MRES30 - Appliances Connection
MRES30
Document # PG05-005
Revised 10/01/10 Page 1/2
30 Inch Wide
Renaissance® Electric Range
PLANNING
GUIDE
All tolerances: +1/16”, -0, (+1.6mm, -0) unless otherwise stated
warning
•
Observe all governing codes and ordinances during planning
and installation. Contact your local building department for
further information.
•
This appliance must be installed in accordance with the
accompanying installation instructions.
60” (152.4 cm) long
240 Vac 4 wire
conduit location
The optional full size side panels are for installation where the side of the
range will not be covered by the cabinet. For the right side panel, order
Dacor part number ARSR30S. Order part number ARSL30S for the left
side.
Dedicated Circuit Required
Total Connected Load
240 Vac, 60 Hz., 4-wire*, 50 Amp.
12.5 kW (48.2 Amp.)
electrical Requirements
The above specifications are for reference only. See the product data label
for exact specifications.
36" (91.4 cm) recommended
30" (76.2 cm) min.
35”
(88.9 cm)
Hood
Non-combustible rear
wall recommended
13" (33.0 cm)
max.
5/16” - 1 13/16”
8 mm - 46 mm)
25"
(63.5 cm)
Top of
finished
counter
Optional full size side panels
(ARSL30S, ARSR30S)
Removable (factory installed)
3” (7.6 cm) side panels
product dimensions - ISO View
18" (45.7 cm)
min.*
30" (76.2 cm) 30 1/16"
min.*
(76.4 cm)
30"
(76.2 cm)
10" (25.4 cm)
min. to
combustibles
side wall
(both sides)
1
2
Range top
Rear of control
Panel/oven door
23 1/2"
(59.7 cm)
Electrical locations**
1) Recommeded
2) Alternate
25 5/16"
(64.3 cm)
* Vertical to combustible surface from cooktop surface
** 14”H (35.6 cm) X 10”W (25.4 cm)
Door opened
Max. depth
to oven door
handle with
door closed
45 1/4"
(114.9 cm)
Consult local code for exact location requirements
Freestanding Cutout Dimensions
For self-rimming cutout dimensions, see the following page.
product dimensions - top View
NOTES:
1.
2.
Electrical is located in the right rear corner of the unit.
Range is supplied with a 60” (1524 cm) long 240V 4-wire conduit.
Specifications subject to change without notice.
www.dacor.com
Phone: (800) 793-0093
5.12
MRES30
Document # PG05-005
Revised 10/01/10 Page 2/2
30 Inch Wide
Renaissance Electric Range
PLANNING
GUIDE
All tolerances: +1/16”, -0, (+1.6 mm, -0) unless otherwise stated
Backsplash
Vertical
non-combustible
surface rear wall
1/4" (6 mm)
min. flat ledge
Rear wall
25"
(63.5 cm)
Adjust for backsplash
thickness
13/16" to 4 1/4"
(2.1 - 10.8 cm)
28 11/16" (72.9 cm)
29 5/8" (75.2 cm)
11/16"
(1.7 cm)
Top View - Slide-In, Self-Rimming Installation using 3” Side Panels
with Backguard Removed
Vertical
non-combustible
surface rear wall
27 7/8" (70.8 cm)
27 13/16"
(70.6 cm)
Backsplash
thicker than
3/4" (1.9 cm)
1/4" (6 mm)
min. flat ledge
2 13/16"
(7.1 cm)
Adjust for backsplash
over 3/4" thick
from 13/16" to 3 13/16"
(2.1 - 9.7 cm)
13/32" (1.0 cm)
29 1/4" (74.3 cm)
30 1/16" (76.4 cm)
Countertop overhangs cabinet
10" (25.4 cm) min.
to combustible side
walls above the range
(both sides)
Top View - Downdraft ERV30 with Slide-In, Self-Rimming Installation using 3” Side Panels
with Backguard Removed
Specifications subject to change without notice.
www.dacor.com
Phone: (800) 793-0093
5.13
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement