IMPORTANT:

Please keep this User Manual & your Warranty Card safe for future reference. Follow the operation & maintenance guide-line/ recommendation as highlighted herewith.

Technical assistance / trouble-shooting through customer-care phone line is at our level best effort only. Any field service request will be charge-able if due to user mis-use. For further details, please refer

Warranty Card (attached separately).

User Manual

Hydro One Outdoor POE

Membrane Water Filter

Hydro One Marketing Sdn. Bhd.

(648758-P)

32, Jalan Bukit Rawang Putra 6,

Taman Bukit Rawang Putra,

48000 Rawang, Selangor Darul Ehsan, Malaysia.

Tel : +603 - 6092 0120

Fax : +603 - 6092 0305

Email : [email protected]

Website : www.hydro1.com.my

Ball Valve’s handle position at Open/ Close condition.

Refer to Piping Connection & Installation Reference Diagram in previous page to identify the position of Ball Valve at Inlet (#1), Outlet (#5) & By Pass (#2) pipe.

Filter Mode

Inlet (#1) & Outlet (#5) Ball Valve should be opened for filtration operation. Bypass Valve (#2) should be closed all the time.

Forward Flushing Mode

Forward Flushing will be performed automatically by the battery operated Auto Timer

Controller (#7) or manually by turning on the manual garden water tap.

By Pass Mode

To by-pass the water filter, mainly during maintenance/ service, open the By Pass Valve (#2) and close the Inlet (#1) & Outlet (#5) Ball Valve. This will isolate the filter and let direct water supply into house.

Back Flush Mode

Back Flush Mode is recommended to perform by user manually once a week to keep the filter performance always at optimum level. Close the Inlet Valve (#1) and open the

Bypass Valve (#2). Turn on the Auto Timer Controller (#7) manually, or the manual garden water tap, to discharge flushing water until it runs clear. Resume the original position of the

Inlet (#1) & Bypass (#2) valve once done. Repeat the procedures all over again for few times until the discharge water is clear. Make sure the Inlet (#1) & Bypass (#2) are restored to its original position as shown in diagram.

NOTE:

Chemical solution cleaning for the membrane system is recommended after 12~18 months of operation, however, necessity will be subjected to water supply quality of individual site.