Hiti
L
User Manual
Hiti Digital, Inc.
www.hiti.com
L user manual
English
General Information
Copyrights
All rights reserved. The information contained in this user’s manual is subject to change without notice. Hiti Digital
Inc. makes no warranty with regard to the material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Hiti Digital Inc. will not liable for errors contained herein or for incidental
or consequential damages in connection with the furnishing, perf ormance, or use of the material.
Safety Precautions
1. Never attempt to disassemble for modify the printer. Doing so may lead to electric shock or malfunction.
2. Do not allow liquids near the printer, which may lead to electric shock or fire.
3. Do not use the printer if the printer body is damaged.
4. Avoid plugging in the printer into a jack being used by couple appliances.
5. Do not put the printer on an unstable cart, stand, or table.
6. Make sure the printer is operated under the type of power indicated on the marking label. If you are not
sure the type of power, please consult your dealer or local power company for detail.
7. Do not block air vents protecting the printer from overheating.
8. Do not disable the safety purpose of grounding type plug. Use the power supply cord only in combination with
an earthed socket-outlet.
9. The socket-outlet shall be installed near the equipment and shall be easily accessible.
10. The equipment shall be used at maximum 40°C ambient temperature.
11. An approved power cord greater or equal (e.g. H03VV-F (for EUT weight 3kg), H05VV-F (for EUT weight >
3kg), 2X or 3G, 0.75mm2) must be used.
FCC Notice
Do not make any changes or modifications to the equipment unless specified in the instruction. This equipment
has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
1.Reorient or relocate the receiving antenna.
2.Increase the separation between the equipment and receiver.
3.Never push objects into this equipment through cabinet openings, which may touch dangerous voltage
points or short out parts that could lead to a fire or electric shock.
4.Never spill liquid on this equipment.
5.Connect the device into an outlet on a circuit difference from that to which the receiver is connected.
Trademarks
Microsoft, MS-DOS, and Windows are registered trademarks of Microsoft Corporation. Adobe and Acrobat are
registered trademarks of Adobe Systems Incorporated. Mac, Macintosh, and Mac OS are trademarks of Apple
Computer, Inc., registered in the U.S. and other countries. Pentium is a U.S. trademark of Intel Corporation. All
other trademarks or registered trademarks are properties of their respective companies.
2
L user manual
1. Checking Package Contents
2. Getting the Latest Update
3. Introduction of Printer
● Top
● Front
● Rear
● Sides
4. Making Printer Ready to Print
● Installing the ribbon cartridge
● Installing the paper box
a.Assembling the paper roll and flange
b.Putting the paper roll into paper box
c.Inserting the paper box to the printer
● Powering up the printer
5. PC-Link Printing
● System requirement
● Connecting the printer to a PC
● Installing the printer driver
6. Photo Finishing By PC-Link Printing
7. Specification
3
English
Table of Content
L user manual
English
Checking Package Contents
Photo Printer
Hiti P510L
Flange x2
Spacer x2
USB Cable
Power Cord
Paper Box
P510L Bonus CD
Note
1. If something missed from the package, please contact your local dealer or Hiti
service center nearest to you.
2. Paper roll spacer is NECESSARY only for 5x7 size paper roll installation.
3. Consumables are EXCLUDED.
Getting the Latest Update
Hiti Digital Inc. website provides the latest driver, application, user’s manual, printer
firmware, and so on for users to download. Please visit our website at www.hiti.com
for more information.
Any questions toward Hiti product(s), please contact your local service center for detail.
4
L user manual
English
Introduction of Printer
Top
Output Tray
Front
Ready / Error
Indicator
Rear
USB Device Socket
Vents
Video-Out Socket
Power Switch
Power Cord Socket
Sides
Vents
5
L user manual
English
Making Printer Ready to Print
Installing the ribbon cartridge
Installing the paper box
a. Assembling the paper roll and flange
Paper Core
Paper roll
1
2
3
1 = Flange (Two colors)
2 = Spacer
(Necessary only on 5x7 size paper roll installation)
3 = Paper roll
Upon assembly, please install the spacers in the paper flange (green) and
paper flange (orange) first when using 5x7 size paper roll. The two spacers
are identical.
Match the notch of paper flange and the notch of paper core. Note that one
side of paper core has 2 notches, and the other has 3 notches.
(After assembly)
6
L user manual
English
Making Printer Ready to Print
b. Putting the paper roll into paper box
Flip the paper box as shown, and
then press the box button to open
the box.
Remove the seal from the paper
after setting the paper roll, and
then pull out the paper so that it
comes out across the box edge.
(Open the box)
Place the paper roll into the box as
shown, make sure the color of paper
roll flange is in consistency with
same color of flange holder inside
the box.
Rotate the knob counterclockwise to
draw back protruding paper until it’s
straight and aligns with paper box
bottom edge as shown.
Close the box
c. Powering up the printer
1
Load the paper box into the printer
and then close the front door to
finalize the installation.
2
After the printer is turned on, your
printer is ready for use.
7
L user manual
English
PC-Link Printing
Before working on photo finishing, please make sure you have followed the User’s Manual booklet supplied for
printer installation. Please pay particular attention to the safety instructions.
The printer driver enables you to do photo printing through a computer. Please see below for the system requirement of a PC.
System requirement
Intel Pentium or compatible PC
Windows 2000/ XP (32/64 bit)/ Vista (32/64 bit)/ Win7 (32/64 bit), Mac OS X 10.2 to 10.6
128MB RAM or higher
100MB or more free hard disk space
CD-ROM or DVD-ROM drive
Connecting the printer to a PC
Please connect the printer to your PC via supplied USB cable. If it is missing
in the package, please reach the local dealer or contact Hiti customer service
center nearest to you.
8
L user manual
English
PC-Link Printing
Installing the printer driver
1. Make sure the printer is turned off
2. Insert the CD into CD/DVD ROM, and then the computer will automatically start the installation. If the
installation does not start automatically, please run the autorun.exe file in the driver CD.
Press [ Start ] for driver installation
You might be informed the security and asked
for installation. Please select “Install this
driver anyway” to continue.
3. If the driver is successfully installed, you got to turn on the printer. After turning on, your PC will find new
hardware and ask for your advice.
New hardware found, please select
“Locate and install driver software” to
finalize the driver installation
Installation complete, please turn on
the printer
9
L user manual
English
Photo Finishing By PC-Link Printing
Software: Windows Photo Gallery
Step 2: Click the icon [
Step 1: Select an image and use Windows Photo
Gallery to browse
] and choose “Print”
Step 3: Print pictures
Make sure P510 is truly selected
Click “Print” to photo finishing…
10
L user manual
Please note that specification of P510L is subject to change without notice.
Item
Description
Resolution
300 x 300 dpi
Max Prints Size
6x9 borderless
Printing Speed (6x4)
Approx 12 sec
Capacity
4x6: 330 images
5x7: 190 images
6x9: 150 images
Printing Category
4x6 / 5x7 / 6x8, and 6x9. All sizes “2-UP” supported
Driver
Windows 2000/XP (32/64-bit)/Vista (32/64-bit)/Win 7 (32/64-bit)
Mac OS X v10.2 to v10.6
Power Requirement
AC 100 V~240 V, 50 / 60 Hz
Operation Condition
10°C~35°C / 50°F~95°F; 20~75% non-condensing
Dimension & Weight
392x298x245mm, 30lbs (consumables excluded)
*Video-out: It is relatively appropriate for use of Passport/ID photo editing. Due to limited resolution, the display quality may vary accordingly.
11
English
Specification
2011 Hiti Digital, Inc.
P/N:39.D1700.001
">
