TEKNOWINCH WWL 125-50 000 kg Electric winch Instruction manual

Below you will find brief information for Electric winch WWL 125-50 000 kg. This manual provides information on the safe transport, handling, installation, maintenance and repair of winches. The document also provides information about the various components of the winch, and how to properly install and operate it. It is important to read this manual thoroughly before using the winch. Failure to do so may result in unsafe operating conditions and damage to the winch.

PDF Download
Document
Electric winch WWL 125-50 000 kg Instruction manual | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Towing and lifting
  • Safe operation
  • Installation instructions
  • Maintenance and repair
  • Emergency stop
  • Limit switch
  • Wire rope handling
  • Gearbox lubrication
  • Electric motor connection
  • Brake connections

Frequently asked questions

Before operating the winch, you should read the manual carefully and familiarize yourself with the product, and ensure that the product is not under load and that the power supply is switched off and disconnected before performing any maintenance or close inspection on the winch.

First, you need to fit the wire dead end from the inside of the drum to the outside through the slotted hole in one of the drum flanges. Then, you need to fasten the wire dead end in the pocket so that it makes an eye around the wire wedge. Pull the wire from the opposite side to press the wire and wedge into the pocket.

You need to check the lubricating oil level and fill up if necessary. You also need to periodically check the tightness of all fasteners and tighten if necessary. Replace any damaged fasteners found.
Preparing document for printing…
0%