO TAKE APART
THE HEATER. DO NOT REMOVE THE HEATER GRILLE. Clean
the body of the heater with a soft cloth.
CAUTION: Do not use gasoline, benzene, paint thinner, harsh
cleaners, etc. as they will damage the heater. NEVER USE
ALCOHOL OR SOLVENTS.
REPAIR: DO NOT OPERATE THE HEATER WITHOUT THE
GRILLE IN PLACE. DO NOT USE THE HEATER IF IT HAS
MALFUNCTIONED OR BECOME DAMAGED IN ANY WAY.
STORAGE: Keep original carton for storage of the heater. Coil
and tie the power cord to avoid damage during storage.
This warranty gives you specific legal rights, and you
may also have other rights which vary from state to state.
No informal dispute settlement mechanisms are available.
This limited warranty is given in lieu of all other warranties.
Manufactured for:
World and Main (Cranbury), LLC
324A Half Acre Rd.
Cranbury, NJ 08512 USA
800-221-6895
www.comfortzoneproducts.com
Rev. 06/02/22
44