Honda 08W17-T2A-100 Installation Instructions

INSTALLATION
INSTRUCTIONS
Accessory
Application
Publications No.
17” ALUMINUM WHEEL
P/N 08W17-T2A-100
2013 ACCORD
2 AND 4-DOOR
AII 13001
Issue Date
OCT 2012
PARTS LIST
Supplemental information
(May not be used.)
Aluminum wheel
(The illustration may differ from the actual wheel.)
Wheel center cap
(The illustration may differ from the actual center cap.)
TOOLS AND SUPPLIES REQUIRED
Isopropyl alcohol
Shop towel
SPECIFICATIONS
Models not equipped with standard 17” wheels:
Valve
Wheel cleaning information
(Give this information to your customer.)
Rim size
17 x 7 1/2 J (inset 55)
Tire size
215/55R17 94V
Bolt hole PCD
114.3 (5 holes)
Tire pressure
Front
225 kPa
(2.25 kgf/cm2, 33 psi)
Rear
225 kPa
(2.25 kgf/cm2, 33 psi)
Models equipped with standard 17” wheels:
TPMS Information
(For models not equipped with standard 17” wheels. Give
this information to your customer.)
For tire pressures, refer to door jam Tire Label or the
owner’s manual.
Tire pressure information label
(May not be used.)
© 2012 American Honda Motor Co., Inc. – All Rights Reserved.
AII 13001 (1210)
08W17-T2A-1000-90
1 of 2
INSTALLATION
If not originally equipped with standard 17” wheels,
do this:
Customer Information: The information in this
installation instruction is intended for use only by skilled
technicians who have the proper tools, equipment, and
training to correctly and safely add equipment to your
vehicle. These procedures should not be attempted by
“do-it-yourselfers.”
1.
Open the driver’s door. Using isopropyl alcohol on a
shop towel, thoroughly clean the area where the tire
pressure information label will attach. Remove the
adhesive backing from the label, and attach it over
the standard tire pressure information label as
shown.
ACCESSORY TIRE
PRESSURE
INFORMATION LABEL
NOTE:
• The illustrations of the aluminum wheels are shown for
reference purposes only.
• Install the tire. If originally epuipped with 17” wheels,
use the same original equipment tire size make and
model tire. If not originally equipped with standard 17”
wheels, use the tire recommended in the applicable
“Accessories and Touch-Up Paint” Parts Information
Bulletin for this model.
LEFT DOOR
JAMB
• Use a tire changer to install and remove the tires as
described in the Operation Manual furnished with the
tire changer. Do not use a tire lever to install and
remove the tires as it may cause damage to the tire and
aluminum wheel.
• The wheel nut torque is 108 N·m (11.0 kgf·m, 80 lbf·ft).
FRONT
ADHESIVE
BACKING
Remove.
• This kit should be installed only if the ambient air
temperature is 60°F (15°C) or above.
• To allow the adhesive to cure, do not wash the vehicle
for 24 hours. Please advise the customer.
2.
Models equipped with standard 17” wheels:
Discard the TPMS information, tire pressure information
label and supplemental information in this kit.
• Be sure to give the wheel cleaning information to your
customer.
2 of 2
AII 13001 (1210)
STANDARD TIRE PRESSURE
INFORMATION LABEL
Clean with isopropyl alcohol.
QB21401AB
Attach the “Supplemental Information” page
included in this kit into the Owner’s Manual. For the
method of attaching the page, refer to “Important
Information to Dealer” attached to the “Supplemental
Information” page.
© 2012 American Honda Motor Co., Inc. – All Rights Reserved.