CAUTION!

Read this first.

Important safety instructions.

OneSpace

Instructions

Prefab

Philips OneSpace luminous ceiling prefab

Hoisting brackets

Safety instructions

Warning:

• OneSpace luminous ceiling panels must be installed by qualified technicians in accordance with all national and local laws, including building codes and safety regulations.

• Nobody is to be underneath a OneSpace luminous ceiling panel when the panel is being lowered or lifted.

• Nobody is to be underneath a OneSpace luminous ceiling panel when the panel is not horizontal.

• Only use the supplied hoisting brackets to hoist a OneSpace luminous ceiling panel.

Installation instruction hoisting brackets

Philips OneSpace luminous ceiling prefab

1. The hoisting kit contains the following parts:

• 4 circular hoisting brackets.

• 8 bolts and 8 washers to mount the brackets.

Not in the picture:

• Instructions.

2. Determine the position of the hoisting brackets (2). The hoisting brackets are positioned at 30 cm on the in- or outside of the mounting brackets (1), depending on the place of the hoisting system used (not supplied by Philips). Move the nuts (3) to this position.

The nuts are already placed in the mounting rail of the panel.

3. If needed, mounting and hoisting brackets can be moved to fine-tune the position.

4. Use an Allen key M5 to mount the brackets to the panel.

5. Repeat the mounting of the hoisting brackets at all four corners.

6. Connect the hoisting system to the hoisting brackets at all four corners and lift the panel to the ceiling.

7. After the panel has been safely mounted using the mounting brackets, remove the hoisting brackets and bolts and retain for later use.

For more information please contact: [email protected]

© 2015 Koninklijke Philips N.V. All rights reserved.

Specifications are subject to change without notice.

Trademarks are the property of Koninklijke Philips N.V.

(Royal Philips) or their respective owners.

Version: 08/2015 - 8122-508-15312 www.largeluminoussurfaces.com/onespace