advertisement
◉
Touch to zoom
No 10. : SprayPartner Spray Boom Installation Instructions Loosen hose clamp on hose at pump and remove hose. Remove Elbow fitting from top of pump and attach new Nipple fitt- ing (49) that you received with the Spray Boom attachment. Attach Tee fitting (#18) to Nipple fitting (#9) as shown. Re-attach Elbow fitting on the right side of the Tee fitting (as ~ shown.) You can re-assemble the hose that goes to the spray wand to this Elbow fitting. Connect another Nipple (#9) fit ting to to the left side of the Tee fitting. Connect Valve (#8) to Nipple fitting. Connect Elbow fitting (#10) to Valve fitting (#8.) Slide hose clamp (#17) over Hose (#4). Then push hose onto Elbow (#10) and tighten clamp (#4.) Attach sprayer arm and support bracket assembly to rear of sprayer tank using Bolts (#15) and Lockwashers (#16) as shown. Make sure the sprayer arms are on the top. Slide hose clamp (#17) over the open end of the hose you assembled in step 8. Slide hose clamp (#4) on the open end of the hose and push the open end of the hose onto the hose tee (#7) and tighten clamp (#4). pecifications, descriptions, and illustrative material in this literature are as accurate as known at the time of publication, but are subject to change without notice © Mantis 2000 M9764 used to hold hose to arm This assembly repeats on the other side of plastic “Tee” (# 7.) Parts List | Key Part No. Description Key Part No. Description 1. M9578 Boom Bracket 12 113 5/16-18 x 1 1/2 Bolt 2 M9579 Boom Arm - Right (not shown) 13 114C 5/16-18 Nut 3 M9580 Boom Arm - Left 14: 328 1/4 Flat Washer 4 M9581 3/8 x 7 Hose 16 M9591 1/4 - 20 x 1/2 PHMS 5 M9582 Wire Tie 16 396 1/4 Lockwasher 6 M9583 3/8 Elbow 17 M9463 #5 Hose Clamp 7 M9584 3/8 Hose Tee 18 M9594 1/2 Tee MPT 8 M9585 1/4 Valve 90 19 M9595 Nut B-12 9 M9586 1/4 Nipple M1400 20 M9596 Cap 8027 10 M9462 1/4 MPT x 3/8 HB Elbow 21 M9597 Spring 11 M9587 Nozzle Tip tk 1.5 Operating Instructions To operate the spray boom... turn the valve (#8) handle so it lines up with the valve body as shown above. Then pull out the switch button on the pump to activate . To operate the Spray Wand... turn the valve (#8) so the valve handle is perpendicular to the valve. Then pull out the switch button on the pump and squeeze the handle on the Spray Wand to activate. SprayPartner Mantis 1028 Street Road Southampton, PA. 18966 1-800-366-6268
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project