Videofied OSX Outdoor Siren Product Install Sheet

OSX Outdoor Siren
P R O D U C T
I N S T A L L
S H E E T
Doc. - Ref. 216-OSX
Version : August 2014
Product Presentation
The OSX Outdoor Siren is designed for use with a
Videofied ® wireless alarm system.
Its main features are :
• Completely wireless and powered with
alcaline batteries : 4 years battery life.
• Dual tamper function provides detection for
both wall and cover tamper.
• Tr a n s m i t s c h e c k - i n /s t a t u s s i g n a l s e v e r y
8 minutes
• Flash LED light
• 100 dBA output level at 1 m
• 3 to 15 minutes output and flashlights
duration (according to local legislation).
Installation guidelines
For easier installation, programming and RF testing should
be done to check for good communication between the
control panel and all system devices before mounting system
devices. Install the siren and other system devices in the order
of the following steps :
>Mounting - mount siren at the tested location.
>Programming/RF Testing - program the siren and all other
devices into the control panel and test RF communication
from each intended device location to the control panel.
Mounting
> Use proper tools and hardware for mounting the unit.
> We recommend to not expose the siren to direct rainfall.
> The strobe light must be clearly visible to responding
authorities. Mount the outdoor siren accordingly.
1 Press both side buttons together to open the siren box.
2 Hold up the siren base against the mounting surface and
mark the four mounting holes.
3 Drill pilot holes and install anchors where needed.
4 Place unit on mouning surface so mounting holes line up
with pilot holes/anchors and secure unit with appropriate
screws.
Mounting holes
5 Install 3 LR 1.5V batteries, observing correct polarity.
6 Attach front cover and lock with the screws.
www.videofied.com
OSX Outdoor Siren
P R O D U C T
I N S T A L L
S H E E T
Programming/RF Testing
The following provides summarized steps for device
programming and testing. For complete details, refer to the
control panel installation manual.
1 With the programming keypad, browse to the ADD A NEW
DEVICE menu (Level 4).
2 Press OK/YES. The keypad displays PRESS PROGRAM
BUTTON OF DEVICE.
3 Press and release program button on siren using a paper
clip end.
The siren LED flashes.Wait for keypad display to show SIREN
(1 - 25) RECORDED.
4
Press OK/YES. The display shows RADIO RANGE TEST?
Press OK/YES again to run the test. The keypad display shows
TEST IN PROGRESS.
5
Make sure the siren is flashing indicating good
communication with the control panel. The test result must
stabilize at 8/9 minimum.
6
Press OK/YES to end the radio range test then ESC NO.
7
When finished, exit from configuration mode by a long
press on ESC NO.
Opening
Button
www.videofied.com
INIT
Button
Locking
Screw
2
OSX Outdoor Siren
P R O D U C T
I N S T A L L
S H E E T
Use only the flashlights or only the output
Enable delay beeps
By default, the output and the flashlights are enabled
when the OSX is active. You can enable one or the other.
By default, delay beeps are disabled on the OSX outdoor
siren. You can enable those delay beeps.
The triggering of the flashlights only is not
compliant with EN50131-4 or NF&A2P.
Lvl. 4
Lvl. 4
CONFIGURATION
CONFIGURATION
OK or YES
OK or YES
AREAS AND DEVICES
AREAS AND DEVICES
OK or YES
OK or YES
DEVICES
DEVICES
OK or YES
ADD A DEVICE
OUT SIREN DELAY
DISABLED/ENABLED
DEVICE
CONFIGURATION
OK or YES
Device list
To select the siren
OK or YES
ALARM
FLASH + SIREN
Press OK or YES and use the arrows to
select FLASH + SIREN, FLASH ONLY or
Those functions are only available for panel
firmware versions 04.03.XX.XXX and later.
In order to check the firmware version, enter
the following code in the standby menu when
the panel is DISARMED : 000000+YES.
SIREN ONLY.
www.videofied.com
3
OSX Outdoor Siren
P R O D U C T
I N S T A L L
S H E E T
Security notes / (FR) Notes de sécurité / (DE) Hinweise zur Sicherheit
English
•
•
•
•
Remove battery before any maintenance !
WARNING, there is a risk of explosion if a
battery is replaced by an incorrect type!
Observe polarity when setting up the
batteries!
Do not throw used batteries! Bring them
to your installer or a collection point.
Français
•
•
•
•
Retirez les piles avant toute opération de
maintenance !
Attention ! Il y a un risque d'explosion si
l'une des piles utilisées est remplacée par
une pile de type incorrect !
Respectez la polarité lors de la mise en
place des piles !
Ne jetez pas les piles usagées !
Ramenez-les à votre installateur ou à un
point de collecte spécialisé.
Deutsch
•
•
•
•
Batterien vor jeglichen Wartungsarbeiten
entfernen!
Vorsicht, es besteht Explosionsgefahr,
wenn eine Batterie durch eine Batterie
falschen Typs ersetzt wird!
Achten Sie beim Einsetzen der Batterien
auf die Polung!
Entsorgen Sie Batterien nicht im
normalen Haushaltsmüll! Bringen Sie
Ihre verbrauchten Batterien zu den
öffentlichen Sammelstellen.
FCC Regulatory Information for USA and CANADA
FCC Part 15.21 Changes or modifications made to this equipment not expressly approved by RSI Video Technologies may void the FCC
authorization to operate this equipment.
FCC Part 15.105 Class B
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
>
Reorient or relocate the receiving antenna.
>
Increase the separation between the equipment and receiver.
>
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
>
Consult the dealer or an experienced radio/TV technician for help.
Radio frequency radiation exposure information according 2.1091 / 2.1093 / OET bulletin 65
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed
and operated with minimum distance of 20 cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
1
This device may not cause harmful interference, and
2
This device must accept any interference received, including interference that may cause undesired operation.
Cet appareil est conforme à la Partie 15 des règlementations de la FCC et avec la norme RSS-210 de l’Industrie Canadienne.
Son fonctionnement est soumis aux deux conditions suivantes :
1
Cet appareil ne doit pas causer d’interférences nuisibles et
2
Cet appareil doit accepter toute interférence reçue, y compris les interférences pouvant entraîner un fonctionnement indésirable.
www.videofied.com
4
OSX Outdoor Siren
P R O D U C T
Electrical Data
S H E E T
Installation/Mounting
Panel Compatibility
Power requirements W, XL,XT, XV, VISIO 4.5V DC
Cover
Two side screws for cover locking
Siren/Wall
Four screws secure siren base to mounting surface
with 3 LR20, 1.5V, D size Alkaline batteries
Battery life
4 years
Low battery limit
3.75 V
Current consumption
Standby
141uA (OSX200 & OSX210)
200uA (OSX601 & OSX712)
Standards & Certifications
868MHz (OSX200 & OSX210)
Standards :
NF EN50131-4 :
2009 Grade 2 - Type W
RTC 50131-4 :
2011
RT48-266 :
2012
NF EN50130-4 : 2011
NF EN50130-5 :
2011 Classe IV
Alarm2A
RF Technology Radio type
S2View®
Spread spectrum bidirectionnal
Operating frequency
868MHz - OSX200 & OSX210 (Europe, South Africa, Asia)
915MHz - FHSS - OSX601 (USA, Canada, South America)
920MHz - FHSS - OSX712 (Australia, South America)
Transmission security Supervision
NF&A2P (OSX200 & OSX210)
NF&A2P – 2 boucliers – suivant le référentiel
NF324-H58
Matériels de sécurité électroniques, détection
d’intrusion
AES encryption algorithm
Polled signal every 8 minutes
Dispositif d’alarme sonore et lumineux à éclats
Marque commerciale : VIDEOFIED
Certificat N° : 3223200007
AntennaIntegrated
Tamper detection
Wall and cover tampered
Sound Frequency
1408 Hz to 1587 Hz
Output level
100 dBA at 1m
Output and flashlights duration
3 min by default (15 min max according to local legislation)
Flashlight type
LED
Flashlight color
Orange - OSX200 & OSX601
Blue - OSX210 & OSX712
Flashlight frequency
1 flash per second
Operating temperature
Maximum relative humidity
Organisme certificateur :
CNPP Cert.
Route de La Chapelle Réanville CS22265
F—27950 SAINT MARCEL
Tel : +33(0)2.32.53.63.63
Fax: +33(0)2.32.53.64.46
Sites Internet : http://www.cnpp.com
E-mail : [email protected]
Organisme certificateur :
AFNOR Certification
11, rue François de Pressensé
93571 Saint Denis La Plaine Cedex
Tel : +33(0)1.41.62.80.00
Fax: +33(0)1.49.17.90.00
Sites Internet : http://www.afnor.org
et http://www.marque-nf.com
E-mail : [email protected]
915MHz (OSX601)
-25°/+70°C (-13°/158°F)
USA FCC Part 15C (FCC47 CFR part15)
75%, non-condensing
Canada IC (RSS-210 Issue 8)
920MHz (OSX712)
Physical Data
Material
Dimensions
Weight
ABS - ULV0
349 mm x 232 mm x 54mm
1200g (without batteries)
1400g (with batteries)
Protection Marking
IP44/IK07
EMEA SALES
North American Headquarters
23, avenue du Général Leclerc
92340 BOURG-LA-REINE
FRANCE
E-Mail : [email protected]
1375 Willow Lake Blvd, Suite 103
Vadnais Heights, MN 55110
USA
E-Mail : [email protected]
www.videofied.com
Australie C-Tick (AS-NZS4268)
© 2013 RSI Video Technologies Videofied® and MotionViewer® are Registered Trademark of RSI Video Technologies.
Specifications subject to change without notice.
I N S T A L L
5