Universal Tool UT8748 angle cut-off tool User manual

Below you will find brief information for angle cut-off tool UT8748. This angle cut-off tool is designed to operate on 90 PSIG. It features the safety lock-off mechanism. The tool is designed to operate on 90 PSIG, which is the maximum rated pressure for the tool. It also features a safety lock-off mechanism to prevent accidental operation.

PDF Download
Document
angle cut-off tool UT8748 User Manual | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Safety lock-off mechanism
  • Maximum rated pressure of 90 PSIG
  • Rear exhaust
  • 17,000 RPM speed
  • 3/8" - 24 spindle size
  • 1.0 HP motor
  • 3.1 lb weight

Frequently asked questions

The maximum rated pressure for the angle cut-off tool is 90 PSIG.

Remove the screws and flange nut with the 4 MM hex wrench and 17 MM spanner, mount the cutting wheel on the spindle, replace the flange nut and re-tighten the screw using the 4 MM hex wrench and 17 MM spanner.

Always use ANSI approved grinding stones with the rated tool RPM.
Preparing document for printing…
0%