Installing the Drive
Before installing the drive, turn
off the system power.
Disconnect the power
cord, and remove the
cover.
• Remove a vacant 5.25” drive bay panel
from the computer. Slide the drive into
the drive bay.
Connecting the SATA
Power Cable
• Connect the power cable so the
projection of the cable connector side to
come to the left side. Be careful not to
connect upside down.
NOTE:
Improper connection may damage the
drive and void the warranty. Generally,
the power connector can only fit one way.
Red
Connect to the
power connector of
the PC.
Connecting the SATA Data
Cable
• Connect the data cable. Be careful not to
connect upside down.
Replace the cover,
connect the power cord
and restart your computer.
• Your computer configuration may different
from the illustrations.
NOTE
Please pay attention to handling Electrostatic
Sensitive Devices, you may use anti-static
products such as wrist straps, heel straps, mats to
protect your body from electrostatic.
Connect to the SATA connector
on the PC's Motherboard.
Quick Set-up Guide
Super Multi DVD Writer
GH24
To install of your product, please read this guide manual carefully and completely.
Features
System Environment
•
•
•
Computer
•
•
Serial ATA interface.
Power tray loading and ejection of disc. (The disc can also be ejected manually.)
Combination CD-R/RW, DVD-R/RW, DVD-R DL, DVD+R/RW, DVD+R DL,
DVD-RAM Drive functions into one drive.
Supports Region playback control Phase II.
Automatic buffer underrun error prevention technology.
• You may experience lower write quality in case if you use disc products by some disc makers which those are not registered with the product's firmware.
Therefore, it is recommended that you use only discs by recommended companies. And
even if the write session is completed successfully, check the write quality before you put
the disc in storage, especially in case of an important data backup.
(Manufacturer is not responsible for any loss resulting from data backup failure.)
• Under Windows 8 operating system, a specific mainboard with nVidia GeForce 7025
Chipset may cause an abnormal operation.
This unit can be operated in the system environment explained here.
CPU: Motherboard that supports Serial ATA. (Recommended Pentium IV 3.2GHz or
higher.) RAM:512MB or higher.
128MB or higher.
20GB or more free space.
(The free space needed for writing depends on the quantity of data.)
Serial ATA
Interface
13.34 cm (5.25-inch) half-height bay required
Drive bay
Power
+5V/+12V power socket required
Software Required OS Windows 8.1, 8/ Windows 7/ Windows Vista(X86, X64)/ Windows XP [Home Edition/
Professional/Media Center Edition] with SP3 or higher,Direct X 9.0 or Higher is required.
Recommended media CD-R : LG, Mitsubishi Kagaku Media, Verbatim, Taiyo Yuden or TDK discs are
recommended.
manufacturer
CD-RW : Ricoh, Mitsubishi Kagaku Media, Verbatim discs are recommended.
DVD-R : Mitsubishi Kagaku Media, Verbatim are recommended.
DVD-RW : Mitsubishi Kagaku Media, Verbatim are recommended.
DVD+R : Mitsubishi Kagaku Media, Verbatim are recommended.
DVD+RW : Mitsubishi Kagaku Media, Verbatim are recommended.
DVD-RAM : Maxell, Panasonic are recommended.
M-Disc (DVD+R SL) : Millenniata
DVD+R DL : Mitsubishi Kagaku Media, Verbatim are recommended.
DVD-R DL : Mitsubishi Kagaku Media, Verbatim are recommended.
System
requirements
VGA Card Memory
Hard disk
* Compatibility problem in write/read function may occur with media depending on the media
manufacturing quality.
* Upon the media condition or some of user’s enviroment the maximum speed sometimes could not be
guaranteed.
* Please visit http://www.m-disc.com to learn more about the M-DISCTM.
Specifications
Items
Items
General
Host Interface
Serial ATA
Supported Discs
DVD-ROM(Single/Dual), DVD-RW, DVD-R, DVD-R Dual layer, DVD+RW,
DVD+R, DVD+R Double layer, DVD- RAM, M-Disc (DVD+R SL),
CD-Digital Audio & CD-Extra, CD-Plus, CD-ROM, CD-ROM XA-Ready,
CD-I FMV, CD-TEXT, CD-Bridge, CD-R, CD-RW, Photo-CD
(Single & Multi-Session), Video CD, DVD-VIDEO
Disc Diameter
12cm/ 8cm
(8cm disc can be used only with drive placed horizontally.)
Mounting direction Horizontal/Vertical
Burst transfer rate
SATA Gen.1 1.5 Gbps
Average Access
CD-ROM: 125 ms (Typical)
DVD-ROM : 145 ms (Typical)
DVD-RAM (Ver. 2.x) : 270 ms (Typical)
Buffer capacity
MTBF
Environmental Level
When operating
When not operating
Read/Write Speed
Write : DVD-R : 2 x, 4 x, 8 x, 16 x, 24 x
DVD-RW : 2 x, 4 x, 6 x
DVD+R : 2.4 x, 4 x, 8 x, 16 x, 24 x DVD+RW : 2.4 x, 4 x, 6 x, 8 x
DVD+R DL : 2.4 x, 4 x, 8 x
DVD-R DL: 4 x, 8 x
DVD-RAM: 2 x, 3 x, 5 x
M-Disc (DVD+R SL): 4 x
CD-R: 16 x, 32 x, 40 x, 48 x
CD-RW: 4 x, 10 x, 16 x, 24 x
Read : DVD-ROM (Single/Dual) : 16 x/12 x max.
DVD-R : 16 x max.
DVD-RW : 13 x max.
DVD+R: 16 x max.
DVD+RW: 13 x max.
DVD+R DL : 12 x max.
DVD-R DL: 12 x max.
DVD-RAM (Ver. 2.x): 5 x max.
M-Disc (DVD+R SL): 12 x max.
CD-R/ROM: 48 x max.
CD-RW: 40 x max.
CD-DA(DAE): 40 x max.
0.5 MB
100000 Power On Hours (Duty Cycle 20 %)
Temperature: 5 °C to 40 °C
Humidity: 15 % to 85 % R.H. (non condensing)
Temperature: -30 °C to 60 °C
Humidity: 10 % to 90 % R.H. (non condensing)
Electrical
Power
DC 5 V, DC 12 V
Software
Install the appropriate CD Recording Authoring Software before using this unit.
* Please uninstall any previous CD burning software you may have loaded on your PC in
order to prevent possible compatibility issues.
Once you have installed the application software, you may (if you wish) begin to
reinstall previous software, taking note for errors.
We recommend using the drive with the latest software as some problems
encountered when using the drive can be solved by updating the software.
❋ The drive’s appearance and specifications may change without prior notice.
SVC Code: GH24NSB0
Worldwide corporate site : http://www.LG.com
Safety Instructions
CAUTION: The laser used in the Drive can damage your eyes. Do not attempt to open
the cover. To reduce the risk of electric shock, do not remove the cover (or back).
There are no user-serviceable parts inside. Refer servicing to qualified service personnel.
Use of controls or performance of procedures other than those specified herein may result
in hazardous radiation exposure.
PERICOLO : Il dispositivo di lettura e scrittura utilizzato in questo masterizzatore
utilizza un raggio laser che, se osservato da vicino, può danneggiare la vista. Evitare di
smontare il coperchio dell’apparecchio. Al fine di prevenire eventuali folgorazioni, evitare di
smontare l’apparecchio. All’interno dell’apparecchio non sono presenti parti che richiedono
manutenzione da parte dell’utente. In caso di difetti o guasti, rivolgersi ad un Centro di
Assistenza Tecnica. L’esecuzione di procedure diverse da quella espressamente indicate in
questo manuale può provocare pericolose esposizioni alle radiazioni laser.
ATTENZIONE: Al fine di evitare cortocircuiti o principi di incendio, evitare di esporre questo
apparecchio alla pioggia o ad una eccessiva umidità ambientale.
WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to
rain or moisture.
VORSICHT : Der in diesem Laufwerk benutzte Laser kann Ihre Augen schädigen.
Versuchen Sie keinesfalls, die Abdeckung zu öffnen. Um die Gefahr eines elektrischen
Schocks zu reduzieren, sollten Sie die Abdeckung (oder Rückseite) keinesfalls entfernen.
Im Inneren des Geräts befinden sich keine Teile, die vom Benutzer selbst gewartet werden
können. Überlassen Sie die Wartung qualifizierten Kundendiensttechnikern. Beachten Sie
bei der Benutzung von Bedienelementen und der Durchführung von Prozeduren
unbedingt die Anweisungen dieses Handbuchs, da andernfalls gefährliche Strahlung
freigesetzt werden kann.
WARNUNG : Setzen Sie das Laufwerk keinesfalls Regen oder Feuchtigkeit aus, um die
Gefahr eines Brandes oder elektrischen Schocks zu reduzieren.
PRECAUCION: El láser utilizado en la unidad puede dañar sus ojos. No intente abrir la
tapa. Para reducir el riesgo de descarga eléctrica, no quite la tapa (ni la parte posterior).
No hay piezas internas que deba mantener el usuario. El servicio de mantenimiento debe
efectuarlo personal técnico cualificado. El uso de controles o la ejecución de
procedimientos distintos de los especificados en este manual pueden ser causa de
exposición a radiación peligrosa.
ADVERTENCIA: Para reducir el riesgo de fuego o descarga eléctrica, no exponga este
aparato a la lluvia ni a la humedad.
ATTENTION: l'exposition au laser utilisé dans le graveur présente un danger pour les yeux.
N'essayez pas d'ouvrir le capot. Afin de réduire les risques de chocs électriques, ne retirez
pas le capot (ni l'arrière du dispositif). Aucune pièce interne ne peut être remplacée
par l'utilisateur. Pour la maintenance de l'appareil, adressez-vous au personnel qualifié du
service de maintenance. L'utilisation de commandes ou de procédures différentes de celles
spécifiées ci-après peut entraîner une exposition à des rayons dangereux.
CUIDADO: O laser utilizado na unidade pode causar lesões oculares. Não tente abrir a
tampa. Para reduzir o risco de choques eléctricos, não retire a tampa (quer frontal quer
superior). A unidade não contém peças que possam ser reparadas pelo utilizador. Deixe a
manutenção para um técnico da assistência qualificado. A utilização de controlos ou a
execução de procedimentos que não sejam os especificados neste manual podem causar a
exposição a radiações perigosas.
AVERTISSEMENT :Ne pas exposer ce matériel à la pluie ou à l’humidité (risques
d’incendie et d’électrocution).
AVISO: Para reduzir o risco de incêndio ou choque elétrico não exponha este aparelho á
chuva ou humidade.
EU Conformity Notice
FCC COMPLIANCE STATEMENT
LG Electronics hereby declares that this/these product(s) is/are in compliance with the essential requirements and other relevant provisions of
Directive 2004/108/EC, 2006/95/EC, 2009/125/EC, and 2011/65/EU.
Note : This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an Authorized Service Center for help.
European representative :
LG Electronics Inc. - EU Representative
Krijgsman 1, 1186 DM Amstelveen
The Netherlands
CLASS 1
KLASSE 1
LUOKAN 1
KLASS 1
CLASE 1
CLASSE 1
LASER PRODUCT
LASER PRODUKT
LASER LAITE
LASER APPARAT
PRODUCTO LÁSER
PRODOTTO LASER
•
CAUTION : CLASS 3B VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN. AVOID
EXPOSURE TO THE BEAM.
ADVARSEL : KLASSE 3B SYNLIG OG USYNLIG LASERSTRÅLING VED ÅBNING. UNDGÅ
UDSÆTTELSE FOR STRÅLING.
ADVARSEL : KLASSE 3B SYNLING OG USYNLIG LASERSTRÅLING NÅR DEKSEL ÅPENS.
UNNGÅ EKSPONERING FOR STRÅLEN.
VARNING : KLASSE 3B SYNLING OCH OSYNLIG LASERSTRÅLNING NÄR DENNAL DEL
ÄR ÖPPNAD. STRÅLEN ÄR FARLIG.
VARO! : KURSSI 3B NÄKYVÄ JA NÄKYMÄTÖN AVATTAESSA OLET
ALTTIINA LASERSÄTEILYLLE. ÄLÄ KATSO SÄTEESEN.
The appliance is not intended for use by young children or infirm persons without supervision.
•
FCC WARNING
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This product is for use only with UL listed personal computers that have installation
instructions detailing user-installation of card cage accessory.
■
Microsoft® and Windows® are trademarks registered in the United States and other
countries by the Microsoft Corporation.
■
The company names and product names written in this manual are trademarks or
registered trademarks of the respective companies.
">
