Installation manual controller

Installation manual controller
EXCELLUM2
CONTROLLER
ENGLISH
General instructions
Excellum2 Controller unit must only be installed and put into operation by a qualified electrician.
The applicable safety regulations and accident prevention regulations must be observed.
Safety instructions
•
•
•
•
Use B 10 A or B 16 A type unit as circuit breaker. The DALI interface is insulated by a basic
insulation.
Use wires that can handle power line voltages for the entire DALI wiring.
Include DALI wiring, with a 5-core cable (e.g. NYM 5 x 1.5 mm²) if necessary, together with the
mains voltage (L, N).
Do not connect the DALI wiring with external voltage, especially not with 230 V mains voltage.
Potential overvoltage is only checked once when the controller switched on.
CAUTION!
• Incorrect mounting can lead to destruction of
the controller unit and other devices.
• The control unit should only be mounted in
switch cabinets (DIN 43880).
• The DALI standard as per IEC 62386 must be
complied with.
• Danger of electric shock.
Wiring
11-12: Mains voltage
13-14: Current Transformer (optional)
15-18: Auxiliary input
21-22: DA+/DA- line 4
23-24: DA+/DA- line 3
25-26: DA+/DA- line 2
27-28: DA+/DA- line 1
KNX: KNX Connection
A: Ethernet Slave
B: Ethernet Master
KNX
conn
A
B
(continues on next page)
Service information
Status LED
blinks green
blinks orange
blinks green/orange
press 5 sec
Button
when everything is ok, meaning controller
runs with good configuration, no electrical
connections errors under power up
when a problem was detected on power up
or configuration has problems
when its doing a firmware upgrade
will switch lights off (even unaddressed DALI
devices) a second long press switch lights on
Technical data
Operation voltage
Max. Power consumption with full DALI load
Working temperature
Leads diameter
100-240 V AC/ 50-60 Hz
23 W
0 °C … +40 °C
0.5 ... 2.5 mm² (fixed)
0.5 ... 1.5 mm² (flexible)
5-7 mm
DALI power supply
Max. number of DALI devices
(addressed)
Dimensions (L x W x H)
4 x 200 mA (basically insulated)
4 x 64
160 x 91 x 58 mm (9 HP)
Applicable standards
Safety
EMC emission
EMC resistance
DALI standard
EN 60950
EN 55022
IEC/EN 61000
IEC 62386
ETAP NV – Progress Business Centre – 7 Whittle Park Way – Slough – Berkshire – SL1 6DQ – UK
Tel. +44 (0)1628559650 – Fax +44(0)1628559012 – [email protected]
www.etaplighting.com
252077
C4E1060 – 07/2015
Conformity with applicable EU directives is confirmed by the
CE symbol. Specifications subject to change without notice
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement