Newport Brass 1-506 3/4" Valve, quick connect included. Installation instructions
advertisement
INSTALLATION INSTRUCTIONS
ROMAN TUB 2 VALVE AND TRIM
Valve Model No's: 1-506, 1-577
Trim Kit for Model No’s:
876, 886, 896, 906, 956, 966, 1026,
1056, 1066, 1076, 1086, 1096, 1106, 1746, 3-2486, 3-2496
2001 CARNEGIE AVE, SANTA ANA CA 92705
(949) 417-5207
WWW.NEWPORTBRASS.COM
Rough-in Valve Installation
Recommended Installation by a Professional Plumbing Contractor
Note: Use plumbers tape or equivalent to seal all threaded joints.
Warning: To prevent severe damage to valve body, any solder/braze process must be performed a min. of 4" from ports.
1. Install the Spout quick connect Deck Flange through spacer and center hole of mounting surface. Secure with washer nut. See Figure 1.
Note: Spout Nipple is installed in the Deck Flange for safe keeping until the trim is to be installed.
2. Place washer nut on valve body. Insert body, (blue cold & red hot), through hole from below mounting surface. See Fig. 1. Adjust and secure with additional washer nut so that the top of valve stem is at the correct height from mounting surface. See Table 1.
Deck Flange
Spout nipple to be used with trim installation **
Washer Nut
See table 1 for stem length
Finished Deck
1-1/4”
1-1/4”
**
Remove from deck flange for trim installation.
Fig. 1
3/4” NPT
Washer Nut
3. Attach hot/cold valves to spout, utilizing ¾" copper pipe. See Figure 2.
Spacer
3/4” NPT
NWP-1-506
Inlet for hot water supply
Fig. 2
Inlet for cold water supply
TABLE 1
Trim Installation
Note: To achieve desired handle rotational alignment, the cartridge
MUST be tightened in a clockwise rotation only. The use of petroleum base plumbers putty on our products will nullify the warranty. We recommend the use of clear silicone sealing materials. (Cartridge factory torque is set @ 14-16 ft-lbs.)
4. Attach handle trim to valve. When possible, any adjustments for rotational alignment should be made to the valve body - not to the cartridge. (Note: Allow minimum spacing between handles and escutcheon/bonnet to prevent damage to the surface finish.) Secure handles into place with setscrew. See Figure 3.
5. Apply plumbers tape to spout nipple and install into base of spout. Slide spout nipple into quick connect deck flange (re-grease if necessary). Make sure spout is flush with deck and secure into place with setscrew. See
Figure 3.
6. Turn on water supply, check for leaks and make any final adjustments required.
Spout
Setscrews
Handle
Spout nipple w/ o-rings
Decorative ring**
Quick connect
Deck flange & spacer
Bonnet **
Shroud **
Escutcheon **
Valve
Fig. 3
** Optional item based on model selection
(949)417-5207
Santa Ana, Ca. 92705 11/23/2015 www.brasstech.com
NWP-1-506
advertisement
Related manuals
advertisement