MO-EL HOT-TOP Medium Use And Maintenance Manual

Longwave infrared heater
MANUALE D`USO E MANUTENZIONE
USE AND MANTAINANCE
EMPLOI ET ENTRETIEN
GEBRAUCH UND WARTUNG
USO Y MANTENIMIENTO
USO E MANUTENÇÃO
(DICITURA IN ARABO)
1
Classe 1-IP55
Introduction to the product
HOT-TOP is the IR-C heater
which surrounds you with his
soft and cozy warmth.
environment for feeling good.
It is perfect for restaurants,
offices,
supermarkets,
factories and patios.
HOT-TOP is perfect in focusing
its warmth in defined areas
indoor or outdoor. You can use
it as long as you like, since
its warmth is invisible. You
won’t see any luminous ray,
but it functions like the sun,
warming the bodies instead the
air. For this reason there is no
need to warm-up the complete
It emits no light on, but as the
sun radiating bodies without
heating the air, dedicating
his warmth to people. Other
types of heating, however,
must first warm up the entire
environment
before
you
receives the benefit.
Technical specifications
Supply voltage
220-230 V
50-60 Hz
Insulation class
240 V
50-60 Hz
I
IP level
IP55
Emission spectrum
IR-C
2
120 V
60 Hz
Benefits
HOT-TOP means soft warmth
and swaths your body making
you feeling like closed to a
chimney corner.
resistances on duct have been
volcanized with silicon in order
to make them lasting longer
and longer.
HOT-TOP doesn’t dry the air
and doesn’t lift dust.
Design, engineering and
production made in Italy.
It doesn’t need gas or propane,
for this reason it doesn’t emit
any combustion refuse.
In comparison with gas heating
its maintenance is easier and
cheaper.
Designed by Pino Spagnolo it
matches a decorating element
with an heavy duty heater.
Its efficiency is higher,
if compared with other
tubular heaters on duct,
because its shape enhances
the front radiating surface
and decreases the warmth
dispersion from the rear
side. It is also for this reason
that the minimum distance
from the wall or the ceiling is
shorter.
It can be easily installed
on walls or ceilings. Its
accessories permit you to
adjust it at your desire.
The models rated IP55 are
perfect for OUTDOOR use.
3 years warranty
The top quality material and
strongest surface casting
make it more resistant
than ever. Weather and use
won’t damage it. The tubular
3
Safety instructions
Instructions should be carefully read before installation
and retained by the user. The booklet must be keeped
and delivered to the new user in case of cession of the
machine. The Manufacturer reserves the right to vary
the features of the product without prior notice. The
technical data are merely indicative.
1.
This appliance is intended solely for the use it has been
designed for, namely room and people heating. The
Manufacturer is not responsible for any damage that could
happen for improper use.
2.
After unpacking make sure that the appliance is complete
and shows no signs of visible damage or tampering.
3.
The device can be used by children at least 8 years (as well
as by persons with reduced physical, sensory or mental
capabilities, or lack of experience or required knowledge)
provided that they are under surveillance, or after they have
been instructed relating to the safe use and have understood
the potential dangers. Children should not play with the
appliance. Cleaning and maintenance must be performed by
the user and not by unsupervised children.
4.
- Children of less than 3 years should be kept away unless
continuously supervised.
- Children aged from 3 years and less than 8 years shall only
switch on/off the appliance provided that it has been placed
or installed in its intended normal operating position and they
have been given supervision or instruction concerning use
of the appliance in a safe way and understand the hazards
involved.
- Children aged from 3 years and less than 8 years shall not
plug in, regulate and clean the appliance or perform user
maintenance.
4
5.
Children should be supervised to ensure that they do not play
with the appliance.
6.
Do not use in presence of gas, inflammable or explosive
liquids or substances. Defined in BS5345.
7.
Some fundamental rules which apply to all electrical devices
must be observed when using the heater:
- Do not touch the heather with wet hands.
- Do not handle with bare feet.
- Do not let children play with the electrical appliance.
8.
Do not apply any modification to the product.
9.
Keep connections dry.
10. If the power supply cord is damaged, avoid to use the appliance.
For power cord replacing, please contact the manufacturer
or the technical service or a person with similar qualification,
in order to avoid any risk.
11. If the appliance is not used for a long period, disconnect it
from the power supply.
This heating appliance does not feature a device to
control ambient temperature.
Do not use it in small rooms used by people who are
unable to leave such rooms on their own unless they
are under constant surveillance.
All users should be made aware of all aspects of
operation and safety and these instructions should be
retained for reference.
5
Model and warmth diffusion
95mm
58mm
202mm
1,1m
2m
1,6m
Small
POWER 1500W
RADIATE AREA 3150cm²
RANGE 5 m²
2m
WEIGHT 5,7kg
1,25m
2,5m
1,8m
Medium
POWER 1800W
RADIATE AREA 3650cm²
RANGE 7 m²
2m
WEIGHT 6,4kg
6
Temperature increase
+5
+10
1,55m
+16
3m
2m
Large
POWER 2400W
RADIATE AREA 4575cm²
RANGE 9 m²
2m
WEIGHT 7,8kg
1,95m
4m
3m
Extra Large
POWER 3200W
RADIATE AREA 5850cm²
RANGE 12 m²
WEIGHT 9,8kg
2m
7
Remote-controlled model
Dimmer Module
For maximum flexibility all
models are available with
dimmer to adjust the intensity
of the heater comfortably by
remote control.
- Insert into the remote
control 2 batteries 1.5V
AAA (not included),
matching the polarities.
- Connecting the machine:
the blue LED lights
flashing.
The length of each model
increases by 15 cm, while
the width and height remain
unchanged.
- Use the remote control
as shown in figure.
8
LOW
select 1/3 of power:
the blue LED lights
on.
HIGH
select max power:
the red LED lights
on.
POWER
MED
select 2/3 of power:
the violet LED lights
on.
ON
ignition device,
which leads LOW
power.
OFF
shutdown device.
9
Safety distances
30cm
180cm
-
The heater must be installed at a
minimum height of 180 cm.
-
If installed in a toilet, the height should
be 225 cm in zone 1 and zone 2; in zone
3 the minimum above ground level is
180 cm, according with the rules of each
Country.
-
A minimum air gap of 30 cm should
always be allowed between the top of
the heater and a ceiling or roof. The
appliance should be 50 cm far from the
walls
50cm
50cm
10
-
The heater must not be directed towards
the ceiling or flammable materials.
-
The device must not be mounted into the
ceiling. You must leave enough space
around the top of the unit to ensure good
ventilation.
-
Do not use the heater in close proximity
of a bath, shower or swimming pool.
-
If there is nobody in the room to be
heated, it is recommended to turn off the
unit.
Wait 15-20 minutes after power to reach the
maximum temperature.
11
Provided wall/ceiling support
cod. 004456
The support to be fixed to the wall
presents a series of holes that
allow to fix the heater in different
positions.
12
Optional supports
Twin
cod. 7704
End to end
cod. 7705
Extension
cod. 7706
13
Mounting
Before being used, the heater must be fixed to
the wall or to the ceiling by means of the provided
supports.
1.
9,6cm
Drill four holes in the wall
as shown below.
* recommended value:
Small 80cm*
Medium 95cm*
Large 125cm*
Extra Large 180cm*
2.
Fix the two supports to
the wall using dowels of
appropriate size.
Ensure that the wall
where you intend
to attach the device
is solid and that
within it do not pass
electric cables or
water pipes.
14
3.
4.
Insert the archshaped support
in the special rail
on the upper side
of the device.
Align the holes of the supports and join them together using
the supplied bolts, setting the desired inclination.
Ensure that the heater turns her rays in the area to be heated.
Firmly tighten the screws when finished.
15
Electrical installation
Warnings
Before connecting the appliance make sure that
the voltage is the same as indicated on the device
and the line supply is corresponding to the effective
rules.
The installation should always be carried out by a qualified
electrician or a competent person in accordance with the current
electrical standards:
HD 384 CENELEC for Mainland Europe, IEC 60446 and BS 7671
for the United Kingdom, IEC 60445(2010) & ET101:2008 for Ireland
and IEC 60364-7-708 1988 Internationally.
The energy supply to the heater must always be properly earthed.
The appliance must be connected to energy supply line by means
of the provided H05SS‑F silicone cable.
An overvoltage category III Combined Circuit breaker and Residual
Current Device (RCD) with rated earth leakage operation not
exceeding 30mA must be fitted upstream on the supply line. The
circuit breaker must have a contact opening distance of at least 3
mm.
The product is in class I and IP55, wich is the protection rate for
the units to be used even outdoor. For keeping the protection rate
of the appliance, the connection of the appliance with the power
supply must be done by means of a minimum IP55 system, as per
the standards HD 384 CENELEC for Europe, or international IEC
60346-7-708 1988.
16
Circuit
breaker
RCD
Fuse*
Active
Neutral
Earth
* 10A (mod. 9815 - 9818)
16A (mod. 9824 - 9832)
Additional information
– Under no circumstances turn the appliance on if it is on any
surface.
- A safety distance of not less than 100 cm should always be left
in front of the heaters or too near.
- The appliance must not be located neither directly below, nor
in front of a socket-outlet.
- The heater must be installed so as to prevent that the switches
can be touched from those who are in the shower.
- Avoid the use of an extension cord with this product, because
the extension cord may overheat and cause a risk of fire.
- Ensure that there is no possibility of inflammable material,
combustible material or curtains coming into contact with the
heater, or lie near the heater.
17
Care and cleaning
Before cleaning, be sure the appliance is disconnected
from the power supply and allowed to cool.
Never immerse the appliance in water or any other
liquid.
To clean, use a soft damp cloth and then dry thoroughly. Make sure
all parts are dry before using again.
Avoid the use of harsh detergents, solvents, and abrasive or aerosol
cleaners as they may damage surfaces.
Technical service
Always disconnect the appliance before doing any
maintenance operation.
Cleaning and maintenance must be performed by the
user and not by unsupervised children.
To avoid risk of failures it is necessary to operate the unit for a few
hours every 6 months.
If you have any question relevant your appliance, call the local
authorized distributor or the nearest Service Centre. Every repairs
should be carried on by an authorized Service Centre and also ask
always for original spare parts.
18
Disposal
This product conforms to EU Directive 2002/96/EC.
This appliance bears the symbol of the barred waste
bin. This indicates that, at the end of its useful life, it
must not be disposed of as domestic waste, but must
be taken to a collection centre for waste electrical
and electronic equipment, or returned to a retailer
on purchase of a replacement.
It is the user’s responsibility to dispose of this appliance through
the appropriate channels at the end of its useful life. Failure to do
so may incur the penalties established by laws governing waste
disposal.
Appropriate separate collection for the subsequent dispatch of the
appliance for recycling, treatment and environmentally compatible
disposal helps prevent negative impact on the environment and
human health and promotes recycling of the materials making up
the product.
For more detailed information regarding the collection systems
available, contact your local waste disposal service or the shop
where you purchased the product.
Producers and importers comply with their responsibility for the
recycling, treatment, environmentally friendly disposal, either
directly or by participating in a collective system.
19
Mo-El S.r.l.
Via Galvani 18, 42027
Montecchio Emilia (RE) ITALY
Tel.: +39 0522 868011
Fax: +39 0522 864223
[email protected]
www.mo-el.com
20