+

Untangled Pro

+

Children’s Bluetooth Headphones

Now With SharePort ® Technology

INSTRUCTION MANUAL

——————————-

1

SAFETY INFORMATION

1.

Please follow all local, state, and federal laws concerning electronic equipment.

2.

Please follow the Instructions of the crew when traveling by airplane in order to comply with any civil aviation laws.

3.

Please check with your doctor before using these if you use personal medical equipment (such as a pacemaker).

4. Please do not disassemble or modify the headphones. Aside from losing the warranty, it could be dangerous

SPECIFICATIONS

Headphones

1.

Bluetooth® Protocol Standards: Bluetooth V4.0

2.

Receiver Range: approximately 10 meters / 30 feet

3.

Carrier Frequency: 2402MHZ - 2480MHz

4. USB Interface: High speed USB2.0

5.

Battery: chargeable lithium-Ion polymer battery (3.7V/ 400 mAh)

6.

Charger Power: Use with DCSV (SOOMA) base units or a computer

7.

Battery Life: 180 hours standby. 12 hours listening

8.

Frequency 20Hz - 20kHz

9.

SIM Ratio: QSdB (Line-in)/60dB (Bluetooth)

If the headphones run out of battery they can still be used with the Included 3.5mm audio cable as if they were a corded high quality headphone Instead of a Bluetooth® pair.

Speakers

1.

Speaker Diameter: 40mm

2.

Frequency Response: 20HZ - 20kHz

3.

Volume Limited to 93db +/- 2db at 1kHz

4. Impedance: 32 ohms

Microphone

1.

Microphone Size: 4mm x 1.5mm

2.

Directivity: 360 degree

3.

SPL: -42 +/- 3dB

4. Impedance: less than or equal to 2.2k ohms

5.

Frequency Response: 30Hz - 16000Hz

6.

Operating Voltage: 4.5V

INSTRUCTION MANUAL

——————————-

2

BUTTONS AND INDICATORS

LED INDICATORS

Operation

Power On

Pairing

Power Off

LED Indicator Status

Blue LED flashing

Blue/Red LED alternating & flashing

Red LED on then turns

Off

Action

Press and hold the power key for 2 seconds until the blue LED blanks

Press the power key for

5-6 seconds until the blue and red LED flash alternately (done from power off mode)

Press the power key for 3 seconds until the red

LED blinks and turns Off

INSTRUCTION MANUAL

——————————-

3

Charging

Fully Charged

Pairing Successful

Call receiving

In Conversation

Low Battery

Red LED remains on until fully charged, then turns blue.

Blue LED on

Blue LED blinking

Blue LED blinking quickly

Blue LED blinking

Red LED on full time

Connect the headphone to the Included micro use and plug Into computer or base station for charging

While connected to a power source, the blue LED will be on

The blue LED will flash then turn off

The blue LED will flash quickly and repeatedly until you press the power key to answer the call

The blue LED will flash every 5 seconds

When the battery has less than

20% remaining the red LED will come on and remain on until fully discharged or re-charged

TONE INDICATORS

Power on

Pairing

Power Off

Pairing successful

Call Receiving

In Conversation

1 high beep

2 Consecutive high beeps

1 low beep followed by

1 high beep

2 consecutive high beeps

Device Ring tone

1 beep upon answering

Press the power key for

1-2 seconds

Press the power key for 5-6 seconds (done from power off mode)

Press the power key for 3 seconds

None

Press power key to answer call

Press power key to answer call

INSTRUCTION MANUAL

——————————-

4

PAIRING THE HEADPHONES

Your Untangled Pro™ Children's Bluetooth® Headphones can be used with most electronic devices that support

Bluetooth® technology. For computers, you may need to consult with your manufacturer to confirm the

Bluetooth® driver is installed so the headphones can pair properly.

For computers, mobile phones, tablets, phablets and the like, you should consult your user manual In order to find the Bluetooth® settings on your device.

Once you have confirmed that your device is able and ready to be paired, please follow these steps to complete the process:

1.

Set your computer or other device into pairing mode by following the device's instructions to turn on

Bluetooth®.

2.

With the power off on your Untangled Pro™ Children's Bluetooth® Headphones, press and hold the power key for 5-6 seconds until the LED Indicator alternates between red and blue flashes.

3.

Now on your computer or device you should see the equipment called 'Untangled Pro' and once you select it the pairing process will be complete.

4. Once the pairing is successful the blue LED will flash several times to confirm.

5.

If the pairing is unsuccessful please turn off the headphones and repeat steps 1 through 5.

USING THE HEADPHONES

1.

Since these are going to be used by your child or children, it is recommended that you use your devices built-In volume limiter and restrict the maximum volume allowed of our volume limited headphones (this limiting feature may not work with some Bluetooth devices but should work with wired devices). Turn the headphones to full volume using the switch on the bottom of the headphone. Then, on the device, limit the volume accordingly. You can consult with your device's user manual or a do a quick web query to locate the volume limit setting.

2.

Please be sure to correctly wear the headphones as well.

3.

The L should go on the left ear and the R should go on the right ear.

4. If you need to clean the product please use a dry and soft cloth.

5.

Once the product has less than 20 percent battery remaining, the red LED Indicator will come on.

6.

Power On: When they are powered off, press and hold the power button for 2 seconds until the blue LED flashes and you hear the power up tone accordingly.

INSTRUCTION MANUAL

——————————-

5

7.

Power Off: When they are powered on, press and hold the power button for 3 seconds until the blue LED flashes and you hear the power down tone accordingly.

8.

Volume Adjustment when listening to music or taking a call holding the volume dial forward (volume +) will increase the volume until you reach the maximum and holding the volume dial backward (volume -) will decrease the volume until you reach the minimum.

9.

Pause/Play. When playing music, press the pause/play switch one time to pause and one more time to resume playing.

10. Previous/Next when playing music press the Next dial one time to go to the next song or press the

Previous dial one to go back one song

USING AS A PHONE

1.

The blue LED will flash blue every 5 seconds while you are holding a conversation

2.

Answer Calls: If you are listening to music and paired with a mobile phone, when a call comes through you will hear a notification tone. By pressing the power button you will switch to conversation mode automatically and the song you are listening to will be paused throughout the duration of the phone call.

3.

Reject Calls: If you are listening to music and paired with a mobile phone, when a call comes through you will hear a notification tone. By pressing the power button down for 2 seconds, you will reject the phone call.

USING THE SHAREPORT®

1.

We have included the SharePort so that your children can easily share their audio with you or their friends. In either Bluetooth or wired mode, just plug in another 3.5mm audio cable to the SharePort and start listening!

WARRANTY & SATISFACTION GUARANTEE

We have a 100% Satisfaction Guarantee so if you aren’t fully satisfied, please reach out to us by email with your order number, photos of the problem, and your concerns. We’ll do our best to assist.

The LilGadgets warranty covers defects in material and product workmanship under normal use for a period of one (1) year. The warranty does not cover damages resulting from misuse, abuse, immersion, normal wear and tear, or unauthorized modification. Should these headphones require service or replacement while under warranty, please contact us for trouble shooting and/or return authorization. There are no expressed warranties except as listed above. This warranty gives you specific legal rights which may vary from state to state. NOT LEGAL FOR

TRADE.

INSTRUCTION MANUAL

——————————-

6

FEDERAL COMMUNICATIONS COMMISSION

(FCC) STATEMENT

FCC ID: 2AFEC-UNTANGLEDPRO

You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential Installation. This equipment generates, uses, and can radiate radio frequency energy and, if not Installed and used according to the Instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular Installation. This device may not cause harmful Interference and this device must accept any

Interference received, Including Interference that may cause undesired operation.

(FCC) STATEMENT (CONT)

If this equipment does cause harmful Interference to radio or television reception, which is found by turning the equipment off and on, the user is encouraged to try to correct the Interference by one or more of the following measures:

-Reorient or relocate the receiving antenna

-Increase the separation between the equipment or devices

-Connect the equipment to an outlet other than the receivers

-Consult a dealer or an experienced radio/T V technician for assistance

FCC RF RADIATION EXPOSURE STATEMENT

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must be at least 20 cm from the user and must not be co-located or operating in conjunction with any other antenna or transmitter.

——————————-

Contact Information

Phone: 1-866-291-8635 (10-5 EST, M-F)

Email: [email protected] (24/7)

INSTRUCTION MANUAL

——————————-

7