USER MANUAL TPS-M5/M55/M555
VERY IMPORTANT
Please read this instruction guide before install and using your mini
portable type air conditioner unit.
This instruction manual is the universal-purpose version for the units
that you purchase, it might be slightly different from the ones
described in the manual, but it does not affect your proper
USER MANUAL
TPS-M5/M55/M555
operations and usage.
CAUTION 1. " PLEASE MAKE SURE THE PRODUCT VENTILATES ALL THE TIME "! Please
make sure the inlet and outlet ventilation is not blocked at all times. 2. Operate this unit on a horizontal surface to avoid water leakage.
3. Do not operate this unit in an explosive or corrosive atmosphere.
4. Operate this unit in an ambient of 35 degree centigrade or less.
5. Clean air filter periodically to enjoy the most efficient cooling.
6. When the unit is shut off, please wait at least 3.5 minutes before restarting
this is to prevent the compressor from being damaged.
7. This unit needs at least 7 Amps of electricity to have its compressor
operational. To avoid the household electricity block out, please do not use
any extension cord for this unit.
8. This unit is for indoor cooling, humidifying, dehumidifying and air filtering
(optional).
9. When turning on the unit at the first time, the cool air outlet stepper motor will
operate and then the fan motor and the compressor will start up. The
compressor will work after 3.5 minutes operating hereafters.
10. When the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid hazard.
MINI PORTABLE TYPE AIR CONDITIONER
11. In order to dispose the appliance safely, please remove the batteries from
the unit before scrapping it.
1
- Moves easily from room to room on easy glide castors
12. This appliance is not intended for use by persons (including children) with reduced
- No installation required-just plug into any household
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
power outlet
they have been given supervision or instruction concerning use of the appliance by
- Powerful refrigerated air system cools down the ambience
a person responsible for their safety. Children should be supervised to ensure that
instantly whenever you want.
they do not play with the appliance.
- Dehumidified and filtered air cycle improve breathing
13. Please drain off water when moving the unit.
environments effectively.
14. Do not install the unit in the laundry room.
- Besides the remote control, your one touch electronic pad
15. The unit should be installed according to the national wiring rules.
- 24 hour programmable timer that can be used with either
ATTENTION! 1.
also provides easy-identifying manual operation.
the air conditioning or dehumidification setting
In order to enjoy cool and fresh air, please be
- Unique sleep control function, dehumidification,
humidification and air purification.
reminded that the windows must be remained
- 220-240 Volt 50Hz operation
open at all times for good air ventilation while
- 1.8 meter cord with plug the Mini Portable Air Conditioner is operating.
UNPACKING INSTRUCTIONS 1.
Place the unit in the correct upright position before
unpacking.
CONGRATULATIONS ON YOUR
SELECTION OF A QUALITY MINI PORTABLE TYPE AIR CONDITIONER 2.
Cut the two packing straps.
3.
Slide the carton in an upwards motion and it will release
from the base.
4.
Grip the carry handles located on either sides of the unit
and lift carefully until it slides out of the foam base.
This Air Conditioner has been designed and manufactured to the
highest standards of modern engineering.
Our product not only provides you a remote control to help user
CONTENTS 1 / MINI PORTABLE TYPE AIR CONDITIONER
operate all the functions easily and conveniently but also has below
2 / Remote control
benefits:
3 / User manual
2
3
CONTROL PANEL & DESCRIPTION OF FUNCTION
NAME OF THE PARTS 1.
Control panel
2.
Remote control receiver
3.
Filter of EVA
4.
Cool air outlet
5.
Cool air inlet
6.
Filter of COND
7.
Hot air inlet
8.
Remote control
location
9.
Hot air outlet
10. Filler
11. Drain hole
12. Water tank
(Optional)
Exhaust Hose & Window Kit
4
5
1.
POWER KEY
6.
SPEED
Press to select LOW, HIGH or AUTO fan speed.
Press to turn unit "ON" or "OFF"
If "AUTO" mode is selected during cooling function, fan speed will be automatically
2.
SET
adjusted according the surrounding temperature.
Press this key to select dehumidifying, cooling, humidifying, air delivery or air
7.
purification.
PROGRAMMABLE TIMER
TIMER-ON: The timer-on is used to turn on the unit automatically after the set time
3.
TEMPERATURE REGULATION KEY (+)
is over.
During cooling function:This key raises the preset temperature by 1℃ each time it
1. Press the "TIMER" key at stand-by status to set the time you desired.
is pressed and the maximum limit is 30℃.
2. Once the set hour has come to an end, the unit will turn on automatically.
During dehumidifying & humidifying function:This key raises the preset humidity by
3. Press the "POWER" key before time out, the setting time will be canceled and
5% each time it is pressed and the maximum limit is 90%.
the unit will turn on.
4. You can set the function and fan speed while setting the timer.
4.
TEMPERATURE REGULATION KEY (-)
TIMER-OFF: The timer-off is used to turn off the unit automatically after the setting
During cooling function:This key lowers the preset temperature by 1℃ each time it
time is over.
is pressed and the minimum limit is 17℃.
1. Press the "TIMER" key at operating status to set the time you desired.
During dehumidifying & humidifying function:This key lowers the preset humidity by
2. Once the set hour has come to an end, the unit will turn off automatically.
5% each time and the minimum limit is 30%
3. Press the "POWER" key before the time out, the setting time will be canceled
HUMIDITY SETTING:
and the unit will turn off.
“CO”(continuous)→30%→35%→40%→45%→50%→55%→60%→65%→70%→75
%→80%→85%→90%→“CO” (continuous)circulation.
8.
DEHUMIDIFICATION
When ambient humidity is lower than setting humidity by 2%, compressor will stop
5.
LCD DISPLAY
automatically for 3.5 minutes, and return working until the ambient humidity is higher
The display indicates the current setting temperature or the timer setting. When the
than setting humidity by 2%.
set temperature or the timer is adjusted, the new setting is shown then the display
9.
returns the current set temperature.
※ The display is also used to show error codes should a fault occur, see ERROR
HUMIDIFICATION
1. The unit will stop automatically after four hours operating in this mode. Please put
some water (Approx 0.8L) into the filler and turn it on again.
CODES.
6
7
2. The unit will stop humidifying if ambient humidity is equal to the pre-set humidity.
Otherwise it will work as the humidifying procedure1.
REMOTE CONTROL FUNCTION
3. The fan motor and water motor will work, but compressor doesn’t work.
10. PURIFICATION
When select this function, the purification indicator light will be on and only the fan
motor works.
When the fan motor’s life time is larger than 2000hrs,the indicator light will flash,
and LCD display E8, it means the filter should be changed; Change the filter and
press SPEED button for 3 seconds and alarm reset.(This unit’s filter is the
ordinary one, please choose HEPA filter if need.
11.
SLEEP CONTROL FUNCTION
1. While in cooling mode, press the SLEEP key to set the temperature. It
increases1 ℃ after an hour and at most increases 2 ℃ after 2 hours.
2. Press the SLEEP key again can cancel the setting.
12.
SWING
Press this key and the outlet will oscillate and stop when this key is pressed again.
The outlet will close up automatically when the unit stops working.
13.
On/Off switch
Function “MODE” selector
Hourly programming
ALARM
When the water tank is full,"E4" will be displayed on the display panel. To resume
Automatic fan speed
operation, please remove the rubber cap of the drain hose to drain out the water
High fan speed
firstly. The E4 warning will disappear after draining, and then you can restart the
Low fan speed
unit by pressing the POWER key.
Night operation selector
Temperature selector
Swing
8
9
NOTICE
CONDENSER/EVAPORATOR 1.
This unit can evaporate the condensation and distribute through the exhaust hose
Use a brush attachment with a vacuum cleaner.
automatically.
Casing
2.
When the unit is in the cooling function, it does not need the drain pipe installed.
Please make sure that the rubber cap① is locked on drain hole, when the unit is
When cleaning the filter, please remove it as the picture.
running.
3.
Wipe with a damp cloth and polish with a soft cloth.
When operating the dehumidifying function the “①” rubber cap on drain hose
should be pulled out and install a proper drain hose②,please remove the air
exhaust hose, connect a drain hose to the drain hole and lead the water to the
POWER SUPPLY outside in order to intensify dehumidifying capacity.
(1) Confirm the correct power.
※ When the water tank is full,"E4" will be displayed on the display panel. Please
(2) Insert the plug into the outlet firmly In order to prevent any dangerous
remove the rubber cap“②” of the drain hole to drain out the water first. After the
leakage.
drainage is completed, please restart the unit and then the unit can operate
(3) Don’t pull power wire by force because it will cause damage to power wire.
normally.
MAINTENANCE
PLACE FOR USE PLEASE DISCONNECT THE POWER CORD BEFORE CLEANING.
AIR FILTER
(1) Because the machine distributes hot air, please don’t place or operate in a
narrow place.
(2) In case of dangerous leak, don’t work the machine in a humid place.
1. The air filter located on both sides of the unit can be
removed simply by pulling the frame out.
(3) Don’t place the machine in a sunlit corner otherwise the unit might shut
down due to overheating and the color of the machine may soon fade out.
2. Wash the filter with cool water (cooler than 40℃) every
two weeks, and put filter back after it air-dried naturally.
10
11
HELPFUL HINTS
SPECIFICATION The unit is fitted with a special thermal cut off device.
Model No.
Please ensure the unit is not placed against objects which will obstruct air
Power Source
intake e.g. furniture or curtains as this will affect its performance dramatically.
Rated Power (EN60335)
Cooling
360W
Cooling Capacity
900W
TROUBLE SHOOTING Cause E1
Electrical short on both
temperature sensor and
PCB
Electrical short of
temperature sensor
copper tube and PCB
wiring
Indicates water tank full or
possibly the incorrect
wiring of plug
Contact an electrician for repair
Filter’s life time is larger
than 2000hrs
Change the filter and press SPEED button
E4
E8
220-240V~50Hz
25liters/day
Moisture Removed(30℃ RH80%)
Problem E2
TPS-M5/M55/M555
Trouble shooting Contact an electrician for repair
Humidifying capacity
0.2L/H
Refrigerant
R410A
Water Tank Capacity
2.6L
Dimensions (mm)
285Wx 375Dx 500H
(CE) N 842/2006:
User needs to pull out the rubber stopper
which is located at the bottom of the unit, to
drain the water away. Check that the plug
has been wired correctly.
R410A is a kind of fluorinated greenhouse gases covered by
the Kyoto Protocol.
Its total global warming potential (GWP) is 1975
for 3 seconds and alarm reset.
All features and specifications of mini portable type air conditioner stated
in this manual are provided by the manufacturer
This marking indicates that this product should not be disposed with
other household wastes throughout the EU. To prevent possible
hazards to the environment or human health from uncontrolled
waste disposal, please recycle it to prove the sustainable reuse of
material resources. Please ask return and collection systems or
contact the retailer where the product was purchased to return your
used device, they can recycle products safely.
12
13
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement