CARBON MONOXIDE ALARM CAT. C0250B/CO250LB CO 10YR CO SENSOR 10YR ALARM LIFE ELECTROCHEMICAL CO SENSOR Most accurate technology available for detecting carbon monoxide as compared to other sensing technologies TWO SILENCE FEATURES Silences low battery chirp for up to eight hours or silence nuisance alarm for several minutes. END OF LIFE SIGNAL Provides audible notice when alarm needs to be replaced after 10 years. TAMPER RESISTANT LOCKING PIN Locks alarm cover to prevent removal of battery. Perfect for apartment, dormitory or hotel applications. 9V BATTERY INCLUDED Available in the following versions: CO250B Alkaline Battery CO250LB 5 Year Lithium Battery 9V Battery Powered Description: BRK Model CO250 is a single station carbon monoxide alarm specifically designed for residential and institutional applications including sleeping rooms of hospitals, hotels, motels, dormitories, and other multifamily dwellings as defined in standard NFPA 101. Model CO250 has been fully tested and complies with, UL2034, NFPA 720, and NFPA 101 and other agencies that model their codes after the above agencies. It meets building codes where battery operated carbon monoxide alarms with silence are required. BRK Model CO250 is a state of the art carbon monoxide alarm designed to provide early warning of the presence of carbon monoxide. It features an electrochemical carbon monoxide sensor, an 85dB horn, a full function test switch and a red LED light that indicates DC power or alarm. The CO250B features a 9V alkaline battery and the CO250LB a 9V 5 year lithium battery. This alarm has two silence features. Low Battery Silence: Temporarily silence the low battery chirp for up to eight hours. Alarm Silence: Silence alarm for several minutes. It also features a tamper resistant locking pin that locks alarm cover to prevent removal of battery. Perfect for apartment, dormitory or hotel applications. The compact, low profile design complements any décor. Battery installation and removal can occur while the unit is mounted to the ceiling or wall via the hinged cover. When voltage drops to a pre-set warning level, the horn will “chirp” approximately once per minute to indicate a fresh battery is needed. To insure the battery is always replaced properly, the cover is designed to resist closing when the battery is missing. Designed for wall or ceiling mounting. Includes mounting anchors and screws. CAT. CO250B/CO250LB TECHNICAL SPECS CO TOP VIEW MOUNTING BRACKET SIDE VIEW ARCHITECTURAL AND ENGINEERING SPEC The carbon monoxide alarm shall be a BRK Model CO250 and shall provide at a minimum the following features and functions: 1. An electrochemical CO sensor. 2. The unit shall be capable of self restoring. 3. The unit shall have an “End of Life” signal after 10 years (120 months) of operation. This signal should be capable of temporarily being silenced for up to 2 days. After about 2 days, the signal will resume. After about 2-3 weeks the signal cannot be silenced. 4. Powered by a supervised 9V battery and a solid state piezo horn rated at 85dB at 10 ft. 5. A visual LED power-on indicator to confirm unit is receiving power or is in alarm. 6. A test/silence button to check all alarm functions and to silence any nuisance alarms. In addition, the unit shall have a low battery silence feature to quiet the low battery chirp for up to eight hours. 7. A tamper resistant locking pin should be provided that locks alarm cover to prevent removal of battery. 8. The CO sensor is adjusted not to detect CO levels below 30 PPM and will not alarm when exposed to constant levels of 30 PPM for 30 days. It will alarm at the following levels: 400 PPM CO between 4 and 15 minutes, 150 PPM CO between 10 and 50 minutes and 70 PPM CO between 60 and 240 minutes. 9. The unit shall be capable of operating between 40°F (4°C) and 100°F (38°C) and relative humidity between 10% and 95%. 10. The unit shall contain mounting hardware and shall be listed for wall or ceiling mounting. 11. The unit shall at a minimum meet the requirements of UL2034, NFPA 720, NFPA 101, ICC. INSTALLATION OF ALARM Installation of this CO alarm must conform to NFPA 720. Always check your local building codes. Follow all instructions for placement as outlined in the user’s manual in sections titled “Recommended Locations for CO Alarms” and “Locations to Avoid for CO Alarms”. 1 Alarm Dimensions: 1.6”H x 4.25”Dia Weight: 5.1 oz Operating Voltage: 9V Battery Powered Temperature Range: 40°F (4°C) to 100°F (38°C) Humidity Range: 10% to 95% relative humidity (RH) Audio Alarm: 85dB at 10 feet Test/Silence: Electronically simulates carbon monoxide condition, causing the unit to alarm. Press and hold test/silence button Alarm Reset: Automatic when CO clears CO Sensor: Electrochemical Indicator Lights/Sounds: DC Power: Intermittent Red LED Local Alarm: Audio alarm and rapidly flashing Red LED End of Life: Replace alarm 120 months after installation Listing: Listed to UL2034 Standard SHIPPING SPECS Individual Carton Dimensions Weight 0.39 lbs. Cube 0.02 ft3 UPC 0 29054 00392 8: CO250B 0 29054 00725 4: CO250LB Master Carton Dimensions 12.63”L x 6.13”W x 5.19”H Master Pack 6 Weight 3.2 lbs. Cube: 0.15 ft3 I2of5: 600 29054 00392 0: CO250B 600 29054 00725 6: CO250LB Pallet Information Cases per Layer 36 Number of Layers: 9 Cases per Pallet: 324 Units per Pallet: 1,944 Cube: 55.0 ft3 Weight: 1,107 lbs. THE PARTS OF THIS CO ALARM 2 3 1.“Open Here” 2.“No Battery” tab 3.Test/Silence button tab 4.CO alarm base 5.Standard screw mounting slots 6.Install 9V battery here 7.Locking pin slot 8.Locking pin: Remove and insert in 7 4 6 7 4.38 ”L x 1.75”W x 4.38”H 7 8 ©2015 BRK Brands, Inc. a Jarden Corporation Company (NYSE: JAH) 3901 Liberty Street Road Aurora, IL 60504-8122 All rights reserved 5 brkelectronics.com First Alert is a registered trademark of the First Alert Trust BRK is a registered trademark of BRK Brands, Inc. CM3171
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project
advertisement
© 2021