Security Brands 25-C1 Ascent C1 Quick Start Guide

1 of 2
QU ICK START GUIDE
1
Carefully unpack box.
I MP O RTA NT!
r
Open front cover of Ascent C1 for
access to internal components
2
We recommend mounting Ascent C1 inside
the gate operator or other weatherproof
enclosure when possible.
START HERE
If mounting inside a metal enclosure, an
Ascent 10' Cable Extension (p/n 16-X-EXT)
is required. Follow the instructions included
with the cable extension before moving on.
3
Connect wires
Ascent C1 Terminal Block
Loosen cable gland locknut,
feed wires through, and
connect wires as shown.
Gate Operator / Door Opener
12–24 V AC/DC
POWER
12–24 V AC/DC
CLOSE
STOP
OPEN
COM
REVERSE LOOP
COM
FREE EXIT
COM
COM
RADIO
NEG. (–)
POS. (+)
N/O
EVENT
COM
N/C
N/O
COM
RELAY B
N/C
COM
RELAY A
N/O
NEG. (–)
POWER
POS. (+)
N/O
GND
STATUS
Relay B can be wired to a second device in same manner.

OR
Antenna not shown for clarity.
Copyright © Security Brands, Inc.
Supplied 12 VAC Transformer
+ –
Third-Party 12–24 V AC/DC Power Source
C A U TI O N!
If you will not be using the supplied 12 VAC
transformer, please go to page 2 and follow the
procedure, Using a Third-Party Power Source.
Do not exceed 24 V! Failure to choose a
compatible power source can damage unit!
Rev. A (3/2015)
2 of 2
Q UICK START GUIDE
4
Tighten cable gland locknut; then
replace and secure front cover
r
IMPO RTA NT!
After connecting to power and waiting a
few minutes, check that the red LED is lit.
If it is not lit, please contact us at
summitcontrol.com/contact
I M P O R T ANT!
r
Using a
Third-Party
Power Source
(Optional)
If you would like to use a third-party
power source, such as solar, verify that
it conforms to the following specs:
Input
Current Draw
1
Installing
Custom
SIM Card
(Optional)
Copyright © Security Brands, Inc.
12–24 VAC / VDC
must be within ±10%
less than 100 mA @ 12 VDC
less than 75 mA @ 24 VDC
Locate supplied SIM card and press
in to unlock it for removal
3a
3b
2
Connect wires to Ascent C1 as shown
in Step 3
Connect wires to your power source,
making sure you connect positive to
positive and negative to negative
Remove SIM card
N
INSTALLATION COMPLETE!
Now follow the Activation Guide to create
an account and begin using Ascent.

C A U TI O N!
Double check that you’ve wired from
positive on Ascent C1 to positive on your
power source and negative on Ascent C1
to negative on your power source.
Reverse polarity can damage Ascent!
3
Insert new SIM card and press firmly
to lock into place
Rev. A (3/2015)