HPRT HT100 Quick Start Manual

Packing List
Quick Start Guide
Printer
AC Adapter
Power Cord
USB Cable
Label Roll
Ribbon
HT100
HT130
Quick Start Guide
CD
Xiamen Hanin Electronic Technology Co.,Ltd
ADD: Room 305A,Angye Building,Pioneering Park,
Torch High-tech Zone,Xiamen,China.
TEL: +86-(0)592-5885993
FAX: +86-(0)592-5885992
WEB:www.hprt.com
!
Note: The packing materials are actually based on the order.
Loading the Roll
Appearance and Components
Front View
Printer Cover
1.Pull and lift the cover.
Cover Open Levers
Rear View
Feed Button
(Status Indicator)
Ethernet Port
Power Switch
Power Receptacle
USB Port
Serial Port
2.Pull the roll holders open and place the roll between
them.
Inside View
Printhead Module
Moveable Roll Holders
Locking Tab
Platen
Kick-stand Cover Lock
Moveable Label Guides
Moveable Label Sensor
!
Note: The views above are for your reference. Ports vary
by your choice.
Rev.1.0
Quick Start Guide
-1-
3.Press down the locking tab.
4.Pass the labels through label guides and adjust label guides
to label’s width.
Rear Ribbon Wheel
Front Ribbon Wheel
Loading the Ribbon
1.After putting rewind spindle through printhead module, insert the right side of supply spindle into the rear pin, and then insert the
left side into the rear wheel. Then do the same procedure for the ribbon rewind spindle.
Ribbon Supply Spindle
Front Ribbon Pin
Rear Ribbon Pin
Ribbon Rewind Spindle
2.Rotate the front ribbon wheel until the ribbon is pulled tightly.
3.Press the lock and close the cover slightly.
4.Press down the cover until it snaps closed.
1.Make sure the printer’s power switch is in the off position.
2.Connect the AC adapter to power receptacle.
3.Connect the power cord to AC adapter.
4.Connect the other end of power cord to the outlet.
Connecting the Power
ON
OFF
1
3
2
AC Adapter
!
Rev.1.0
-2-
Power Cord
4
Varies by regions
Note: Please refer to windows driver installation in
HT100+HT130 User Manual.
">