Honda 2006 RIDGELINE Installation Instruction

Accessory
INSTALLATION
INSTRUCTIONS
PARTS LIST
Attachment Kit:
P/N 08B06-SJC-100
Application
Publications No.
AII 28615
MP3 PLAYER
ATTACHMENT KIT
2006 RIDGELINE
Issue Date
FEB 2005
MP3 Player Kit (sold separately):
P/N 08A06-4E1-200
Right player bracket
MP3 player
Left player bracket
4 Washer-bolts, 5 x 8 mm
Owner’s Manual
Player panel
BUS cable
Harness clip
Washer-screw, 4 x 8 mm
© 2005 American Honda Motor Co., Inc. - All Rights Reserved.
AII 28615 (0502)
08B06-SJC-1000-91
1 of 5
4.
TOOL AND SUPPLIES REQUIRED
Phillips screwdriver
Flat-tip screwdriver
Shop towel
Remove the audio unit (five bolts, pull the audio
unit out toward you, and unplug the vehicle
connectors).
VEHICLE
CONNECTOR
INSTALLATION
INSTRUMENT
PANEL
AUDIO
UNIT
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by “do-it-yourselfers.”
1.
Make sure you have the anti-theft code for the
radio, then write down the radio station presets.
2.
Disconnect the negative cable from the battery.
3.
Insert a flat-tip screwdriver, wrapped with a shop
towel, into the groove of the meter panel to
release the two clips. Pull the meter panel out
toward you to release the 18 clips, and then
remove the meter panel by unplugging the vehicle
connectors.
BOLTS (5)
(Reuse.)
4606030T
VEHICLE
CONNECTOR
VEHICLE
CONNECTOR
5.
Remove the left and right vehicle brackets, and
the pocket from the audio unit by removing the
eight bolts and two self-tapping screws.
BOLT
(Reuse.)
RIGHT VEHICLE
BRACKET
METER
PANEL
AUDIO
UNIT
BOLT
(Reuse.)
VEHICLE
CONNECTOR
SHOP
TOWEL
CLIPS
(2)
SELF-TAPPING
SCREW
(not reused)
SELF-TAPPING
SCREW
LEFT VEHICLE
(not reused)
BRACKET
3915101T
CLIPS (18)
FLAT-TIP
SCREWDRIVER
Insert into the groove.
2 of 5
POCKET
4701010T
AII 28615 (0502)
© 2005 American Honda Motor Co., Inc. - All Rights Reserved.
6.
Remove the hazard switch from the pocket (two
retaining tabs).
8.
Reinstall the vehicle brackets to the audio unit
with the eight bolts removed in step 5.
POCKET
(not reused)
BOLT
(Reuse.)
AUDIO UNIT
RETAINING
TAB
HAZARD
SWITCH
RIGHT VEHICLE
BRACKET
BOLT
(Reuse.)
4701020T
7.
Insert the player into the new player panel.
9.
PLAYER
PANEL
LEFT VEHICLE
BRACKET
4701050T
Insert the pins on the audio unit into the holes in
the player panel, and attach the audio unit to the
player. Position the left and right player brackets
on the vehicle brackets, and install the four
5 x 8 mm washer-bolts included with the player
kit.
AUDIO UNIT
LEFT
VEHICLE
BRACKET
PIN
RIGHT VEHICLE
BRACKET
PLAYER
4701041T
LEFT
PLAYER
BRACKET
RIGHT
PLAYER
BRACKET
5 x 8 mm
WASHERBOLT
(in the
Player Kit)
PLAYER
HOLE
4701062T
5 x 8 mm
WASHERBOLT
(in the
Player Kit)
© 2005 American Honda Motor Co., Inc. - All Rights Reserved.
AII 28615 (0502)
3 of 5
10. Install the hazard switch (removed in step 6) into
the player panel.
PLAYER
PANEL
12. Secure the BUS cable with the harness clip.
HAZARD
SWITCH
4701031T
HARNESS CLIP
11. Plug the BUS cable 14-pin connector into the
audio unit and into the player. Install the harness
clip to the rear of the player with the 4 x 8 mm
washer-screw.
BUS CABLE
13. Plug the vehicle connectors into the audio unit,
and into the player.
AUDIO
UNIT
AUDIO
UNIT
14-PIN
CONNECTOR
VEHICLE 20-PIN
CONNECTOR
HAZARD
SWITCH
CONNECTOR
BUS
CABLE
HARNESS
CLIP
4 x 8 mm
WASHERSCREW
PLAYER
PLAYER
ANTENNA
CONNECTOR
VEHICLE 14-PIN
CONNECTOR or ACCESSORY
XM RADIO 14-PIN
CONNECTOR
(If equipped)
4 of 5
AII 28615 (0502)
© 2005 American Honda Motor Co., Inc. - All Rights Reserved.
14. Reinstall the audio unit/player assembly.
INSTRUMENT
AUDIO UNIT/
PLAYER ASSEMBLY PANEL
BOLTS (5)
(Reuse.)
4701131T
15. Check that all wire harnesses are routed properly
and all connectors are plugged in.
16. Reconnect the negative cable to the battery.
17. Enter the customer’s radio anti-theft code, and
reset the radio station presets.
18. Set the clock.
19. Check the operation of the player according to
the owner’s manual.
20. Put the player owner’s manual in the glove box.
21. Reinstall all removed parts.
NOTE: Whenever the battery is disconnected, the
driver's window AUTO function is disabled.
22. Start the engine. Push down on the driver's
window switch until the window is fully open.
23. Pull up on the driver's window switch fully to close
the window completely, then hold the switch for
2 seconds or more.
24. Check the window AUTO function by opening and
closing the window with the driver's window
switch.
© 2005 American Honda Motor Co., Inc. - All Rights Reserved.
AII 28615 (0502)
5 of 5