BOCA FLASHER CCS100 LED Light Strip Installation Manual

BOCA FLASHER CCS100 LED Light Strip Installation Manual

Below you will find brief information for LED Light Strip CCS100. The CCS100 is designed for low power applications where energy consumption and size are the main concerns. It can be specified with either one row or two rows, depending on the light output required. It offers seamless LED configuration, easy installation, and vibrant monochromatic color. The CCS100 can be used with any magnetic low voltage dimmer and is available in different housings for different uses, including underwater installations where IP68 is required.

advertisement

Assistant Bot

Need help? Our chatbot has already read the manual and is ready to assist you. Feel free to ask any questions about the device, but providing details will make the conversation more productive.

LED Light Strip CCS100 Installation Manual | Manualzz

CCS100

Installation Manual

WARNING: DO NOT ATTEMPT TO INSTALL OR USE THE CCS100 FIXTURE WITHOUT READING THE

INSTALLATION INSTRUCTIONS AND SAFETY LABELS COMPLETELY.

Failure to adhere to these instructions could result in serious injury or property damage.

DO NOT MODIFY, ALTER OR ATTEMPT TO SERVICE THE CCS100. DOING SO WILL VOID THE WARRANTY.

CCS100

INSTALLATION INSTRUCTIONS

CCS100

DMX Controlled Dimmable LED Light Strips

INTRODUCTION:

The Boca CCS100 is designed for low power applications where energy consumption and size are the main concerns. It can be specified with either one row or two rows, depending on the light output required. It offers seamless LED configuration, easy installation, and vibrant monochromatic color. The CCS100 can be used with any magnetic low voltage dimmer and is available in different housings for different uses, including underwater installations where IP68 is required.

Fixtures must be installed by a qualified and licensed electrician in accordance with all national, state and local electrical codes and regulations. If any part of this manual does not meet the necessary codes and regulations, contact the factory for more information before attempting to install.

MAINTENANCE:

Cleaning:

− Dry and Damp (IP65) Rated Fixtures:

To clean surface use a soft damp cloth.

− Wet (IP68) Rated Fixtures:

To clean surface use a soft cloth with mild soap and water.

Storage: Store in a dry, well-ventilated area when product is not in use. Keep the electrical cord away from heated surfaces when in use or not in use. If cord shows signs of damage do not use, return product to manufacturer.

ELECTRICAL SPECIFICATIONS:

1. Input Voltage: 24 VDC or 24 VAC

(See layout drawings for spec.)

2. Total linear ft per distribution box: 80ft (10ft per port)

3. Total linear ft per 100watt transformer: 22ft

4. Total linear ft per 300watt transformer: 66ft

5. Input Current: 150mA RMS per linear ft

IP65

DAMP LISTING

IP68

WET LISTING

Max temp: 55 °C

Min. temp: -40 °C

Turn Power Off At Circuit Breaker Before Beginning Installation!

INCLUDED IN THIS PACKAGE

1

CCS100 Fixtures

(In lengths shown on job specific drawings)

2 Mounting Brackets

(2 brackets per fixture)

3 Remote Transformers

(if ordered)

Underwater Tube

OR

Tube

For Underwater Tube

OR

For Tube

6 Job Specific Drawings

4 I.M.C.S.

Distribution Box (if ordered)

CCS100

Page 2 of 5

CCS100

INSTALLATION INSTRUCTIONS

1a

1. Install Clips into Substrate

1b

OR

OR

Screw Information:

1. Screws not provided by Boca Flasher.

2. For Tube Boca Flasher recommends wide washer

flat head Philips #8 screw (not to exceed .418

".

For Underwater Tube Boca Flasher recommends

#8 screw (not to exceed .330

").

3. Length of screw will vary depending on

mounting surface.

4. For outdoor installations, installer should use

a screw with weatherproof coating.

2. Install Fixture into Clips

2a.

Push Fixture down with slightly firm pressure 2b.

Clip will securely snap into place.

OR

OR

▶ snap!

3. Connect Fixtures Together

(as Shown on Job Specific Drawings)- for Tube Only

3a.

Connect Male and Female connectors in order shown on job specific drawings.

3b.

3c.

Push together until you hear a “Click”.

Coupler click!

*Note: Underwater Tube ships connected.

Page 3 of 5

4. Connect Fixtures to Power

CCS100

INSTALLATION INSTRUCTIONS

* Note: If contractor wishes to hard wire fixture,

cable can be stripped of Edison plug and hardwired

using a junction box. Molded cable must be

encased in conduit.

Page 4 of 5

Boca Flasher, Inc.

552 NW 77th Street ■ Boca Raton, Florida ■ 33487 USA

Phone: 561.989.5338 ■ Fax: 561.982.8323

www.bocaflasher.com

Important Safety Reminders

CCS100

INSTALLATION INSTRUCTIONS

1. DANGER: To reduce the risk of electric shock, always unplug the CCS100 from electrical outlet before cleaning. Cut breaker if outlet is not available.

2. TO REDUCE THE RISK of burns, fire, electric shock, or injury to persons

• Use the CCS100 only for its intended use as described in these instructions.

• Do not use attachments not recommended by Boca Flasher.

• Never operate the CCS100 if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. If the seal appears to be damaged/broken/torn return the CCS100 to a service center for examination or repair.

• Keep cord away from heated surfaces.

• Never drop or insert any object into any opening.

• Do not operate where aerosol (spray) products are being used or where oxygen is being administered

3. WARNING: Do not attempt to install or use the CCS100 without reading the installation instructions and safety labels. Failure to adhere to these instructions could result in serious injury or property damage.

4. DO NOT MODIFY , alter, or attempt to service the CCS100. Doing so will void the warranty.

5. DO NOT USE SHARP TOOLS near or on the fixture lens.

Doing so will result in property damage and will void the warranty.

IP65

DAMP LISTING

IP68

WET LISTING

Boca Flasher, Inc.

552 NW 77th Street ■ Boca Raton, Florida ■ 33487 USA

Phone: 561.989.5338 ■ Fax: 561.982.8323

www.bocaflasher.com

We are constantly improving our fixtures and reserve the right to change options and specifications. Additional information & details at www.bocaflasher.com. For specific requirements, contact your Boca Flasher sales representative. Boca Flasher, Inc. 552 NW 77th Street Boca Raton, Florida 33487 USA Phone: 561.989.5338 Fax: 561.982.8323 © 2015 Boca Flasher,

Inc. All rights reserved. All names and trademarks are property of their respective owners. REV031815_lr

advertisement

Key Features

  • Low power consumption
  • Seamless LED configuration
  • Easy installation
  • Vibrant monochromatic color
  • Available in different housings
  • IP68 rated for underwater installations

Frequently Answers and Questions

What is the input voltage of the CCS100?
The CCS100 can be powered by 24 VDC or 24 VAC, according to the specifications on the layout drawings.
What is the maximum linear footage per distribution box?
The maximum linear footage per distribution box is 80ft, with 10ft per port.
What is the maximum linear footage per transformer?
The maximum linear footage per 100 watt transformer is 22ft, and 66ft per 300 watt transformer.
What are the temperature ratings for the CCS100 fixtures?
The temperature ratings are 55°C maximum and -40°C minimum.

Related manuals

Download PDF

advertisement