DP9210 - Extron Electronics

DP9210 - Extron Electronics
IP Link® Device Interface
Communication Sheet
prox_1_2216_1.pke
Revision: 7/20/2005
This document provides additional assistance with wiring your Extron IP Link enabled product to your device.
Different components may require a different wiring scheme than those listed below.
For complete operating instructions, refer to the user’s manual for the specific Extron IP Link enabled product or
the controlled device manufacturer supplied documentation.
Device Specifications:
Device Type:
Manufacturer:
Firmware Version:
Model(s):
Video Projector
Proxima
N/A
DP9210
Version History:
Driver
Version
Date
IP Link
Compiler
IP Link
Firmware
GVC
Version
1
7/14/05
1.0.9.3
1.08
1.6
Notes
Released version. Tested on DP9210
Driver Notes:
Page 1 of 3
IP Link® Device Interface
Communication Sheet
prox_1_2216_1.pke
Revision: 7/20/2005
Control Commands & States:
Audio Mute
On
Off
Freeze
On
Off
Input
Computer 1
Computer 2
AV1
AV2
Power
On
Off
Video Mute
On
Off
Volume
Up
Down
Status Available:
Power
On
Power Status
On
Status Unavailable
Cable and Adapter Requirements:
Use the manufacturer’s serial cable provided with the projector, a M/F RS-232 straight serial cable (Extron
Electronics P/N: 26-433-03), and a female-to-female gender changer (Extron Electronics P/N: 10-438-10).
As an alternative, you can create a cable using the pin assignment diagram below with a male-to-bare wire RS-232
cable (Extron Electronics P/N: 26-437-03) and a female-to-female gender changer (Extron Electronics P/N: 10-43810) and solder the bare wire to an 8 pin mini din connector.
Notes for the Device:
The RXD signal on the serial port (pin 1) is provided on the PC control port 2 connector only, therefore the IP Link
device must be connected to the PC control port 2 on the projector.
Page 2 of 3
prox_1_2216_1.pke
IP Link® Device Interface
Communication Sheet
Revision: 7/20/2005
Serial communication:
Port Type: RS232
Baud Rate: 19200
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
Pin Assignments Diagram:
With provided projector cable:
To create your own cable:
PC Control 2
Note: Captive screw connector may also be used as a serial connection.
General Notes:
Page 3 of 3
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement